Where is the antenna located on the Audi Q3?

1 Answers
DeMax
07/29/25 10:52pm
Audi Q3's antenna is positioned at the center of the rear part of the roof. Introduction to Car Antennas: A car antenna is a device that intercepts high-frequency radio waves transmitted by broadcasting stations and delivers them to the car's radio, mobile phone, or radio navigation equipment receiver for demodulating the carrier wave. Characteristics of Car Antennas: The single-axis antenna, which serves as the foundation of car antennas, should ideally be 1/4 the wavelength of the received radio waves. However, the length of antennas that can be installed on vehicles is typically around 1 meter. Considering the conditions under which cars operate with arbitrary movements, except for devices like ETC used in specific locations, general car antennas should be non-directional.
Was this review help?
12
4
Share
More Forum Discussions

Can a car cover provide sun protection?

Car covers can indeed provide sun protection. The functions of a car cover include: 1. Environmental protection, rain protection, sand protection, dust protection, frost protection, heat insulation, cooling, and anti-peeping effects. 2. It can also block UV radiation and reduce the evaporation of harmful substances inside the car. 3. Additionally, it can prevent aging of interior leather, dashboard, and other components, thereby extending the vehicle's lifespan. Additional information: 1. Car covers do offer some sun protection, though installation can be somewhat cumbersome. 2. However, using a cover with an aluminum film surface can provide better heat insulation. 3. Car covers not only protect against sunlight but also prevent rainwater corrosion.
16
4
Share

Can ETC be installed without sticking to the car window?

ETC does not have to be stuck to the car window, as long as it does not obstruct the driver's view and can be recognized by the toll station equipment. The installation steps for ETC are: 1. Remove the double-sided adhesive plastic film on the back of the ETC device and stick it to a suitable position; 2. Press firmly for about 10 seconds after sticking; 3. Insert the card into the ETC device and repeatedly insert and remove it several times. ETC is an Electronic Toll Collection system, which is an automatic toll collection for highways or bridges. It is an on-board electronic tag installed on the vehicle's windshield, enabling dedicated short-range communication with the microwave antenna in the ETC lane at toll stations.
3
4
Share

Can National 5 vehicles still be registered?

Whether National 5 vehicles can still be registered depends on the region, as the implementation time of the National 6 emission standard varies across different areas in the country. The details are as follows: Introduction: The National Fifth Stage Motor Vehicle Pollutant Emission Standard, abbreviated as the 'National 5 Standard,' has an emission control level equivalent to the European Union's fifth stage emission standard currently in implementation. The EU has been enforcing this standard since 2009, which imposes stricter limits on nitrogen oxides, hydrocarbons, carbon monoxide, and particulate matter emitted by motor vehicles. From National 1 to National 4, each upgrade in the standard reduces vehicle pollution by 30% to 50%.
13
1
Share

What to Do If Changan's First Maintenance Exceeds Three Months?

If the time limit is exceeded, the cost of the vehicle's first maintenance will be borne by the owner. The 4S store's after-sales service will not perform the complimentary maintenance items, so it is important to pay attention to the first maintenance time and mileage after purchasing the vehicle. After purchasing the vehicle, you can consult the staff at the 4S store. During the subsequent use of the vehicle, be sure to pay attention to the time, and it can only be done in advance. If the mileage reaches 5,000 kilometers, you can still avoid bearing the first maintenance cost and enjoy the maintenance items. The time and mileage are determined by whichever comes first.
17
0
Share

What Causes Engine Cylinder Pounding?

Engine cylinder pounding can be caused by broken connecting rod bolts or incorrect operation. Below is a detailed explanation of the causes of engine cylinder pounding: Broken Connecting Rod Bolts: When connecting rod bolts break or connecting rods snap, they can damage the cylinder block. A fractured piston pin or piston separation (where the piston head detaches from the skirt) can also damage the cylinder block. Additionally, a valve dropping into the cylinder or a fracture in the upper shoulder of the cylinder liner may lead to cylinder pounding. Incorrect Operation: Improper operation, such as revving the engine aggressively before starting or shutting it down, can cause unstable diesel engine speeds and worsen lubrication conditions. Over time, this may lead to fatigue damage of components, resulting in cylinder pounding.
2
1
Share

Is the Honda City compliant with China 6 emission standards?

Honda City is not compliant with China 6 emission standards, but rather with China 5. The Honda City is a compact 4-door, 5-seater sedan with body dimensions of 4450mm in length, 1695mm in width, and 1477mm in height, a wheelbase of 2600mm, and a fuel tank capacity of 40 liters. It is equipped with a 1.5L naturally aspirated engine and a 5-speed manual transmission, delivering a maximum power of 96 kW at 6600 rpm and a maximum torque of 155 Nm at 4600 rpm. The drivetrain is front-wheel drive, with a MacPherson strut independent suspension at the front and a torsion beam non-independent suspension at the rear.
9
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.