Where is the air conditioning filter located in the Touareg?

1 Answers
SanAvery
07/30/25 9:23am
The air conditioning filter in the Touareg is located behind the glove box. To replace the air conditioning filter in the Touareg, follow these steps: 1. Remove the glove box and take off the lower panel beneath it. Gently pull the panel, as there is a connection wire for the footwell light behind it. Remember to disconnect the footwell light wire when removing the panel. 2. Remove the air filter cover by pressing the clips on both sides to release it. 3. Take off the air filter cover, remove the old air filter, and replace it with a new one. 4. Reinstall the cover and panel, paying special attention to reconnecting the footwell light wire.
Was this review help?
15
3
Share
More Forum Discussions

Where is the auxiliary battery of Mercedes-Benz W212 located?

The auxiliary battery of Mercedes-Benz W212 is located on the right side of the trunk. Function of the battery: The battery is an important component of a car, responsible for powering all electronic devices in the vehicle and also for starting the engine. Lifespan of the car battery: It is typically 3 to 4 years, but many car batteries fail before reaching this lifespan due to incorrect usage habits of the owners. Avoid sitting in the car for extended periods using electronic devices without starting the engine. In winter, try to avoid parking the car outside overnight. The low outdoor temperatures in winter can reduce the battery's lifespan.
2
4
Share

Which Parts Do the Handbrake and Footbrake Control Respectively?

The handbrake of a vehicle controls the two rear wheels. By braking these two wheels, it prevents the vehicle from rolling when stationary or waiting at a red light. The footbrake controls the braking of all four wheels, allowing the driver to press the footbrake pedal in emergency situations to smoothly decelerate the vehicle. Since it involves braking all four wheels, there is no risk of fishtailing or uneven braking during deceleration. Differences in the usage nature of the two brakes: The handbrake is the vehicle's parking brake system, while the footbrake is the vehicle's service brake system. The handbrake uses a steel cable to pull the brake calipers of the rear wheels, thereby braking the vehicle. The footbrake operates via a hydraulic brake pump, transmitting pressure through pipelines to the brake discs of all four wheels, enabling the vehicle to decelerate or come to a stop. Correct usage methods for the handbrake and footbrake: Handbrake usage method: Pull the handbrake until the rear wheels lock, then lift it 1-2 notches further to ensure the car does not slip. Footbrake usage method: Parking on flat ground: After the vehicle stops, press the brake, shift the gear to P, then press the footbrake and release the brake. Parking on a slope: After the vehicle stops, press the brake, first press the footbrake, then shift to P to prevent the vehicle from rolling. Precautions when using the handbrake and footbrake: When using the handbrake, avoid pulling it too hard every time, as excessive or prolonged stretching of the metal can accelerate deformation, reducing braking effectiveness. When using the footbrake, also avoid pressing too hard, as excessive force can cause the footbrake to be pressed too deeply, accelerating wear or even breakage of the handbrake cable.
3
2
Share

Is it necessary to replace the recalled Mercedes airbags?

It is necessary to replace the recalled Mercedes airbags. How airbags work: While the car is in motion, the sensor system continuously sends speed change information to the control unit, which analyzes and evaluates this data. If the measured acceleration, rate of speed change, or other values exceed predetermined thresholds, the control unit sends an ignition command to the gas generator or the sensor directly controls ignition. Upon ignition, an explosive reaction occurs, generating N2 or releasing compressed gas from a storage tank to inflate the airbag. When occupants come into contact with the airbag, the damping effect of the airbag's exhaust holes absorbs the collision energy, protecting the occupants. Meaning of the Mercedes airbag warning light: If the light stays on without flashing when the ignition switch is turned on, if the light flashes 7 to 9 times and then stays on when the ignition switch is turned on, if the light comes on while the engine is running, if the light does not come on at any time, or if the light does not stay on steadily during engine startup.
11
3
Share

What does Honda EK3 throttle body matching mean?

Honda throttle body matching refers to writing the actual throttle data into the ECU. Causes of high idle speed and starting difficulties: Check the ECU for any fault codes, clean the throttle body, add a bottle of fuel system cleaner, replace the fuel filter, and drive at high speed for 30 kilometers. Observe if the situation improves. Solutions: Check if the fuel pump and pressure regulator meet standard pressure specifications, inspect the spark plugs and try replacing them with a new set, check for ignition coil and spark plug wire leakage, and inspect for carbon buildup in the intake system. EK3 Engine: The EK3 is equipped with a standard 1.5L SOHC D15A engine producing only 97 horsepower.
1
2
Share

What is the model of the high beam for Geely Emgrand EC718?

The high beam for Geely Emgrand EC718 uses H7 model bulbs. Bulb recommendations: You can use Philips bulbs for better quality, with upgraded versions like SilverVision and X-tremeVision available for use and selection. How the high beam of Geely Emgrand EC718 works: The intensity of the light is adjusted based on the distance of the filament. The high beam is focused at its focal point, emitting light that is parallel and more concentrated, providing greater brightness and the ability to illuminate distant and high objects. The low beam is positioned beyond its focal point (between 1 and 2 times the focal distance), emitting light in a divergent pattern, which can illuminate a larger area of nearby objects.
13
0
Share

Is the Baojun 510 Seat Cushion Size Suitable?

Baojun 510 seat cushion size is suitable. Official dimensions of the Baojun 510 trunk: The regular volume of the Baojun 510 trunk is 318 liters, with a length of 1030 mm, width of 960 mm, and height of 820 mm. The rear seats of the Baojun 510 can be folded flat, expanding the trunk volume to 1210 liters. Installation steps for Baojun 510 car seat cushions: Check if all accessories are complete; full set of seat cushions; black card trays, at least 8 per set; metal hooks, at least 8 per set; install the front seats; lay the seat cushion flat on the driver's seat. Pass the waist card tray through the gap between the original seat back and cushion; for the headrest part, connect the buckles properly. Finally, hook the front and side hooks of the seat cushion.
14
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.