Where is the cabin air filter located in a Mercedes-Benz GLK300?

Where is the ETC generally installed?

The ETC is usually installed in the upper middle part of the front windshield for most vehicles, while for large vehicles like trucks and buses, it is installed in the lower middle part. The suitable installation position should be no lower than 1.2 meters and no higher than 2.5 meters, with an installation angle between 30 to 90 degrees. For vehicles with anti-explosion film or those that have it installed later, it may affect the signal transmission of the microwave communication link, so it should be installed in the microwave skylight band. ETC stands for Electronic Toll Collection, which is an electronic toll collection system. To apply for ETC, the vehicle owner needs to provide original and photocopies of their valid ID card and vehicle registration certificate. If the application is made by a proxy, the proxy's valid ID card is also required. The photocopy of the vehicle registration certificate should include the page with the most recent annual inspection stamp. A bank card for deducting highway tolls is also needed, and the vehicle must be registered under the name of an individual aged between 18 and 60. For company vehicles, the required documents include: A letter of introduction from the vehicle owner (with official seal); photocopy of the organization code certificate or business license (with official seal); original ID card of the proxy; original vehicle registration certificate; and the vehicle that needs to have ETC installed. Here are some precautions for installing ETC: Do not obstruct the driver's view. It is best to install it behind the rearview mirror: Many car models have a steeply angled windshield, which can reduce the driver's field of vision. Installing the ETC without considering this can increase the driver's blind spots. Installing it on the right side behind the rearview mirror can help avoid obstructing the view. Do not interfere with charging: The ETC electronic tag consumes power but generally does not require charging or battery replacement because it has a solar panel on the back for self-charging. Therefore, during installation, avoid the blackened areas on the windshield and positions that may block the solar panel. Once installed, do not remove it arbitrarily: The button in the middle of the adhesive is an anti-tamper lever connected to a switch. After the electronic tag is installed, the windshield will press the anti-tamper lever in. If the tag is removed arbitrarily, the lever will pop out and trigger the switch, locking the electronic tag and rendering it unusable. In such cases, you will need to visit an ETC service point to unlock it. This mechanism is designed to prevent multiple vehicles from sharing one device. When using ETC, note the following: The ETC transaction sensing range is 8 meters. To prevent issues caused by the ETC device of the vehicle in front, maintain a distance of more than 10 meters to avoid automatic toll deduction for the vehicle ahead. The ETC lane recognition speed is 20 km/h; driving too fast may result in failure to read the vehicle's device information, leading to toll deduction failure. When using a debit card linked to ETC, insufficient balance may also cause toll deduction failure.

10

2

Share

Which country produces Peugeot cars?

Peugeot is a French automobile brand. Here is some extended information: Model Introduction: Peugeot 408, Peugeot 508, Peugeot 3008, Peugeot 5008, Peugeot 2008, etc. 2014 Peugeot 408: Its body dimensions are: length 4750mm, width 1820mm, height 1488mm, wheelbase 2730mm, fuel tank capacity 53l, trunk capacity 455l, curb weight 1315kg. The 2014 Peugeot 408 is equipped with a 1.8l naturally aspirated engine, with a maximum horsepower of 139ps, maximum power of 102kw, maximum torque of 172nm, paired with a 5-speed manual transmission.

13

2

Share

How to Solve Dash Cam Interference with Car Radio?

To solve the issue of dash cam interference with car radio, the solution is to identify the path through which the interference propagates and either cut off this path or add additional interference suppression and isolation circuits. The diagnostic method involves using an oscilloscope to measure the voltage amplitude and ripple at the power supply terminal of the radio when it operates alone, recording the results. Then, power the dash cam and measure the radio's power supply again. By comparing the two measurements, you can determine if the interference is entering through the power supply and ground lines. Since the radio is a wireless RF circuit, it's possible that the dash cam, during its design, includes an antenna that continuously radiates in the corresponding frequency band. The dash cam records the entire journey, and in the event of an accident, it can help restore the facts and quickly determine liability.

17

3

Share

Does Stepping Hard on the Gas Pedal Damage the Car?

Stepping hard on the gas pedal can lead to carbon buildup, causing a decline in engine performance. The acceleration gained from stepping hard on the gas pedal may result in some idling conditions, as inertia can offset much of the power. Rapid driving can also exacerbate tire wear. Below is some related information about car braking: Mastering the Gas Pedal Technique: It is essential to master the correct stepping posture. The operation of the gas pedal should use the right heel placed on the floor of the driver's compartment as a pivot, with the sole gently pressing on the accelerator pedal. The ankle joint's flexion and extension should be used to press down or release the pedal. When pressing or releasing the gas pedal, the force should be gentle, ensuring a light press and slow release. Avoid Wearing Inappropriate Shoes While Driving: Remember not to drive wearing high heels, wedges, or other unsuitable footwear. Avoid Fully Depressing the Gas Pedal: When starting the car, do not press the gas pedal all the way down. It is better to keep it slightly above the idle throttle. During takeoff, it is advisable to apply a bit of gas just before the clutch engagement point, with the throttle opening set to a small or medium level. Releasing the clutch should be closely coordinated with pressing the gas pedal, ensuring swift and smooth actions. Select the Appropriate Gear Based on Conditions: While driving and operating the vehicle by pressing the gas pedal, the throttle should be increased or decreased according to road conditions and actual needs. The selected gear should be appropriate, allowing the engine to operate mostly at medium speed and with a larger throttle opening to save fuel.

10

3

Share

Why Does One Side of the Car Audio Work While the Other Doesn't?

Reasons why one side of the car audio works while the other doesn't: 1. Circuit failure—due to aging or potential cutting and friction from internal plastic parts, the circuit may disconnect or have poor contact, resulting in no sound from one side; 2. Audio damage; 3. Insufficient power supply from the car battery. Car audio maintenance tips: 1. High temperatures and humidity can directly shorten the lifespan of the audio—avoid direct sunlight and keep the audio dry; 2. After the car has been exposed to intense sunlight, avoid immediately turning up the volume, as electronic systems are affected by temperature changes—doing so may damage speakers and other components and reduce the audio system's lifespan; 3. Prevent dust buildup—close windows promptly in poor road conditions and maintain cleanliness inside the car.

11

2

Share

How to Reset the Maintenance Reminder on the Lamando?

Method to reset the maintenance reminder on the Lamando: First, insert the key into the ignition, then press and hold the "set" button on the right side of the car's dashboard. Turn the key to the "on" position (without starting the engine), hold for ten seconds, then release. Immediately after releasing, press the button on the left side once to successfully reset the reminder. The Lamando is a compact car produced by SAIC Volkswagen, with dimensions of 4599mm in length, 1826mm in width, and 1425mm in height, and a wheelbase of 2656mm. In terms of exterior design, the Lamando features two chrome strips on the upper grille that connect with the chrome eyebrow of the headlights. The front bumper, paired with the lower grille, extends horizontally to both sides, creating a sharp and integrated design that enhances daytime visibility, presenting a clear and distinctive appearance that exudes a bold and dynamic character.

3

2

Share

Where is the cabin air filter located in a Mercedes-Benz GLK300?

Where is the ETC generally installed?

Which country produces Peugeot cars?

How to Solve Dash Cam Interference with Car Radio?

Does Stepping Hard on the Gas Pedal Damage the Car?

Why Does One Side of the Car Audio Work While the Other Doesn't?

How to Reset the Maintenance Reminder on the Lamando?

Can Cars Run on Hydrogen?

Why Does the Car Brake Make Noise?

How to Use the Tire Pressure Monitoring System in the Ford Kuga?

What type of car is the Golf?