
The air filter element of the Haifuxing is located under the glove box on the passenger side. Cleaning method: If the filter element is dirty, you can clean it by blowing compressed air from the opposite side. Operation method: Hold the air gun about 5 cm away from the filter element and blow at a pressure of 500 kPa for approximately 2 minutes. The air filter element is very prone to dust accumulation, so use compressed air to remove loose dust. Never wash it with water, as this can easily damage it. The Haifuxing is a compact car launched by FAW Haima, with dimensions of 4464mm in length, 1695mm in width, and 1425mm in height, and a wheelbase of 2610mm. The Haifuxing is equipped with a 1.5L naturally aspirated engine, delivering a maximum horsepower of 111ps and a maximum torque of 147nm, paired with a 5-speed manual transmission.

I've been into cars for decades and have handled all kinds of models. The air filter location of the Haima Family (Haima3) is quite intuitive—it's right in the engine bay. Just pop open the front hood, and you'll spot that rectangular plastic box near the front intake. That's the air filter housing. Open the lid, and the filter is right inside. I often change it myself—it's straightforward: remove the clips or small screws, take out the old filter, and slot in a new one of the exact same size. Regular replacement is crucial; I recommend doing it every 8,000 to 10,000 kilometers to prevent engine carbon buildup and improve fuel efficiency. Save some money by DIY—brand filters cost just a few dozen yuan. While you're at it, check the intake piping for leaks to extend engine life—killing multiple birds with one stone. The placement is well-designed, so even beginners won't find it too complicated.

I've helped friends repair many cars before, and the Haima Family was no exception. Its air filter is located in the engine compartment - just lift the hood and you'll spot that square box fixed behind the front grille, with the filter element inside. The removal is quite straightforward; I usually loosen a few screws with a wrench or simply unclip the cover. Replacing it with a new filter improves airflow and prevents clogging that could affect idle. I make it a habit to check during every maintenance cycle - easy to locate and simple to service, just using standard filters. Be careful not to install it backwards, as that reduces dust collection efficiency. While you're at it, inspect the connecting tube for cracks and clear any debris to prevent minor issues from becoming major repairs. The whole process takes just minutes and costs very little.

When I first got my Haifuxing, I knew nothing about it. Later, I figured out where the air filter is located. It's at the front of the engine compartment - just open the hood and you'll see a plastic box containing the filter. To replace it, simply press the clips to open the box, but don't use too much force to avoid damage. I change it every six months, and the acceleration becomes noticeably smoother afterwards. The location is straightforward, and buying the filter myself saves half the cost compared to going to a shop. Just remember to measure the size correctly to avoid buying the wrong one, and make sure it's installed in the right orientation.


