Where is the body control module located on the Buick New Regal?

1 Answers
NicoleAnn
07/29/25 3:17pm
The body control module of the Buick New Regal is located at the bottom center of the instrument panel. Detailed information about the body control module is as follows: 1. The Body Control Module (BCM) is a powerful control module. Its body controller connects to various power sources, and the main controller is connected to the execution circuits of input signals respectively. The input end of the main controller is also connected to the output end of the airbag control. 2. When the main controller detects an 80ms low-level pulse, it determines that a collision has occurred and outputs two unlock signals until all motors are opened/closed. The motors unlock the doors, allowing timely escape for occupants inside and prompt rescue from outside.
Was this review help?
19
2
Share
More Forum Discussions

What are the main components of an automotive air conditioning system?

An automotive air conditioning system mainly consists of the following components: 1. Refrigeration system: The compressor's function is to compress low-pressure vapor into high-pressure vapor, reducing the vapor volume and increasing the pressure. The compressor draws lower-pressure vapor from the evaporator and, after increasing the pressure, sends it to the condenser. 2. Heating system: A low-temperature heat medium is heated in the heat source, absorbs heat to become a high-temperature heat medium, and is then transported through pipes to the interior, where it releases heat through radiators to raise the indoor temperature. 3. Ventilation system: This system uses natural or mechanical methods to allow unobstructed airflow to pass through and reach the interior or a sealed environment, creating a sanitary, safe, and suitable air environment. 4. Air purification device: The air purification device can remove impurities and purify contaminated air. 5. Control system: The control system refers to a management system composed of a control subject, control object, and control medium, with its own goals and functions.
18
0
Share

Where is the Car's Air Filter Located?

The location of a car's air filter element varies depending on the intake form and engine structure. It is generally located in the air cleaner on the engine's intake pipe. There are two types of air filters in cars: dry and wet. Dry filters are made of paper or organic materials, while wet filters are made of metal mesh. The air filter should be replaced every 10,000 to 20,000 kilometers or during each maintenance interval. However, it is recommended to clean the air filter every 5,000 kilometers to reduce the formation of throttle sludge. Function of the air filter: It filters out particulate impurities in the air, ensuring that sufficient clean air enters the cylinders and preventing floating dust in the air from being sucked into the engine, which accelerates wear on the piston group and cylinders. Air filter: It is a type of filter, also known as an air filter cartridge, air cleaner, or style. It is mainly used in engineering vehicles, cars, agricultural vehicles, laboratories, sterile operating rooms, and various precision operating rooms as an air filter. During operation, the engine inhales a large amount of air. If the air is not filtered, the suspended dust in the air will be sucked into the cylinders, accelerating the wear of the piston group and cylinders. Larger particles entering between the piston and cylinder can cause severe cylinder scoring, especially in dry and sandy working environments. The air cleaner is installed in front of the carburetor or intake pipe to filter out dust and sand particles from the air, ensuring that sufficient and clean air enters the cylinders. Dirty air cleaner: Using an excessively dirty air cleaner while driving can cause insufficient engine intake, incomplete fuel combustion, leading to unstable engine operation, reduced power, and increased fuel consumption. Therefore, the car's air cleaner must be kept clean. The car's air cleaner is a device that removes particulate impurities from the air, consisting of one or several air filter components. Its main function is to filter out harmful impurities in the air before it enters the cylinders, reducing early wear on the cylinders, pistons, piston rings, valves, and valve seats. Therefore, before air enters the cylinders, it must be finely filtered by the air cleaner. A dirty air cleaner can cause poor engine performance, excessive fuel consumption, and engine damage. When inspecting the air cleaner, if it is found to have little dust and is lightly clogged, it can be cleaned with high-pressure air from the inside out and reused. Excessively dirty air filters should be replaced promptly.
13
1
Share

How to Wire a Car Rearview Camera?

