Where is the button to adjust the seat on a bus?

1 Answers
McKai
07/30/25 10:53am
Button is located on the left or right side of the seat cushion inside the bus, or next to the armrest. Here is relevant information: 1. Adjustment angle: The principle of seat adjustment ultimately depends on the comfortable sitting angle for the human body. Each person's height and weight are different, so the most important aspects during actual adjustment are the angles of the back, elbow joint, and knee joint. 2. Aisle adjustment: For bus seats next to the aisle, the left and right buttons on the armrest adjust the seat's lateral movement, allowing the seat next to the aisle to be adjusted towards the aisle, increasing the width between seats.
Was this review help?
2
1
Share
More Forum Discussions

What to Do When the Rear Axle of a Car Overheats?

Immediately ventilate the area. The stronger the wind, the faster the cooling, or water it—the more water, the faster the cooling. Cool it down to ambient temperature, close the doors and windows, turn on the air conditioning, water the radiator, add ice water, and cool the radiator. The lower the radiator temperature, the better the air conditioning effect and the faster the cooling. If this happens while driving, pull over immediately and turn off the engine. If driving at high speed, be sure to set up the warning triangle with sufficient distance between the triangles. Then open the engine hood, being careful not to burn yourself, and check if the coolant in the tank is insufficient or leaking. Of course, checking might not be very meaningful since, even if there’s not enough coolant, there’s little you can do. At this point, call a tow truck if possible. If the coolant is only slightly low, you may drive for a while after the engine temperature drops, but closely monitor whether the water temperature alarm activates.
16
3
Share

How much refrigerant should be added to an Audi A6?

Audi A6 generally requires 2 bottles of 300g refrigerant. Introduction to refrigerant: Refrigerant, commonly known as freon, is a working fluid used in refrigeration and air conditioning systems to transfer heat energy and produce cooling effects. It can be classified by working method into primary refrigerant and secondary refrigerant, or by material properties into natural refrigerant and synthetic refrigerant. Physical and chemical properties of refrigerant: Refrigerant is a substance that easily absorbs heat to become gas and releases heat to become liquid. In early refrigeration plants, ammonia was used as refrigerant - when pressurized, ammonia releases heat and turns into liquid; when high-pressure liquid is depressurized into gas, it absorbs heat. The refrigerant commonly used in household air conditioners is fluorochlorocarbon, but older types of fluorochlorocarbons were found to damage the ozone layer. Scientists have since developed ozone-friendly fluorochlorocarbons. An ideal refrigerant should be non-toxic, non-explosive, non-corrosive to metals and non-metals, non-flammable, easily detectable when leaking, chemically stable, non-destructive to lubricants, have high latent heat of evaporation, and be environmentally harmless.
15
3
Share

Does the URV have a hybrid version?

The URV does not have a hybrid version. Here is an introduction to the URV: 1. In terms of configuration, the new vehicle comes standard with features such as cruise control, keyless entry, one-button start, tri-zone independent air conditioning, B-pillar air vents, and tire pressure monitoring. Additionally, the new vehicle is equipped with the HONDA CONNECT intelligent guidance interconnection system, including in-car WiFi, smart connectivity, navigation multimedia entertainment, and road rescue functions. 2. For the interior, the design of the URV is largely the same as that of the Avancier, with only the air vents and some buttons being redesigned. The center console features an 8-inch touchscreen display. 3. In terms of exterior, the Dongfeng Honda URV is based on the Honda Concept D. Compared to the GAC Honda Avancier, the URV's headlight assembly, front grille, and front bumper form a U-shaped design, complemented by more chrome accents. Furthermore, the fog light area and front bumper design of the URV have also been redesigned.
17
3
Share

What is the reason for the Audi Q3 tailgate brake light not working?

Audi Q3 tailgate brake light not working reasons are as follows: Fuse blown: First, check the fuse. It may be that the brake light fuse has blown, causing the brake light not to work. Most car brake light fuses are located in the car's center console. You need to find the brake fuse according to the fuse box instructions and pull it out to check if it is blown. Brake light bulb filament broken: Even if the power is connected, the brake light will not work. In this case, you need to remove the brake light and check if the bulb is normal. If there is a problem, it needs to be replaced promptly. Brake light circuit damaged: The brake light will only work normally after the brake light switch is properly connected. First, unplug the brake light switch and use a wire to connect the switch. If the brake light turns on, it means the brake light switch is damaged. If it does not turn on, it means the brake light switch is not the issue.
7
0
Share

What are the dimensions of the Mercedes-Benz E260L?

The length (mm) of the Mercedes-Benz E260L is 5065, the width (mm) is 1860, and the height (mm) is 1490. Appearance: The new Mercedes-Benz E-Class doesn't differ much in design from the previous model, retaining the brand's signature design language. Its elongated body, paired with smooth body lines, exudes a high-end and business-like feel. However, the new family-style details add a touch of sportiness and modernity. Interior: The interior design follows Mercedes-Benz's mainstream family-style language, appearing very retro and luxurious. The addition of LCD screens introduces a sense of technology and futurism. Moreover, the craftsmanship and materials are superior to the older E-Class models, reducing the likelihood of squeaking noises. Performance: The new E260L model has been upgraded with a new low-power tuned 2.0T engine, delivering a maximum horsepower of 197 HP and 320 Nm. These specifications are better than the previous 1.5T model. It is still paired with Mercedes' own 9AT transmission, achieving a 0-100 km/h acceleration time of just over 7 seconds, which is also faster.
5
1
Share

What is the voltage of an electric vehicle?

Electric vehicles generally operate at 336V or 384V, while electric buses typically have a bus voltage of 580-600V. The higher the bus voltage, the wider the constant power speed range of the motor. Voltage (V): Electric vehicles generally operate at 336V or 384V, while electric buses typically have a bus voltage of 580-600V. The higher the bus voltage, the wider the constant power speed range of the motor. On-board power source: A pure electric vehicle refers to a vehicle that uses an on-board power source as its power, meeting all the requirements of road traffic and safety regulations. Due to its relatively smaller environmental impact compared to traditional vehicles, its prospects are widely optimistic, but the current technology is still not mature. A pure electric vehicle (Battery Electric Vehicle, abbreviated as BEV) is entirely powered by rechargeable batteries (such as lead-acid batteries, nickel-cadmium batteries, nickel-metal hydride batteries, or lithium-ion batteries). Although it has a long history of 134 years, its application has been limited to certain specific areas, mainly due to the serious shortcomings of various types of batteries, including high cost, short lifespan, large size and weight, and long charging time.
3
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.