Where is the cabin air filter located in a 2012 Nissan X-Trail?

2 Answers
McIsabela
07/29/25 6:49pm
On the right side of the driver's accelerator pedal. Open the lower right cover panel of the center console to access the cabin air filter cover. Here's an introduction to the replacement schedule for the X-Trail's cabin air filter: 1. The recommended replacement interval for the X-Trail's cabin air filter is typically every 20,000 kilometers or once a year. 2. The actual replacement frequency depends on usage conditions. For most urban family vehicles, it's recommended to replace every six months to one year. Here are the step-by-step instructions for replacing the filter: 1. Pry open the right-side panel of the center console, then use a screwdriver to remove the small cover of the cabin air filter compartment to reveal the filter. 2. Remove the old cabin air filter and install the new one. 3. Since the cabin air filter is made of relatively soft paper material, Nissan officially advises against repeatedly blowing off dust or reusing it.
Was this review help?
9
0
Share
LeTyler
08/14/25 12:25pm
I drive a 2012 X-Trail and have replaced the cabin air filter several times. It's hidden behind the glove box. First, you need to open the glove box and empty all the contents, then locate the clip or screw at the bottom of the box and unscrew or pry it off. Next, slowly pull out the entire glove box tray to reveal the filter cover. Open the cover, pull out the old filter, and remember to install the new filter in the direction of the arrow to avoid affecting the filtration efficiency. I change mine once a year, and the air feels much fresher, especially during spring when pollen is high—my nose doesn’t get irritated anymore. If you're unsure, don’t force it; just take it to a repair shop to avoid damaging the plastic parts. Changing the filter is simple—just have a new filter and a screwdriver ready. Regular checks can also extend its lifespan.
Was this review help?
7
1
Share
Expand All
More Forum Discussions

Is it necessary to repaint a scratched fender?

A scratched fender does not require repainting. If the fender only has paint damage without any dents, simply applying putty and repainting the affected area is sufficient. However, there is one situation where a full repaint is recommended: when the vehicle has a special color. This is because partial repainting on special colors can easily result in color discrepancies, affecting the aesthetic appearance. Notes on car scratches: 1. New cars: It's best to repair scratches on new cars as soon as possible to maintain their appearance. 2. Polishing machine: For minor scratches, use a polishing machine, but avoid excessive grinding to prevent damage to the paint. 3. 4S shops: For more severe damage, it's advisable to visit a 4S shop for professional repair.
4
1
Share

How to adjust the brakes on the GAC Trumpchi GS4?

The method to adjust the brakes on the GAC Trumpchi GS4 is by adjusting the nut below the pedal. The brake clearance is automatically adjusted and does not require manual adjustment. Braking, also known as stopping, refers to the action of stopping or reducing the speed of running locomotives, vehicles, and other transportation tools or machinery. The principle of braking involves fixing a wheel on the high-speed shaft of the machine and installing corresponding brake shoes, bands, or discs on the machine base to generate braking torque under external force. The GAC Trumpchi GS4 is a compact SUV with a length, width, and height of 4545mm, 1856mm, and 1668mm respectively, and a wheelbase of 2680mm.
13
5
Share

What are the reasons for a car air conditioner not cooling properly?

There are several reasons why a car air conditioner may not cool effectively: 1. Excessive refrigerant: Too much refrigerant can reduce cooling efficiency. If the refrigerant and compressor oil contain excessive impurities, minor blockages can occur, leading to insufficient cooling capacity. 2. Insufficient refrigerant: A lack of refrigerant results in inadequate cooling. A dirty condenser or a loose compressor drive belt can also cause the air conditioner to blow warm air. 3. Excessive impurities: If the refrigerant and compressor oil contain too many impurities, minor blockages can form, reducing cooling capacity. If the entire air conditioning system has excessive contaminants in the refrigerant and compressor oil, the filter screen will likely become clogged, decreasing refrigerant flow, increasing resistance, and reducing the amount of refrigerant reaching the expansion valve, thereby causing insufficient cooling.
6
3
Share

How to connect the tachometer signal wire for BYD F0?

To connect the tachometer signal wire for BYD F0, attach the yellow signal wire to the trigger terminal of the ignition switch. The engine fires once every four strokes, which corresponds one-to-one with the RPM. Simply connect it in parallel. The other two wires should be connected to the positive and negative power terminals respectively, with black being positive and green being negative. The BYD F0 is a compact car launched by BYD Company. Its body dimensions are 3460mm in length, 1618mm in width, and 1465mm in height, with a wheelbase of 2340mm. It is equipped with a 1.0L naturally aspirated engine, delivering a maximum power of 50 kW at 6000 RPM and a maximum torque of 90 Nm between 4000 to 4500 RPM. It is paired with a 5-speed manual transmission.
7
2
Share

What are the reasons for the difficulty in starting the Ford Transit diesel vehicle in the morning?

The reasons for the difficulty in starting the Ford Transit diesel vehicle in the morning are: 1. Use of high-viscosity engine oil in winter; 2. Excessive carbon deposits in the intake system and at the root of the intake valve, resulting in an overly lean air-fuel mixture during cold starts; 3. Severe throttle valve contamination, leading to insufficient air intake; 4. Transmission lubricating oil viscosity being too thick, causing excessive engine operating resistance; 5. Insufficient cylinder compression pressure in the engine, among others. Taking the 2020 Ford Transit as an example, its front suspension is a MacPherson independent suspension, the rear suspension is a leaf spring non-independent suspension, equipped with a 2.0T turbocharged engine, with a maximum horsepower of 202 PS, a maximum power of 148.5 kW, a maximum torque of 300 Nm, and matched with a 5-speed manual transmission.
19
1
Share

What Causes the Coolant Reservoir to Overflow When the Car Is Not Overheating?

There are two scenarios where the coolant reservoir overflows without the car overheating: 1. Overflow occurs when aggressively pressing the accelerator: This is mainly due to significant gaps or cracks in the wet cylinder liners or cylinder head. When the engine is running, the pressure of compressed air or combustion gases in the cylinders exceeds the pressure of the coolant in the cooling passages, allowing these combustible gases to enter the engine's cooling passages through the gaps, resulting in the coolant reservoir overflowing. 2. No air in the coolant during engine operation: Whether the coolant temperature is high or low, pressing the accelerator does not cause the coolant to spray out from the radiator filler neck, but releasing the accelerator results in coolant spraying out from the filler neck.
5
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.