Where is the brake fluid reservoir located on the Chery Flagcloud 2?
2 Answers
The brake fluid reservoir of the Chery Flagcloud 2 is located near the wiper motor on the left side of the engine compartment. Function of the brake fluid reservoir: The brake fluid reservoir is used to hold brake fluid, which is unquestionable. Although the replacement cycle of brake fluid is relatively long, if the brake fluid is not replaced in time, it will become turbid, its boiling point will decrease, and its effectiveness will deteriorate, leading to brake failure. This is because the brake fluid system always experiences wear, and the brake fluid absorbs moisture from the air, leading to oxidation, deterioration, and other phenomena, which can easily cause the brake fluid to expire and reduce its effectiveness. Brake fluid inspection: Brake fluid is a critical component of the braking system. When the brake pedal is pressed, the high temperature from the friction between the brake discs and pads is transferred to the brake fluid, and the oil temperature can even exceed 100 degrees Celsius. At this point, the water inside the fluid will turn into a gaseous state, and pressing the brake pedal will feel empty, which is very dangerous. Therefore, when high moisture content is detected in the brake fluid, it is recommended to replace it promptly.
As a seasoned driver, I often locate the brake fluid reservoir on my Chery Fulwin 2. It's positioned at the rear of the engine bay, near the windshield side. Typically, it's a translucent plastic container about the size of a fist, colored black or gray, with labels reading 'Brake Fluid' or 'DOT3'. After opening the hood, you can easily spot it by looking forward from the driver's seat direction. The fluid level should be between the min and max lines; if it's too low, the brakes may feel spongy, which is especially dangerous in rainy conditions. I make it a habit to check it every two months and top it up with qualified brake fluid to maintain safety. Developing this routine helps prevent major brake failure issues and saves a lot on repair costs. Remember, checking when the engine is cold gives the most accurate reading, as the fluid level fluctuates more when the engine is hot. Don't brush it off as a hassle—it's just a two-minute task that's crucial for driving safety.
