Where is the air intake of the Emgrand located?
3 Answers
Geely Emgrand's air intake is located in the engine compartment. Introduction to air intake: According to shape and position, it can be divided into leading-edge intake, funnel-shaped intake (or scoop intake), skin intake, internal intake, etc. Icing conditions of the intake duct: Supercooled water exists, or the air humidity is high and the temperature is above 0 degrees Celsius. The air pressure entering the intake duct is very low during the aircraft's taxiing, takeoff, and climbing phases, so the temperature can drop to the point where condensation or sublimation occurs. Therefore, icing may form inside the intake duct, narrowing the passage and affecting air intake.
As a long-time Emgrand owner, I can tell you the air intake is located at the front of the vehicle, specifically beneath the bumper and grille area, slightly offset to the left near the radiator. Positioned at the lower front section of the engine bay, this low placement is designed to draw in cooler air from the vehicle's frontal area to enhance combustion efficiency. Through daily driving, I've noticed it's prone to dust accumulation or clogging, especially on dusty roads, which reduces airflow and impacts engine performance. Regular inspection and cleaning are crucial – simply pop the hood to access it, then gently brush with a soft-bristle tool or use compressed air to clear debris. Avoid letting leaves or foreign objects block it entirely. Memorizing its location facilitates maintenance, as prolonged neglect may lead to increased fuel consumption or power loss. Frequent drivers should pay extra attention to this as preventive maintenance against potential malfunctions.
From an automotive aerodynamics perspective, I've observed that the Emgrand's air intake layout is exceptionally clever. It's positioned in the lower rear section of the front grille, closely adjacent to the radiator module. This design effectively captures fresh airflow during driving while preventing hot air intake from the engine compartment that could reduce efficiency. Upon opening the hood, you can see a plastic duct leading to the air filter box, typically located on the inner side of the grille near the driver's side. I believe this design achieves an excellent balance between airflow efficiency and dust protection, which deserves recognition. When performing DIY cleaning, be careful not to damage any wiring harnesses as the components are somewhat concealed. Understanding these details can also serve as reference for modifications - such as adding protective mesh against stone impacts - though the OEM design is already quite rational, so avoid unnecessary alterations that might void the warranty.
