Where is the cabin air filter located in a 2011 Haval H5?

3 Answers
MacTheo
07/29/25 11:17am
Here is the introduction about the cabin air filter location in Haval H5: 1. The 2011 Haval H5 model does not have a cabin air filter, as the filtered air conditioning system was only installed starting from the second half of 2012. 2. For later models, the filter is located outside the front windshield on the passenger side, behind the engine compartment, under a plastic cover. Loosen one screw and lift the cover to see it. Here is some additional information about cabin air filters: 1. The cabin air filter can be considered the most important component of the air conditioning system, primarily responsible for comprehensively filtering dust, pollen, and bacteria from the air. 2. During maintenance of the air conditioning refrigeration system, it is essential to thoroughly clean the cabin air filter.
Was this review help?
6
2
Share
TannerFitz
08/13/25 6:16pm
My 2011 Haval H5 requires crawling behind the glove compartment to replace the cabin air filter. First empty the glove box, then lift it firmly upwards to remove the entire unit. Inside hides a white plastic cover with clips on both sides – pinch them to release. The filter sits in a long slot in front of the blower motor; note the arrow direction when pulling it out to avoid installing the new one backwards. DIY replacement saves big – Taobao sells filters for 20 yuan, while dealerships charge 200 just for labor. Remember to change it every six months, especially during northern China's spring when poplar catkins clog everything.
Was this review help?
14
5
Share
Expand All
Greyson
08/13/25 6:18pm
As a female car owner, I've changed it three times myself. The glove compartment on the passenger side is the breakthrough point. After emptying the items, hold the bottom of the compartment with both hands and push it upward, and the entire compartment will come off. At this point, you'll see a cover with grids. Press the clips on both sides of the cover simultaneously to remove the filter frame. The filter for the old H5 is flat and rectangular, so don't buy the wrong model. Last week when I changed it, I found the filter covered with leaves and small insects, no wonder there was a musty smell when the AC was on. I recommend buying a filter with activated carbon. It's ten yuan more expensive but the odor removal effect is noticeable.
Was this review help?
16
0
Share
Expand All
More Forum Discussions

What is the ground clearance of the Lynk & Co 01?

The minimum ground clearance (unladen) of the Lynk & Co 01 is 211mm, and the ground clearance when fully loaded is 170mm. Introduction to ground clearance: Ground clearance refers to the distance between the ground and the rigid parts at the bottom of the vehicle. The ground clearance of a vehicle varies depending on whether it is unladen or loaded. Ground clearance is related to the vehicle's load; the heavier the load, the smaller the ground clearance. Vehicles with lower ground clearance have a lower center of gravity but poorer off-road capability. Impact of minimum ground clearance: The greater the minimum ground clearance, the better the vehicle's ability to pass over obstacles or uneven terrain, but the higher center of gravity reduces stability. The smaller the minimum ground clearance, the weaker the vehicle's ability to pass over obstacles or uneven terrain, but the lower center of gravity increases stability.
14
0
Share

What Causes the Golf Display Screen to Go Black?

Golf display screen blackout may be caused by issues with the vehicle's power supply voltage. Here are detailed explanations and solutions: Vehicle power supply voltage issues: The solution is to first investigate the stability of the vehicle's power supply voltage to rule out the possibility of voltage fluctuations. Car navigation cable problems: The solution is if the voltage is stable, then check the cables on the back of the device for any issues, which can be resolved by replacing the connections. If there are no contact issues, inspect the display cable of the device; if problems are found, replace it with a new one for testing.
20
1
Share

What causes the airbag light to flash in a Tiida?

The flashing airbag light in a Tiida may be due to loose wiring in the airbag device, a faulty sensor in the airbag device, or a weak battery. Here are detailed explanations and solutions: Loose wiring in the airbag device: Loose or poor contact in the airbag device wiring. There are airbag device wires under the car seat, which may have been accidentally kicked or disturbed by rear-seat passengers, causing them to loosen. The solution is to simply reconnect all the plugs. Faulty sensor in the airbag device: This requires inspection and repair at a professional auto repair facility or 4S shop. Weak battery: A weak battery or abnormal reception device code may be the cause. This requires a professional to check the battery voltage or use a diagnostic device to examine the code and troubleshoot the issue.
6
5
Share

What's the matter with the indirect tire pressure monitoring failure in Golf?

Golf indirect tire pressure monitoring failure may be due to issues with the tire pressure detector or prolonged driving with low tire pressure. Here are detailed explanations and solutions: Problems with the tire pressure detector: The solution is to regularly check whether the tire pressure detector is functioning properly. If the tire pressure monitor does not alert in time when the car has issues, it indicates a problem with the tire pressure monitor. Prolonged driving with low tire pressure: The solution is to stop and rest or replace the spare tire in time. This situation usually occurs when the tire pressure of a certain tire is too low, and high-speed operation causes the tire temperature to rise, leading to an increase in tire pressure.
1
5
Share

What are the reasons for the high fuel consumption of Mazda 6?

The reasons for the high fuel consumption of Mazda 6 include low-quality fuel, severe engine carbon deposits, and excessive vehicle weight. Here are the detailed explanations and solutions: Low-quality fuel: When the fuel added to the car is of low quality, the fuel and mixed gas cannot burn fully in the engine, leading to partial fuel wastage and consequently increased fuel consumption. This situation can be mitigated to some extent by using higher-quality fuel. Severe engine carbon deposits: When the engine carbon deposits are too severe, the fuel cannot be transported normally, resulting in increased fuel consumption and weakened power. In this case, it is necessary to clean the engine carbon deposits promptly. Excessive vehicle weight: When the vehicle weight is too high, it increases the burden on the engine, leading to higher fuel consumption. To address this, the vehicle weight should be reduced.
3
0
Share

How Many Liters of Engine Oil Does the Lynk & Co 02 Require?

According to the manufacturer's manual, the Lynk & Co 02's recommended engine oil specifications are as follows: For the 1.5T version engine, it is recommended to use RBS0-2AE0W-20 engine oil; the oil capacity (with oil filter) is approximately 5.6L, and the oil capacity (without oil filter) is approximately 5.3L. For the 2.0T version engine, it is also recommended to use RBS0-2AE0W-20 engine oil; the oil capacity (with oil filter) is approximately 5.6L, and the oil capacity (without oil filter) is approximately 5.2L. To check the engine oil level: The oil level can be viewed on the dashboard. Without pressing the brake pedal, hold the start button alone for ten seconds, and the oil level will be displayed on the dashboard. When checking, ensure that all four wheels of the car are parked on the same level surface without any tilt. If the car body is tilted, the oil level in the oil pan will change, leading to inaccurate measurement results.
12
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.