Where is the air conditioning filter located in the Tiguan?

1 Answers
VonMarcus
07/29/25 9:23pm
The air conditioning filter in the Tiguan is located under the glove box on the passenger side, near the center console. The air conditioning filter is used to filter the quality of indoor or outdoor intake air. Taking the 2017 Tiguan as an example, it is a compact SUV with body dimensions of 4506mm in length, 1809mm in width, 1685mm in height, a wheelbase of 2684mm, and a curb weight of 1600kg. The 2017 Tiguan is equipped with a 1.8T inline 4-cylinder turbocharged engine, delivering a maximum horsepower of 160PS, a maximum torque of 250Nm, and a maximum power of 118kW, paired with a 6-speed automatic transmission.
Was this review help?
13
2
Share
More Forum Discussions

How to Remove a Car Sunroof?

Take out a small flat-head screwdriver and gently pry open the trim panel along the gap with the small flat-head screwdriver. Be careful to do it lightly to avoid breaking the plastic clips inside. Remove the right-side screw. Take out a T-20 spline and use it to gently remove the screw. Keep the removed screw safely. There is a screw on the left side securing the sunroof switch. Remove the second screw and keep it safely for reinstallation. Take out the small flat-head screwdriver again and gently pry open the clips on both sides with it. This will separate the sunroof switch from the headliner. Take out the T-20 spline and use it to remove this screw. Disconnect the wiring harness plugs at the sunroof switch—there are three in total—one by one.
15
5
Share

What to Do When a Car's Valve Core Leaks Air?

If you find that the valve core of your tire is leaking air, the cause is likely due to aging of the valve stem. In this case, you need to replace the old valve stem with a new one, which involves cutting off the old valve stem and installing the new one. The rubber washer under the screw is usually the cause of the valve core leaking air. Therefore, before installation, make sure to clean any debris around the installation area of the valve stem on the rim. Then, cut a section from the old inner tube that includes the valve stem, and cut out a circle about 2 centimeters in diameter around the valve stem. Place one rubber circle onto the valve stem and install it onto the rim. Then, fit another rubber circle over the valve stem on the outside of the rim.
10
1
Share

What are the four steps to start a car?

Adjust the front and rear distance. For manual transmission, mainly adjust the left foot. When the clutch is fully depressed by the sole of the foot, there should be a slight margin left. Fasten the seat belt. Insert the key into the ignition lock, turn on the ignition switch, then observe whether all gauges are functioning normally, start the engine, and engage the correct gear. Turn on the left (right) turn signal and honk the horn as a signal, while observing the front, sides, above, and rearview mirrors of the vehicle to check for any obstacles that may hinder starting. Release the handbrake, slowly release the foot brake, and the vehicle will move forward. For manual transmission, gradually release the clutch, move the right foot to the accelerator pedal, and gently apply throttle.
20
1
Share

How to Check If a Vehicle Has Been Transferred to Someone Else?

You can bring your ID to the vehicle management office to inquire about the vehicle information under your name, or check with the local traffic police team to see if you have any cars registered under your name. On the vehicle violation inquiry platform, enter the vehicle information and license plate number. If you can only retrieve the information by entering the original owner's vehicle details, it indicates that the transfer has not been completed successfully. You can also inquire with the insurance company about the vehicle's insurance personnel to determine whether the vehicle has been transferred. When there are issues with the vehicle, such as involvement in a car accident, failure to undergo annual inspection, stolen vehicles, or smuggled vehicles, the transfer cannot be processed through normal procedures.
19
5
Share

How to turn off the TC light on a Buick?

The owner accidentally touched the traction control switch next to the gear shift lever. The owner can simply turn the control switch back on to deactivate the TC light. If the TC light remains on after turning off the traction control switch next to the gear shift lever, it indicates a malfunction in the traction control system, and the vehicle should be taken to a repair shop for inspection. TC stands for Traction Control system. When the ABS detects wheel slippage, the traction control system applies braking to the slipping wheel. Possible causes of the malfunction include: engine solenoid valve failure; dirty engine oil clogging the solenoid valve filter screen; or wear and tear on the actuator gear and impeller.
10
5
Share

How to Deal with Water Stains on Car Windows That Won't Wipe Clean?

Pour the cleaner onto a towel or sponge and wipe the glass to remove water stains. You can also use alcohol to remove them. First, wipe the glass with a damp cloth, then use a dry cloth dipped in a small amount of alcohol or high-proof liquor to wipe the glass, which can also remove water stains. Alternatively, you can spray vinegar or soda water on the glass and wipe it with a towel to remove water stains. For small scratches, squeeze toothpaste onto a polishing cloth, apply it to the scratches, and then wipe the toothpaste clean with a damp cloth.
12
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.