Where is the battery located in the Wuling Zhiguang?

Where to Place the Gecko Emblem on a Car?

The gecko emblem is typically placed on the rear part of the car. Below is an introduction to related emblem placement: 1. Emblem Types: Compulsory Traffic Insurance Emblem, Vehicle Annual Inspection Certification Emblem, and Environmental Inspection Certification Emblem. 2. Placement Location: These emblems should all be affixed to the upper right corner of the car's front windshield. 3. Validity Period: These emblems are valid for one year and need to be replaced annually. Below is extended information about tire pressure monitoring system malfunctions after changing rims: 1. Direct TPMS: Direct Tire Pressure Monitoring Systems use pressure sensors installed on the valve stem or inside the tire to measure tire pressure. When changing rims, if the sensor is on the rim's valve stem, it must be removed and installed on the new rim, followed by resetting the tire pressure monitoring system. 2. Indirect TPMS: Indirect Tire Pressure Monitoring Systems calculate tire pressure by measuring the tire's rolling radius through the computer. Changing rims of the same size has no effect on this system. 3. Hybrid TPMS: Hybrid TPMS also uses sensors for monitoring. After changing rims, the tire pressure sensors must be transferred to the new rims and the system reset.

15

3

Share

What are the characteristics of temperature sensors in automotive electronic control systems?

The characteristics of temperature sensors in automotive electronic control systems are that the higher the temperature at the measurement point, the lower the resistance value of the sensor, and the lower the output voltage signal. Related knowledge about temperature sensors: 1. Composition: Most temperature sensors in automobiles are negative temperature coefficient thermistors. 2. Classification: intake air temperature sensor, coolant temperature sensor, transmission oil temperature sensor, clutch temperature sensor G509, temperature sensor on the air compressor, and air conditioning temperature sensor. 3. Partial fault analysis: The higher the intake air temperature sensor temperature, the richer the air-fuel mixture. A short circuit or poor grounding of the sensor can cause the mixture to be too lean, leading to difficulty in starting. If the engine coolant temperature sensor is short-circuited, the data stream will show a high temperature above 100℃, causing the mixture to be too lean and preventing startup. If the sensor is open-circuited or the grounding wire has poor contact, the data stream will show a low temperature below -30℃, causing the mixture to be too rich, resulting in black smoke from the exhaust pipe, etc.

5

Share

What is the normal tire pressure for cars running on highways?

When driving on highways, the normal tire pressure for cars is 2.5 kilograms per cubic centimeter. Below is an introduction to tire pressure-related information: 1. Function of low-pressure tires: Low-pressure tires are mainly used for private cars. 2. Function of high-pressure tires: High-pressure tires are mainly used for large trucks or passenger vehicles. Below are the differences between high-pressure and low-pressure tires: 1. In terms of nature: Low-pressure tires are hollow pneumatic tires; due to the development of skeleton materials and tire design, the load capacity of high-pressure tires has gradually increased, and the pressure has correspondingly risen, yet the cushioning performance remains similar to that of low-pressure tires of the same specifications. 2. In terms of appearance: Low-pressure tires have good elasticity and a wide cross-section, with a large contact area with the road. 3. In terms of tire pressure: The inflation pressure of high-pressure tires is 0.5~0.7 MPa; the inflation pressure of low-pressure tires is 0.15~0.45 MPa.

3

Share

Which is more severe, impoundment or temporary suspension of a driver's license?

The severity of impoundment and temporary suspension of a driver's license depends on the final penalty decision. Below is a detailed introduction to impoundment and temporary suspension: 1. Impoundment: Impoundment is a compulsory measure. During on-site law enforcement, if traffic police believe that a temporary suspension or revocation of the driver's license should be imposed on the violator, they may first impound the driver's license and issue a compulsory measures certificate on the spot. 2. Temporary suspension: Temporary suspension is an administrative penalty, usually not imposed on the spot. It requires investigation through general procedures before an administrative penalty decision is issued. 3. Differences: The legal consequences of impoundment and temporary suspension are also different. Driving a motor vehicle during the temporary suspension period is treated as 'driving without a license,' with a fine of 2000 yuan and possible detention of up to fifteen days. After the driver's license is impounded, the driver must report to the traffic management department of the public security authority within fifteen days for processing. If the driver fails to report without a valid reason, the driver's license will be revoked. Driving during the impoundment period incurs a fine of 200 yuan.

18

0

Share

Why doesn't the car move when it's in gear?

Here are the reasons why a car doesn't move when in gear: 1. Check all parts: According to driving standards, check if the vehicle's handbrake is fully released. If there's no issue, you need to check for comprehensive functional faults involving the clutch, transmission, and drive axle. First determine the faulty part - you can start by checking both wheels and judge the fault based on actual conditions. 2. Diagnostic sequence: When a car doesn't move in gear, the diagnostic sequence should be from the drive wheels forward through the rear axle to the driveshaft, then to the transmission, and finally to the clutch. If the driveshaft rotates but the car doesn't move forward, the fault lies in the rear axle. If you lift the rear axle and rotate one rear wheel while the other rotates in reverse without the driveshaft turning, it indicates all rivets on the driven bevel gear are sheared. 3. Check the transmission: If the car is in gear but the driveshaft doesn't rotate when starting, the fault is in the transmission. Remove the transmission cover to check if the shift fork is broken or if the guide block fixing screws are loose. 4. Clutch issues: If the driveshaft doesn't rotate in any gear, the fault is in the clutch. Check if the clutch is severely slipping.

8

0

Share

What does an automatic transmission car mean?

An automatic transmission, as the name suggests, means that the driver does not need to manually shift gears. The vehicle will automatically select the appropriate gear based on the driving speed and traffic conditions. Generally, an automatic transmission car has six gear positions, arranged from top to bottom as: P, R, N, D, S, L. The P gear is the parking gear, used for long-term parking of the vehicle; the R gear is the reverse gear, engaged when the vehicle is moving backward; the N gear is the neutral gear, used when the vehicle is parked for a short time without turning off the engine; the D gear is the drive gear; the S gear is the sport mode, making the vehicle more dynamic; the L gear is the low gear. When starting the car, press the brake, shift the gear lever to D, release the handbrake, and then slowly accelerate to move the car forward. During normal driving, the driver does not need to shift to other gears, as the car will automatically switch between gears 1-4 based on the speed. Some advanced cars may have D2 and D3 gears. Shifting to D2 or D3 limits the transmission to gears 2 or 3, allowing the vehicle to maintain lower gears and deliver more power under special road conditions.

8

1

Share

Where is the battery located in the Wuling Zhiguang?

Where to Place the Gecko Emblem on a Car?

What are the characteristics of temperature sensors in automotive electronic control systems?

What is the normal tire pressure for cars running on highways?

Which is more severe, impoundment or temporary suspension of a driver's license?

Why doesn't the car move when it's in gear?

What does an automatic transmission car mean?

Where to go for the physical examination required for a driver's license?

What are the safety precautions for passenger vehicle operation?

What is the N gear?

Is Engine Maintenance Fluid Useful?