Where is the cabin air filter located in a 2012 Peugeot 508?

2 Answers
ZoeMarie
07/28/25 11:53pm
The cabin air filter in a 2012 Peugeot 508 is positioned directly beneath the central dashboard, above the accelerator pedal. Replacement steps: 1. Remove the plastic trim panel near the accelerator using a T20 screwdriver; 2. Detach the upper trim panel connected by clips; 3. After removing the trim panel, look upward to locate the cabin air filter's protective cover. Remove this cover to access the filter, then replace it with a new one. The Peugeot 508 is a premium sedan model with body dimensions of 4826mm in length, 1855mm in width, and 1465mm in height, featuring a 2815mm wheelbase. Power options include two powertrain configurations: a 2.0L engine paired with a 5-speed manual transmission, and a 2.3L engine mated to a 6-speed Tiptronic automatic transmission (with sport or snow modes).
Was this review help?
17
2
Share
MacLeonardo
08/12/25 4:12am
I recently replaced the cabin air filter on my 2012 Peugeot 508 myself, which is located behind the glove box on the passenger side. First, open the car door and sit in the passenger seat, then open the glove box. You'll notice small clips or a panel at the bottom—gently press down to release the entire glove box. Some models might require you to apply a bit more force to pull the glove box downward, revealing the rear panel. This panel usually has a small pull tab or slot; remove it to access the cabin air filter slot. When removing the old filter, be careful not to get your hands dirty as there's quite a bit of dust. When installing the new filter, align it according to the arrow direction with the airflow. I bought the matching filter online myself, and regular replacement helps prevent AC odors and extends its lifespan. I recommend checking it once a year before summer—it's a simple task that saves on repair costs and takes just five minutes to do yourself. Driving with fresh air makes the ride much more pleasant and breathing easier.
Was this review help?
8
0
Share
Expand All
More Forum Discussions

Does Using Car AC Consume More Fuel?

Using the car air conditioning does consume more fuel. Here is relevant information about vehicle air conditioning systems: 1. Concept: The vehicle air conditioning system consists of a compressor, condenser, throttle element, evaporator, fan, and necessary control components, designed to regulate cabin temperature and humidity to provide a comfortable environment for occupants. The refrigerant continuously circulates through the system, with each cycle including four processes: compression, condensation, throttling, and evaporation. 2. Working Principle: When the compressor operates, it draws in low-temperature, low-pressure gaseous refrigerant from the evaporator. After compression, the refrigerant's temperature and pressure increase, and it is then sent to the condenser.
10
1
Share

What is the wading depth of the Raptor?

The maximum wading depth of the Raptor is 810mm. The wading depth of the Raptor is determined by the height of the vehicle's chassis, which is the ground clearance listed in the model's parameter configuration table. Generally, the greater the ground clearance, the higher the chassis, and the higher the safety factor when driving through waterlogged roads. Therefore, in terms of safe wading depth, the advantages of off-road vehicles and SUVs are obvious. However, for most compact and small vehicles with low chassis, the position of the vehicle's air intake should be used as a benchmark when passing through waterlogged roads. If the air intake of the Raptor is below the water level during wading, water will be sucked into the engine's cylinders. Since water cannot be compressed like air, it will cause severe damage to the engine's mechanical components (such as connecting rods, pistons, crankshafts, etc.). Therefore, the wading depth must not exceed the height of the engine's air intake. The height of the engine's air intake, and thus the maximum wading depth, can also be increased by installing a snorkel. If wading is unavoidable, the following safe and correct operations should be performed: Before driving through water, always turn off the auto start-stop function to prevent the vehicle from automatically restarting after stalling in the water, which could cause severe engine damage due to water ingress. Judge the underwater road conditions based on the passage of preceding vehicles and choose an appropriate entry point. Observe the path taken by other vehicles, follow their tracks, and drive at a low speed. Avoid sudden acceleration or deceleration. On roads prone to water accumulation, observe warning water level markers, trees, and reference points such as the wheels and doors of other vehicles to estimate the water depth before deciding whether to proceed. Be aware of your vehicle's safe wading depth. If the water depth exceeds half of the tire height or the engine's air intake, do not proceed. Choose an alternative route instead.
20
1
Share

What is the wading depth of the Ford Raptor?

