Where is the BMW X1's Cabin Air Filter Located?

1 Answers
LaBenjamin
07/29/25 11:27pm
The cabin air filter of the BMW X1 is located in the engine compartment, near the windshield wipers. Below are the methods for replacing and cleaning the cabin air filter: Method for replacing the cabin air filter: Remove the 6 screws in the engine compartment; after removal, you can see the cabin air filter, and it is very convenient to take it out and replace it; when installing, pay attention to the direction, and after installation, check whether it is properly and firmly in place. Method for cleaning the cabin air filter: If the filter is very dirty, use compressed air to clean it from bottom to top. Keep the air gun 5cm (centimeters) away from the filter and blow at 500kPa (kilopascals) for about 2 minutes. If the cleaning effect is not achieved, please have the dealer clean or replace it.
Was this review help?
16
0
Share
More Forum Discussions

Is it necessary to press the accelerator in Subject Two?

Subject Two test allows pressing the accelerator, but be careful not to stop the car, let alone stall it. Here is an introduction to Subject Two: Definition: Subject Two, also known as the small road test, is part of the motor vehicle driver's license assessment, referred to as the field driving skill test subject. Objective: Master the basic driving operation essentials, possess the basic ability to control the vehicle; proficiently master the basic methods of field and in-field road driving, have the ability to reasonably use vehicle control components, correctly control the spatial position of the vehicle movement, and accurately control the vehicle's driving position, speed, and route.
14
3
Share

What Causes the Sudden Disappearance of Gear Display in Automatic Transmission?

Automatic transmission suddenly not displaying the gear position may be caused by an abnormality in the gear selector switch. Below is a related introduction to automatic transmission gears: P (Park) gear: The output shaft is locked. R (Reverse) gear: The rotation direction of the transmission output shaft is opposite to that of the engine. N (Neutral) gear: The internal gears of the transmission are in a freewheeling state. D (Drive) gear: Automatically shifts between the lowest and highest gears. S (Sport) gear: This gear is often used when climbing slopes to provide additional power, but it increases fuel consumption. L (Low) gear: This gear is mainly used when descending slopes or long inclines, keeping the gear in the lowest position to utilize engine braking for safer downhill driving.
6
4
Share

Are there counterfeit Michelin tires?

There are counterfeit Michelin tires. Computer verification for authenticity: Genuine Michelin tires sold through official channels have anti-counterfeit labels on the tire's label paper. The certificate comes with a silver coating that can be scratched off to reveal a 16-digit code as per instructions. Visit Michelin China's official website, enter the retailer's ID number. Upon success, input the mobile phone number, license plate, and tire anti-counterfeit code to display the verification result. Identifying tire quality by appearance: Tire quality can be assessed by observing the tread pattern, color, and gloss. Generally, inferior retreaded tires are poorly processed, resulting in relatively shallow tread grooves. In terms of color, counterfeit retreaded tires appear overly bright and shiny, whereas genuine ones look darker. Retreaded tires tend to have dull colors and lackluster gloss.
12
2
Share

Where to Add Fuel Additive?

Fuel additive is added into the fuel tank. The purpose of adding fuel additive is to solve the carbon deposit problem in the fuel system of electronic injection vehicles, quickly restore the optimal working condition of the engine, and compensate for some defects of gasoline in certain properties, improving gasoline atomization, reducing vehicle wear, protecting the engine, and reducing particulate matter and harmful substances in exhaust emissions. Precautions for using fuel additive: Pay attention to purchasing branded fuel additive. Fuel additive is a high-threshold technical product with high costs, so there are many low-quality and counterfeit products on the market. Using counterfeit products not only fails to remove carbon deposits and maintain the engine but may also cause damage to the engine. Therefore, it is essential to purchase from official channels. Do not add excessive fuel additive; it should be used according to the standard. Excessive addition may increase carbon deposits in the combustion chamber and even cause engine knocking or detonation, worsening vehicle exhaust emissions. Method for adding fuel additive: It is best to add fuel additive before refueling the car. First, add the fuel additive into the fuel tank according to the recommended ratio, and then refuel. This way, the added fuel additive will fully dissolve under the impact of the fuel, ensuring a more uniform mixture of fuel additive and fuel.
12
1
Share

Can self-selected license plate numbers only be chosen from the published number segments?

Self-selected license plate numbers can only be chosen from the published number segments. The self-selection process on the Traffic Management 12123 platform is an internet-based random method, where each time 10 numbers are displayed, allowing you to choose the most satisfactory one from the 10 numbers and place it in the selection queue. Operations may vary by region, with a maximum of 5 attempts. After 5 attempts, you can have up to 5 pre-selected numbers for final confirmation. Relevant information about license plates is as follows: Introduction: License plates, commonly known as vehicle plates, refer to the plates mounted on the front and rear of a vehicle, displaying the vehicle's registration number, registration region, or other relevant information. Function: License plates serve as a numbering and information registration system for vehicles, primarily enabling identification of the vehicle's region of registration and facilitating access to the vehicle owner's details and registration information through the plate number.
3
5
Share

How many points are deducted for getting off the car without turning off the engine in Subject 3?

Getting off the car without turning off the engine in Subject 3 deducts 5 points. Below are the relevant details: Surrounding environment: Failing to walk around the car to inspect the vehicle's appearance and surrounding environment results in disqualification; Failing to observe the traffic behind before opening the car door results in disqualification. Insufficient air pressure: Starting the car with insufficient brake air pressure results in disqualification; Starting the car without fully closing the door results in disqualification; Before starting, failing to observe the interior and exterior rearview mirrors and not turning the head to observe the traffic behind results in disqualification; When starting the engine, if the gearshift lever is not in the neutral (parking) position, it results in disqualification; Starting the car without releasing the parking brake and failing to correct it promptly results in disqualification; Starting the car without releasing the parking brake but correcting it promptly deducts 10 points.
20
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.