Where is the battery of Wuling Zhiguang located?
3 Answers
The battery of Wuling Zhiguang is located under the co-driver's seat. You can see it after opening the co-driver's seat. The battery is also called the car battery, which is an important component of a car. This component is also a wearing part that needs to be replaced regularly. When the engine is not started, the battery supplies power to all the electronic devices in the car and is also responsible for starting the engine. The length, width, and height of Wuling Zhiguang are 3695mm, 1495mm, and 1860mm respectively, with a wheelbase of 2500mm. In terms of power, this car is equipped with a 1.2-liter naturally aspirated engine, with a maximum horsepower of 82, a maximum power of 60.3 kilowatts, and a maximum torque of 115 Newton meters.
I used to drive a Wuling Rongguang, and the battery was placed in a very noticeable position in the engine bay. Generally, you can find it on the front right side or under the driver's side by lifting the cover—it depends on the model and year. When checking, I always prioritize safety by disconnecting the negative terminal to avoid accidental short circuits, while also cleaning the terminals to prevent corrosion that might affect startup. If the car won't start, it's usually due to a dead battery. You can use a multimeter to measure the voltage—if it's below 12 volts, it's time to recharge or replace it. Wuling's design is quite reasonable, keeping the battery close to the heat source to avoid overheating, but remember to perform regular maintenance, such as checking the electrolyte level every six months to prevent drying out. I recommend that owners not just replace the battery and call it a day—keeping an eye on the charging system and starter motor condition can save a lot of trouble. If you can't find it, check the user manual's diagrams, which clearly mark the location to avoid mistakes.
In our repair experience, the battery placement of the Wuling Sunshine is typically standardized, mostly located in the front left of the engine compartment near the fuse box or fan area, while a few low-end versions may have it under the driver's seat. The advantage of placing it in the engine bay is easy heat dissipation and maintenance, reducing the risk of circuit overheating, but be mindful of poor contact issues caused by wire aging or water ingress. During inspection, I recommend disconnecting the power cable to measure the voltage, with a normal value around 12.6 volts. If it's too low, check if the alternator is undercharging. Safety tip: Wear insulated gloves when working and avoid touching the positive terminal to prevent sparks from short circuits. The location is easy to identify, but if unclear, checking the vehicle's VIN code against the manufacturer's data is the most reliable method.
