Where is the cabin air filter located in an Audi Q5?
3 Answers
The Audi Q5 has two cabin air filters: one is located under the car's engine hood, near the front windshield; the other is beneath the glove compartment in the center console inside the vehicle. There are two types of cabin air filters: one without activated carbon and another with activated carbon. The activated carbon cabin air filter can not only absorb dust particles but also effectively eliminate odors. The Audi Q5 offers two powertrain options, equipped with a 2.0T low-power engine and a 2.0T high-power engine respectively. The 2.0T low-power engine delivers a maximum power of 140 kW and a maximum torque of 320 Nm, while the 2.0T high-power engine produces a maximum power of 185 kW and a maximum torque of 370 Nm. In terms of the transmission system, both engines are paired with a 7-speed dual-clutch transmission.
I've been driving an Audi Q5 for several years, and the cabin air filter is located behind the glove compartment in front of the passenger seat. When you open the glove box, there's a small cover or clip inside. Remove it, and you'll see the filter housing tucked inside. The operation is quite convenient—just use a screwdriver to pry open a few screws, and it takes about ten minutes to complete. I usually change it myself to save money and time. It's recommended to replace it every 10,000 kilometers, which significantly improves cabin air quality and reduces pollen allergy issues. Audi's design is very thoughtful—the location isn't too hidden, unlike older models where you had to dismantle the entire dashboard. Also, when choosing a filter, pick a good brand like Mann-Filter, as long as the size matches. Remember to turn off the engine when replacing it to avoid injury from the A/C system. Regular maintenance ensures smoother A/C operation and much better cooling performance.
In our auto repair community, the fixed position of the Audi Q5's cabin air filter is located inside the glove compartment on the passenger side beneath the dashboard. First, you need to empty the contents of the glove box, then locate the sliding door or clips at the bottom. Gently push or twist to reveal the filter slot. When replacing, ensure the arrow mark points in the direction of airflow to avoid reduced filtration efficiency from incorrect installation. I've done it myself a few times—basic tools like a screwdriver are all you need, and it's not difficult. Using OEM filters or equivalent replacements is recommended to prevent dust leakage, which can cause interior odors or abnormal AC pressure leading to increased fuel consumption. A good practice is to check it every 15,000 km, ideally combined with regular maintenance for convenience. Safety tip: remember to turn off the engine and wear protective gloves. The design favors DIY by owners, eliminating frequent trips to the repair shop.