Where is the Audi Fragrance System Located?

1 Answers
DonovanRose
07/29/25 11:04pm
Audi's fragrance system activates automatically without manual operation. Here is additional information: 1. Introduction: Car fragrance, also known as in-car fragrance, utilizes the natural evaporation diffusion method. Plant essential oils are added to a finely crafted crystal car fragrance bottle, which is then inserted into the cigarette lighter for use. This allows the fragrance to slowly and naturally diffuse throughout the vehicle, creating an aromatic environment, sterilizing and deodorizing, and refreshing the mind. 2. Principle: The fragrance in the system is emitted from non-woven fabric soaked in fragrance oil, which is fixed inside the fragrance box to ensure the oil does not spill into the car. The compact and convenient fragrance box can be easily installed and removed in the glove compartment of the passenger seat, with the capacity to hold up to two different fragrance boxes.
Was this review help?
16
5
Share
More Forum Discussions

What is the reason for the airbag light in the Lavida being on?

The reason is that there may be a malfunction in the airbag system. Here are the relevant details about the airbag: 1. Composition: It mainly consists of an airbag sensor, a collision airbag, and an electronic control device. The driver-side collision airbag is installed in the steering wheel, while the passenger-side collision airbag is generally installed on the dashboard. 2. Principle: When a collision occurs while the car is in motion, the airbag sensor first receives the impact signal. If the impact reaches the specified intensity, the sensor activates and sends a signal to the electronic controller. Upon receiving the signal, the electronic controller compares it with its stored data. If the conditions for airbag deployment are met, the driving circuit sends a start signal to the gas generator in the airbag assembly. Once the gas generator receives the signal, it ignites the gas-producing agent, generating a large amount of gas. This gas is filtered and cooled before entering the airbag, causing the airbag to rapidly expand and break through the padding in an extremely short time.
6
4
Share

Is it normal for the front tire pressure of the X-Trail to be 230 and the rear tire pressure to be 210?

The front tire pressure of the X-Trail being 230 and the rear tire pressure being 210 is not normal, as the rear tire pressure is slightly low. The standard tire pressure for the Nissan X-Trail ranges between 2.2-2.5 bar. Solutions for insufficient tire pressure: If no damage is visible, simply inflate the tires to the normal pressure and reset the tire pressure system. If a puncture is found upon inspection, promptly drive to a tire shop for repair and then reinflate the tire. If the tire pressure warning reappears some time after inflation without any punctures, it might be due to air leakage caused by a deformed wheel rim. It is recommended to check the wheel rim and replace it if necessary. There are three common methods for tire pressure monitoring: Direct Tire Pressure Monitoring: This system uses pressure sensors installed in each tire to directly measure the tire pressure. The pressure data is transmitted wirelessly from inside the tire to a central receiver module, which then displays the pressure for each tire. The system automatically alerts when the tire pressure is too low or if there is a leak. Indirect Tire Pressure Monitoring: When the pressure in a tire decreases, the vehicle's weight causes the rolling radius of that tire to become smaller, making it rotate faster than the other wheels. By comparing the rotational speed differences between tires, the system monitors the tire pressure. Essentially, the indirect tire pressure warning system relies on calculating the rolling radius of the tires to monitor pressure. Tire Pressure Monitoring System (TPMS) Introduction: This system combines the advantages of both the above systems. It equips direct sensors in two diagonally opposite tires and includes a four-wheel indirect system. Compared to a full direct system, this hybrid approach reduces costs and overcomes the limitation of indirect systems, which cannot detect simultaneous low pressure in multiple tires. However, it still cannot provide real-time pressure data for all four tires as effectively as a direct system.
2
3
Share

How to Reset the Maintenance Light on an Old Bora?

Turn off the ignition, press and hold the maintenance light reset button, then turn on the ignition. Release the reset button and press button A to complete the reset. Below is an introduction to the Bora: 1. Powertrain: Equipped with 1.6L and 1.4TSI engines, paired with a 5-speed manual transmission, 6-speed Tiptronic automatic manual transmission, and 7-speed DSG dual-clutch automatic transmission. 2. Features: Multifunction digital display instrument panel; voice navigation system integrating DVD playback, navigation, radio, and Bluetooth; cruise control system; pedestrian protection function; fourth-generation online electronic anti-theft system.
16
0
Share

What is the wading depth of the Range Rover Sport?

The wading depth of the Range Rover Sport is 850mm. The wading depth of the Range Rover Sport is determined by the height of the vehicle's chassis, which is the ground clearance listed in the model's parameter configuration table. Generally, the greater the ground clearance, the higher the chassis, and the higher the safety factor when driving through waterlogged roads. Therefore, in terms of safe wading depth, the advantages of off-road vehicles and SUVs are obvious. However, for most compact and small vehicles with low chassis, the position of the vehicle's air intake should be used as a benchmark when passing through waterlogged roads. If the air intake of the Range Rover Sport is below the water level during wading, water will be sucked into the engine's cylinders. Since water cannot be compressed like air, it will cause severe damage to the engine's mechanical components (such as connecting rods, pistons, crankshafts, etc.). Therefore, the wading depth should not exceed the height of the engine's air intake. The height of the engine's air intake, and thus the maximum wading depth, can also be increased by installing a snorkel. If wading is unavoidable, the following safe and correct operations should be performed: Before driving through water, always turn off the auto start-stop function to prevent the vehicle from automatically restarting after stalling in the water, which could cause severe engine damage due to water intake. Assess the underwater road conditions based on the passage of vehicles ahead and choose an appropriate entry point. Observe the path taken by other vehicles and follow their tracks at low speed, avoiding sudden acceleration or deceleration. On roads prone to water accumulation, observe warning water level markers, trees, and reference points like the wheels and doors of other vehicles to estimate the water depth before deciding whether to proceed. Be aware of your vehicle's safe wading depth. If the water depth exceeds half the height of the tires or the engine's air intake, do not proceed and choose an alternative route.
17
1
Share

What are the symptoms of small valve clearance in motorcycles?

The symptoms of small valve clearance in motorcycles are as follows: 1. Valve noise: The most common symptom of excessive valve clearance is abnormal noise, which mainly comes from the collision between the rocker arm and the valve. 2. Reduced power: The main reason for the decrease in power after excessive valve clearance is the reduction in intake and exhaust volume, primarily because the valve opening becomes smaller, thereby affecting the engine's intake and exhaust volume. 3. Unexpected damage: If the valve clearance is too large and not adjusted in time, for pushrod engines, there is a possibility of pushrod detachment. This is because the pushrod relies on the upper and lower rocker arms for positioning. If the clearance is too large, the pushrod may shift, leading to detachment.
18
4
Share

How often should Castrol EDGE engine oil be changed?

Castrol EDGE is a fully synthetic engine oil, and fully synthetic oils can typically be changed every 10,000 kilometers or once a year. However, the actual interval depends on the vehicle's driving conditions. If the vehicle frequently operates in heavy traffic congestion, it's recommended to change the oil 1,000 kilometers earlier, as engine oil continues to lubricate the engine even during idling. Engine oil, also known as motor oil or engine lubricant, is a substance enhanced with additives in base oil, primarily containing anti-wear additives, detergents, dispersants, and multi-grade viscosity index improvers. Engine oil is used for lubricating internal combustion engines. Its main functions are to reduce friction and wear on moving parts, and to remove sludge and varnish from the engine.
3
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.