Where is the air conditioning sensor located on the old Chery Tiggo 3?
1 Answers
The air conditioning sensor on the old Chery Tiggo 3 is located at the air vent. The air conditioning sensor is a detection device that can sense the temperature of the measured environment and convert the sensed information into electrical signals or other required forms of information output according to a certain pattern, to meet the requirements of information transmission, processing, storage, display, recording, and control. Additional information: The locations of other sensors on the Chery Tiggo 3 are as follows: 1. Oxygen sensor: The oxygen sensor is installed on the exhaust pipe and is used to monitor the post-combustion gases to determine whether the engine combustion is sufficient and whether the mixture is too lean or too rich. 2. Wheel speed sensor: The wheel speed sensor is generally located on the front wheel brake disc. It primarily collects the car's speed to determine if there are signs of skidding. Therefore, a dedicated sensor is used to collect the wheel speed, usually installed on the hub of each wheel. If the sensor is damaged, the ABS will fail. 3. Water temperature sensor: The water temperature sensor is usually installed near the thermostat. It converts the coolant temperature into an electrical signal. When the temperature is low, it increases the fuel injection or advances the ignition timing angle. When the temperature is high, it prevents detonation and delays the ignition timing angle. 4. Intake pressure sensor: Generally installed near the throttle valve, the intake pressure sensor, as the name suggests, senses a series of resistance and pressure changes with different engine speeds and loads, converting them into voltage signals for the ECU to adjust fuel injection and ignition timing angles. If it malfunctions, it can cause difficulties in ignition, unstable idle speed, and lack of acceleration power.
