···
Log in / Register

Where is the cabin air filter located in the Changan Yuexiang?

3 Answers
Jocelyn
07/29/25 12:35pm
The cabin air filter in the Changan Yuexiang is located inside the glove compartment on the passenger side. Specifically, it is situated beneath the passenger seat storage box. When lying beneath the storage box and looking to the right, you will see a rectangular black opening, which is where the cabin air filter is positioned. The cabin air filter is installed in the vehicle's air conditioning system and is designed to capture dust particles, not only protecting allergy sufferers from irritants but also safeguarding the cooling system of the car's air conditioning. Without the protection of the cabin air filter, unpleasant odors can develop inside the vehicle, significantly affecting the driver's mood and driving safety. Below are the steps for removing and cleaning the cabin air filter in the Changan Yuexiang: 1. Open the glove compartment and unhook the small latch on the right side. 2. Open the cabin air filter cover of the Changan Yuexiang to locate the filter. 3. Remove the old cabin air filter and replace it with a new one. The cabin air filter should not be cleaned with water, as this can easily damage it. Instead, use a high-pressure air gun to blow away the dust.
Was this review help?
8
0
Share
LondonLynn
08/14/25 12:16am
As a long-time owner of a Changan Alsvin, I usually maintain my car myself and found that the cabin air filter is located behind the glove compartment in front of the passenger seat. You need to first open the glove box, empty its contents, then either pull it upward firmly or press the clips on both sides to remove it. Looking inside, you'll see a square box which is the filter housing—just pull it out directly to replace the filter. I remember it only takes a few minutes to change, no tools required, and buying the filter online costs just tens of yuan, much cheaper than going to a 4S shop. The key is that regular replacement keeps the cabin air fresh, especially for families with children—less dust means fewer allergies. I typically replace it every six months, ideally during seasonal transitions. The location is quite user-friendly, making it easy even for beginners. The more you DIY, the more attached you become to your car.
Was this review help?
10
0
Share
Expand All
MaddoxRose
10/09/25 4:41am
From my experience with car maintenance, the location of the Changan Alsvin's cabin air filter is quite straightforward, primarily situated deep inside the glove compartment on the passenger side. After opening the glove box, you can directly see the filter slot fixed at the air duct entrance—simply slide out the old filter to remove it. This area tends to accumulate dust easily, making regular checks crucial, especially when driving in dusty urban areas. I recommend replacing it every six months or adjusting based on air quality. Changing the filter boosts AC efficiency, reduces odors, and prevents bacterial growth. The actual process is simple, with online video tutorials making it easy to understand, and replacement parts cost just a few dozen yuan. Developing this habit can significantly lower your vehicle's maintenance costs.
Was this review help?
2
5
Share
Expand All
More Forum Discussions

How to Deal with Intake Camshaft Position Fluctuation in Roewe 350?

Install a dial indicator in the thrust direction at the front end of the camshaft to measure whether the axial end clearance indicated by the dial when the camshaft moves forward and backward (axially) is normal. The limit value for camshaft end clearance is 0.1~0.2mm. If it exceeds this value, you can reduce the thickness of the spacer ring or replace the thrust collar. For fluctuations caused by a faulty camshaft position sensor, simply replace it with a new one. Check if the timing chain is loose, as a loose chain can cause gear misalignment, leading to camshaft fluctuation.
12
4
Share

How to Turn on the High Beam on a CRV?

Carry the key close to the car (within two meters) to unlock the door. After entering the driver's seat, gently press the one-touch start button to power on the vehicle and initiate self-check. On the lower left side of the steering wheel, there is a turn signal lever. The outer part is the headlight and position light switch. Turn the knob to the bottom position to turn on the headlights. The headlights turned on at this time are low beams. In this state, push the lever downward to activate the high beams. After turning on the low beams, pull the light control lever backward to momentarily activate the high beams, also known as flashing the high beams or alternating between high and low beams.
18
0
Share

How to Remove the Door Panel of an Old Jetta?

First, prepare the tools: one flat-head screwdriver, one Phillips-head screwdriver, and one T30 wrench. Unscrew the door handle counterclockwise, remove the inner door handle, pry open the plastic cover from below using the flat-head screwdriver, then loosen the two screws inside with the T30 wrench. Remove the three Phillips-head screws on the door edge; forcefully push open the locking clip of the handle frame (push outward toward the door), then push along the arrow direction to complete the removal. Forcefully remove the rearview mirror adjustment knob, unplug the control button wiring harness connector inside the Jetta door panel. Lift the door panel off the bracket. Forcefully pull open the clips to remove the door panel.
16
0
Share

What is the solution for oil burning in a 2015 Peugeot 408?

For a 2015 Peugeot 408 experiencing oil burning, you can increase the sealing between the engine pistons and cylinder walls by switching to a higher viscosity oil or regularly inspecting and replacing relevant oil system components. Symptoms of oil burning: Blue smoke during cold starts indicates minor oil burning. If you observe large amounts of blue smoke from the exhaust pipe, this signals significant engine oil burning. A very black exhaust pipe interior wall is another indicator. Preventive measures for oil burning: Use high-quality engine oil. Oil tends to corrode and degrade under prolonged high temperatures, thinning the oil film and making it easier to enter the combustion chamber. Using premium quality oil can significantly delay this phenomenon.
15
4
Share

How to route wires from outside to inside the car for Magotan B7?

Open the hood of the Magotan B7, locate the firewall on the partition between the hood and the driver's seat, and make a hole in the rubber plug, which serves as the passage for the wire harness. Open the glove box, find the fuse box of the Magotan B7 inside, where there will be spare fuse positions. Connect the external wire harness's fuse circuit to the spare fuse. After connecting the wires, organize the wire harness properly, cover it with protective caps, ensure waterproofing, and secure the wire harness in the appropriate position on the car using fastening clips. After debugging and confirming normal operation, seal the rubber plug wire harness hole with silicone sealant, remove any excess sealant, and finish with aesthetic treatment.
17
4
Share

What to Do If the Geely Vision Car Key Is Lost?

When taking delivery of the car, the 4S dealership will provide the owner with two keys, one of which is a spare key. If a key is lost, the first step is to locate and use the spare key. Call a professional locksmith company and request them to send a technician to assist with unlocking the car. You will need to provide identification documents such as an ID card and driver's license. Most 4S dealerships now offer emergency rescue services. Contacting the dealership will help get the car door opened and arrange for a new key to be made. The Geely Vision car key consists of a remote control and a mechanical key. Identical models are available for purchase online. After purchasing, the owner can follow the instructions to self-match the key.
17
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.