Car rearview camera wiring steps are as follows: 1. Insert the original accessory camera wiring harness into the rear license plate light hole, then snap it in place. 2. Remove the trunk liner, pull out the waterproof wiring grommet, use a pull wire to draw the camera harness into the trunk, guide the camera harness and data connector to the grommet wiring hole, and finally reinstall the waterproof grommet. 3. Remove the left decorative panel of the trunk, connect the combined power/data extension cable to the camera harness, and route it along the original vehicle wiring harness from the rear trim panel. 4. Peel back the door seal on the left side of the rear seat, guide the wiring into the rear cabin, and pull out both the combined power/data plug and remaining extension cable. 5. Restore the trunk, tuck the extension cable into the plastic panel gap along the door seal until reaching the driver's side door edge. 6. Remove the storage compartment below the headlight, pass above the OBD interface, then connect the wiring port to the navigation system interface.
15
2
Share

How Many Days After Running a Red Light Can You Receive a Notification?

After running a red light, the violation capture SMS is usually received within 3 to 7 days, with the latest being around 13 days. However, some cities now offer "instant electronic police capture notifications," where you can receive an SMS notification within 5-10 minutes of being captured. But a notification does not equate to a violation; it merely serves as a capture alert. The final determination of whether it constitutes a violation takes 3-7 days. If it is indeed a violation, you will receive another SMS notification. For traffic violations captured by surveillance cameras, vehicle owners generally do not receive the violation SMS immediately. There is a time delay, and the duration may vary. This is because after the electronic camera captures the violation, the relevant violation information needs to be transmitted through a dedicated channel to the traffic police management center, where it is compiled and then verified by relevant traffic police personnel. Only after the violation is confirmed will the system automatically retrieve the vehicle owner's phone number based on the license plate information and send the violation details via SMS. After receiving the violation SMS, the vehicle owner must go to the traffic police department at the location of the violation within one month before the vehicle's annual inspection to handle the matter. Generally, if a vehicle owner suspects they have committed a violation, they can use 15 days as a benchmark. If no violation SMS is received after 15 days, it is likely that no violation was recorded. Traffic Violation Query Methods: Traffic violation queries refer to checking a motor vehicle's traffic management violations online or via query terminals. There are five methods for vehicle violation queries: traffic branch terminal queries, vehicle violation website queries, phone queries, SMS queries, and mobile app queries. Website Query: You can search for "vehicle violation query" and enter your vehicle information to check. Phone Query: To query violations, you can call the local 114 (area code + 114) or 12580 for confirmation. Violations can only be processed at the location of the violation or the vehicle's license plate registration location. For on-the-spot violations, such as those directly caught by traffic police, they must be handled at the violation location. SMS Query: Open your phone's SMS composition interface; enter "WZ [license plate number] [plate color]" in the message body; input 1062650001 as the recipient and send. Mobile App Query: Open the "Traffic Management 12123" app, select "Violation Query," and clear any unresolved violations.
5
3
Share

What does CTV transmission mean?

CVT usually refers to a type of automotive transmission, also known as a continuously variable transmission. The difference between a CVT and a stepped transmission is that its gear ratio is not a discontinuous point but a series of continuous values, thereby achieving excellent fuel economy, power performance, and smooth driving, while reducing emissions and costs. The advantages of a CVT continuously variable transmission include the following: 1. Since there are no transmission gears like those in a conventional automatic transmission, the shifting process of an automatic transmission is eliminated, along with the associated shift shock. As a result, the power output of a CVT transmission is linear, providing a very smooth driving experience. 2. Theoretically, a CVT transmission system can have an unlimited number of gear ratios, allowing for more flexible gear settings. It is easier to achieve a balance between gear ratios, speed ratios, performance, fuel consumption, and exhaust emissions compared to traditional transmission systems. 3. The mechanical efficiency and fuel economy of a CVT transmission are significantly better than those of a conventional automatic transmission, second only to manual transmissions, and its fuel efficiency is much better than that of manual transmissions.
8
4
Share

What Could Be the Reasons for a Car Not Starting?

There are several possible reasons why a car may not start: 1. Fuel system issues: clogged low-pressure fuel lines, loose or leaking fuel pipes, air in high-pressure fuel lines, poor technical condition of the fuel injectors, incorrect fuel injection timing. 2. Starting system issues: power supply failure, poor contact in the electromagnetic switch, poor contact between the starter motor commutator and brushes, slipping clutch in the starter transmission mechanism. 3. Insufficient cylinder compression pressure: damaged cylinder head gasket causing air leakage, valves not sealing properly leading to air leakage, worn piston or cylinder liner causing air leakage. 4. Insufficient air intake: clogged air filter element.
3
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.