Where is the air intake of the Nissan Patrol located?

What are the trunk dimensions of the Odyssey?

Trunk interior length: 560mm, width: 1190mm, height: 790mm. Items that can be placed in the trunk: The Odyssey's trunk can accommodate some daily items that are not very large in volume. It also comes with a partition board that serves to protect privacy, and there is a storage compartment under the floor for tools. How to open the trunk: The Odyssey's trunk has an electric switch. The driver can open the trunk for others using the door panel button without having to get out of the car. When the engine is off, pressing the button once will open the trunk. When the engine is running, you need to hold the button for 3 seconds to open it. If the owner wants to open it manually, they can simply insert and turn the trunk key to open it.

11

1

Share

Why does the Passat New Lingyu make noise when turning the steering wheel?

The Passat New Lingyu makes noise when turning the steering wheel due to insufficient lubrication of the steering column, increased friction, low power steering fluid, potential issues with the universal joint, aging and hardening of the chassis suspension stabilizer link bushings, or a faulty plane bearing. Solution: If the steering tie rod end is aged or has excessive play, replace the steering tie rod end and perform a wheel alignment. Solution: If the steering gear boot is leaking oil, replace the boot or reapply grease. Solution: If the steering gear is malfunctioning, possibly due to excessive gear clearance, replace the steering gear. Solution: If the power steering belt is improperly tensioned or aged, adjust the belt tension or replace the belt.

19

0

Share

What are the reasons for the Cayenne tire pressure warning?

Cayenne tire pressure warning may be caused by abnormal tire pressure, unreset tire pressure monitoring, or damaged tire pressure sensors. Abnormal tire pressure: Generally, the warning will activate if the pressure is below 1.8bar or exceeds 3.0bar. In this case, tire inspection and pressure adjustment are required. Tire pressure monitoring not reset: After inflating the tires, if the tire pressure monitoring system is not reset in time, it will still record the previous data, causing the tire pressure monitoring indicator to light up. Simply performing a tire pressure reset will resolve this issue. Damaged tire pressure sensor: The tire pressure sensor, used to monitor tire pressure, is installed inside the tire and connected to the tire inflation valve. If the sensor is damaged due to impact while driving, it will also trigger the tire pressure warning light. For sensor damage, the only solution is to replace it with a new part.

15

2

Share

How Bright Are Audi's Headlights?

Audi's headlights are very bright, with the low beams being as bright as other vehicles' high beams. Reasons for the brightness of Audi headlights: Audi headlights are matrix headlights, which makes them brighter. Introduction to matrix headlights: They are highly intelligent, with high brightness and smart features. The headlights can detect pedestrians and vehicles. They intelligently adjust the beam angle when detecting pedestrians, only illuminating the lower part of the body to avoid dazzling the pedestrian's eyes while ensuring the driver can see them. They also detect vehicles to reduce accidents. The intelligent automatic headlights can identify oncoming and parked vehicles. If an oncoming vehicle is detected, the headlights automatically adjust the beam angle to avoid shining into the eyes of the driver in the opposite lane.

11

2

Share

What is the difference between wet and dry transmissions?

The differences between wet and dry transmissions are as follows: 1. Different in transmission efficiency: In terms of clutch structure, the wet clutch has a more complex structure. A more complex structure means higher energy loss, resulting in lower transmission efficiency for wet dual-clutch transmissions, which occupy more engine power. With other factors remaining unchanged, this also means higher fuel consumption. 2. Response speed: The dry clutch transmits power through direct contact of metal plates, making power transmission more direct. When the metal plates are pressed tightly, the transmission ratio increases, and the effect is immediate and significant. On the other hand, the wet clutch uses oil as an "intermediary," requiring a process from the acceleration of the driving plate to the increase in oil centrifugal force, and then to the acceleration of the driven plate. This additional step results in slightly slower response speed. 3. Torque capacity: The metal friction plates of a dry clutch cannot withstand too much torque. If subjected to excessive stress impact, the friction plates can easily be damaged. Therefore, dry clutches can only be used in small-displacement, low-torque output models. In some cases, to adapt to dry clutches, certain models deliberately limit the engine's torque output in low gears to protect the transmission clutch. Wet clutches do not have such issues at all. They can handle everything from 1.5L displacement, 200N˙m family cars to 6.0L displacement, over 1000N˙m supercars, and even large diesel engines and electric motors with torque exceeding tens of thousands of N˙m, where wet clutches are commonly used.

20

3

Share

What Causes the Transmission Noise in the Envision?

Transmission noise can be caused by the following reasons: Wear and damage of bearings: When bearings wear out, the gap increases, and the fitting accuracy decreases. When bearings are damaged, abnormal noise occurs as they cannot operate normally, potentially leading to damage of transmission components and exacerbating the issue. This can also be caused by the wear of transmission components or the use of replacement parts with excessively low precision, such as gear wear or mismatched gear clearance. Insufficient or overly viscous lubrication oil leading to poor lubrication: In such cases, the corresponding lubricating oil (grease) should be replaced; otherwise, it will accelerate transmission wear and shorten its service life. Loose bolts on the transmission housing (end cover): Vibrations during operation can loosen bolts, so regular inspections are necessary.

19

1

Share

Where is the air intake of the Nissan Patrol located?

What are the trunk dimensions of the Odyssey?

Why does the Passat New Lingyu make noise when turning the steering wheel?

What are the reasons for the Cayenne tire pressure warning?

How Bright Are Audi's Headlights?

What is the difference between wet and dry transmissions?

What Causes the Transmission Noise in the Envision?

How Long Does the Fista Dry Dual Clutch Last?

How many more years can a National II emission standard vehicle be driven?

What is the standard tire pressure for the Honda Fit?

What is the Difference Between Big Benz and Small Benz?