Where is the body control module located on the Chery Flagcloud 2?

[Micah]

The high-configuration 2012 model has it under the left front seat, while other models only have the window control module located under the left rear seat cushion. Functions of the body control module: Power management; light control; wiper control; central door lock and remote control reception; vehicle anti-theft and engine immobilizer control; self-diagnosis in fault mode. Body Control Module: The Body Control Module (BCM) is one of the most important modules in a vehicle. The BCM can perform various functions. Output devices are managed based on data received from input devices through CAN (Controller Area Network), LIN (Local Interconnect Network), or Ethernet as means of communication with modules and systems.

[BryceAnn]

I remember I used to have a Chery Fulwin 2, and the body control module was located inside the driver's side footwell. You had to remove the small panel under the dashboard to see its exact position, usually tucked behind the fuse box. It was designed there to protect the module from being exposed, avoiding bumps and moisture interference. I replaced it once myself because the windows stopped working. Upon opening it, I found it was a small black box with thin wiring. Before working on it, you had to disconnect the battery to prevent short circuits. Although not overly complicated, the limited space could make it tricky—if you're clumsy, you might mess up the wiring harness. It's advisable not to overlook this corner during routine car inspections. While its hidden location offers good protection, aging can lead to frequent malfunctions. Experienced drivers who've been on the road for years know that the placement of these small components is crucial—easy to maintain without affecting daily use.

[EvaFitz]

As an occasional car repair helper, I know the Chery Flagcloud 2's body control module is installed in the front area of the driver's side footwell, right below the fuse box. You'll need to remove several protective panels under the floor mat to access it. The location is well chosen, away from heat sources and vibration sources. The module itself resembles a controller box, connected to wiring systems like windows and lights. During maintenance, pay attention to anti-static measures and power-off procedures, otherwise the circuits can be easily damaged. From experience, this location makes fault diagnosis more intuitive. If the module fails, it may cause headlight or central locking malfunctions - timely inspection can save trouble. For DIY friends, I recommend starting with simple tools and avoiding forcefully pulling wiring harnesses, as the tight space can easily cause hand injuries.

[JustinLynn]

When driving this car, I noticed that the body control module is located behind the front panel near the driver's footwell, close to the fuse box. The placement is discreet yet well-designed, making it less prone to water accumulation or dust. If you need to inspect it, you'll have to remove the cover to reveal a small black device. It usually functions without issues, but a malfunction can affect window and door controls. Remember to disconnect the power before performing any operations.