Where is the Cabin Air Filter Located in the Changan CS95?

1 Answers
VanTyler
07/30/25 2:55am
The cabin air filter in the Changan CS95 is located behind the glove compartment on the passenger side. The cabin air filter is a component installed in the vehicle's air conditioning system, designed to absorb dust particles, alleviate respiratory discomfort, reduce irritation for allergy sufferers, and protect the air conditioning cooling system. The Changan CS95 is a midsize 5-door, 7-seat SUV with the following body dimensions: length 4949 mm, width 1930 mm, height 1790 mm, and a wheelbase of 2810 mm. It is equipped with a 2.0T turbocharged engine and a 6-speed automatic transmission, delivering a maximum power of 171 kW and a maximum torque of 360 Nm. The vehicle features front-wheel drive, with a MacPherson strut independent front suspension and a multi-link independent rear suspension.
Was this review help?
6
5
Share
More Forum Discussions

What are the reasons for weak car starting?

The reasons for weak car starting are: 1. Excessive wear of cylinder liners, pistons, and rings due to prolonged use, leading to insufficient cylinder pressure, reduced efficiency, and weak engine performance, usually accompanied by blue smoke from burning engine oil; 2. Incorrect valve timing, resulting in abnormal operation; 3. Issues with the fuel system or electrical circuit; 4. Excessive carbon buildup in the intake manifold; 5. Carbon deposits or incorrect gap in spark plugs. Transmission clutch failure can cause weak car starting. The function of the clutch is to transmit and cut off the engine's power. Manual transmissions, dual-clutch transmissions, etc., use friction plate clutches. Over time, the friction plates wear severely, leading to slipping and subsequently causing weak car starting. Additionally, dirty or insufficient transmission fluid can also result in weak car starting.
11
4
Share

What are the reasons for a car making a squeaking noise when starting but not firing up?

Car making a squeaking noise when starting but not firing up is due to: 1. The car is out of fuel. If the fuel gauge shows below the red line, it indicates no fuel and the owner needs to refuel the car, naturally it won't start; 2. Incorrect gear position. For automatic transmission cars, the gear must be in P or N position when starting. If it's in R or D position, the car won't start. For manual transmission cars, not pressing the clutch will also prevent starting; 3. Dead battery, caused by leaving headlights on for a long time or the battery reaching the end of its lifespan; 4. Installing xenon headlights, high-power audio systems, DVD players, etc., can also cause vehicle circuit failures; 5. Faulty spark plugs or ignition coils.
10
3
Share

What are the symptoms of a faulty coupler?

Symptoms of a faulty coupler include: the car may experience weak acceleration, rough gear shifting, and in severe cases, the car may fail to start. In microwave systems, it is often necessary to divide a microwave power into several paths proportionally, which is a power distribution issue. The component that achieves this function is called a power distribution component, or coupler, mainly including: directional couplers, power dividers, and various microwave branch components. An optoelectronic coupler is an electrical-optical-electrical conversion device that transmits electrical signals using light as the medium, consisting of a light source and a light receiver. The light source and the light receiver are assembled in the same sealed housing, separated by a transparent insulator. The pins of the light source serve as the input, while the pins of the light receiver serve as the output. Common light sources include light-emitting diodes, and light receivers include photodiodes and phototransistors.
6
2
Share

What are the causes of emission system failure?

The causes of emission system failure are: 1. Excessive spark plug gap; 2. The resistance value of the cylinder wire does not meet the requirements; 3. Failure of the oxygen sensor or carbon canister solenoid valve; 4. Excessive carbon deposits in the throttle or engine interior. The hazards of emission system failure are: 1. Excessive carbon deposits; 2. Affects the safety during vehicle operation and reduces the service life of the engine; 3. Causes sintering or detachment of the three-way catalytic converter carrier; 4. Excessive emission of harmful substances. The emission system is: The automobile exhaust system refers to the system that collects and discharges exhaust gases, generally consisting of the exhaust manifold, exhaust pipe, catalytic converter, exhaust temperature sensor, automobile muffler, and exhaust tailpipe.
2
5
Share

Which generation is the Toyota Camry produced in 2016?

The Toyota Camry produced in 2016 belongs to the seventh generation. The dimensions of the Camry are 4850mm in length, 1825mm in width, and 1489mm in height. In terms of suspension, the Camry features a MacPherson strut independent front suspension and a double-wishbone independent rear suspension. Regarding powertrain options, the Camry offers three different systems: a 2.5L hybrid, a 2.0L naturally aspirated engine, and a 2.5L naturally aspirated engine. The 2.5L hybrid system delivers a maximum horsepower of 160 hp, the 2.0L naturally aspirated engine produces 167 hp, and the 2.5L naturally aspirated engine generates 184 hp. For transmission, the 2.5L hybrid model is equipped with an E-CVT continuously variable transmission, while all other models come with a 6-speed automatic transmission with manual shift mode.
8
4
Share

What Do White and Yellow Solid Lines Mean?

Yellow solid lines serve to separate lanes of traffic moving in opposite directions. Think of them as a wall or fence dividing the road into two directions. White solid lines, on the other hand, are used to separate lanes moving in the same direction. Below are some relevant details: 1. Penalties: Crossing a white solid line constitutes a lane violation and typically results in a fine. Crossing a yellow solid line is considered driving against traffic, which carries a penalty of 3 demerit points and a fine. 2. Parking: When a yellow solid line is present along the roadside, it indicates that parking is prohibited, whether for extended periods or temporarily. If the roadside has a white solid line, temporary parking is generally allowed unless there is a no-parking sign. If both yellow and white solid lines are present along the roadside, parking is still prohibited, and violators will face demerit points and fines if caught.
10
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.