The maximum wading depth of the Ford Raptor is 810mm. The wading depth of the Ford Raptor is determined by the height of the vehicle's chassis, which is the ground clearance listed in the model's parameter configuration table. Generally, the greater the ground clearance, the higher the chassis, and the higher the safety factor when passing through waterlogged roads. Therefore, in terms of safe wading depth, the advantages of off-road vehicles and SUVs are obvious. However, for most compact cars and small cars with low chassis, the position of the vehicle's air intake should be used as a reference when passing through waterlogged roads. If the air intake is below the water level when the Raptor is wading, water will be sucked into the engine's cylinders. Since water cannot be compressed like air, it will cause severe damage to the engine's mechanical components (such as connecting rods, pistons, crankshafts, etc.). Therefore, the wading depth should not exceed the height of the engine's air intake. The height of the engine's air intake, and thus the maximum wading depth, can also be increased by installing a snorkel. If wading is unavoidable, the following safe and correct operations should be performed: Before the vehicle enters the water, the auto start-stop function must be turned off to prevent the engine from automatically restarting after stalling in the water, which could cause severe damage due to water ingress. Assess the underwater road conditions based on the passage of preceding vehicles and choose an appropriate entry point. Observe the path taken by other vehicles and follow their tracks at low speed, avoiding sudden acceleration or deceleration. For roads prone to water accumulation, observe warning water level markers, trees, and other reference points such as the wheels and doors of other vehicles to estimate the water depth before deciding whether to proceed. Be aware of your vehicle's safe wading depth. If the water depth exceeds half of the tire height or the engine's air intake, do not enter the water recklessly. Instead, choose an alternative route.
19
1
Share

Can Flooded Vehicles in Zhengzhou Be Covered by Insurance?

If the car owner has purchased auto flood insurance, they can enjoy insurance claims when the vehicle is flooded. Below is relevant information about flooded vehicles: 1. Concept: A flooded vehicle refers to a car that has been submerged in water, typically meaning the engine and transmission have been soaked, with water levels exceeding the wheels and body seats, and the vehicle's underbody components being in prolonged contact with water. Such vehicles pose significant risks, as the electrical circuits are prone to short circuits, fires, etc. 2. Insurance: There are two types of insurance related to vehicle flooding—the most common being auto damage insurance, and the other called special engine loss insurance, commonly known as flood insurance.
12
5
Share

What is a Paint Protection Film?

Paint protection film is a high-performance, new type of environmentally friendly film. Here are some relevant details about paint protection film: 1. Composition: Paint protection film is a thermoplastic polyurethane film (TPU) that contains UV-resistant polymers and is resistant to yellowing, with exceptional toughness. 2. Product Features: Excellent ductility and superior tensile strength; can be applied on any curved surface. Resistant to yellowing for over 3 years and to aging for over 5 years. Crystal-clear transparency that blends seamlessly with the original car paint without affecting its color; can enhance the glossiness of the car paint by 5%-20%. It can resist damage to the paint surface caused by petroleum, grease, weak alkalis, gravel, acid rain, etc.
18
1
Share

Will the insurance company compensate for a water-damaged car?

If the car owner has purchased auto water damage insurance, they can enjoy insurance claims when the vehicle is flooded. Below is relevant information about water-damaged cars: 1. Concept: A water-damaged car refers to a vehicle that has been submerged in water, typically meaning the engine and transmission have been soaked, with water depth exceeding the wheels and body seats, and the bottom components of the vehicle being in prolonged contact with water. Such vehicles pose significant risks, as the electrical circuits are prone to short circuits and fires. 2. Insurance: There are two types of insurance related to vehicle water damage: the most common one is auto damage insurance, and the other is called special engine loss insurance, commonly known as water damage insurance.
12
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.