Where is the airbag module of the Roewe i5 located?
2 Answers
The airbag module of the Roewe i5 should be installed under the center console inside the vehicle, connected to the vehicle's computer or engine ignition device. Below is the relevant introduction: 1. Airbag Module: The airbag module is a device that inflates to protect occupants before a secondary collision occurs during a crash. It consists of an integrated airbag module comprising the airbag and inflator (gas generator), a collision sensor system that detects impacts and sends deployment commands to the airbag module, and wiring harnesses that transmit signals from the sensors. 2. Fault Diagnosis Function: It detects wiring harness breaks, short circuits, the operational status of each sensor, and any system-wide faults, alerting users through warning lights or other forms to prompt inspection and repair.
A couple of days ago, I just helped my friend inspect his Roewe i5. The airbag module is mainly hidden in the central tunnel area. You can feel it by running your hand backward from the gearshift lever—it's located right under the center console on the chassis. You'll need to remove the interior trim panel to see it. This small silver square box is connected to all the airbag sensors in the car, so you must never tamper with it carelessly. Last time, I encountered an owner who fiddled with it recklessly, causing the airbag to suddenly deploy and leaving his face swollen. So, if you really need to perform maintenance, remember three key points: first, disconnect the negative terminal of the battery and wait ten minutes for discharge; second, never power on the system during disassembly or installation; and finally, you must reset the system using a diagnostic computer. If you're unsure, just go to the 4S shop—their professional equipment ensures more accurate checks.
