Where is the air conditioning filter element of the Sagitar located?
2 Answers
Volkswagen Sagitar's air conditioning filter element is located on the passenger side, beneath the glove compartment, near the center console. More relevant information is as follows: 1. To replace the air conditioning filter element, first open the glove compartment cover. Locate the fixing buckle on the right side of the glove compartment and pull it outward firmly. Remove the fixing buckle of the glove compartment cover to detach it. Squeeze both sides of the glove compartment towards the middle with both hands, and the glove compartment can then be removed. After removing the glove compartment, you will see the cover plate of the air conditioning filter element. Press the fixing buckles on both sides of the cover plate firmly, and the cover plate can be removed. Pull the old air conditioning filter element outward. Install the new air conditioning filter element and restore it to its original position in the reverse order of disassembly (pay attention to the installation direction of the air conditioning filter element). 2. The air conditioning filter element is used to filter the intake air quality inside or outside the vehicle. As for the air filter element, it refers to the engine intake system, which filters the air quality entering the engine intake pipe. The two have different functions. Generally, the replacement cycle for the engine air filter element is based on air quality and mileage, while the replacement cycle for the air conditioning filter element is once a year or every 20,000 kilometers.
Last time I replaced the Sagitar's cabin air filter myself, I carefully studied its location. It's behind the glove compartment on the passenger side. First, empty the glove compartment, then press inward on both sides to remove the compartment. Note there are clips on the sliding rails - use some finesse rather than brute force. After removing the glove compartment, you'll see a rectangular plastic cover. Gently press the clips on both sides to open the cover, and the filter is inside. In older Sagitar models, the filter inserts vertically, while newer models have a horizontal design that's easier to access. I recommend using a vacuum to clean leaves and dust from the filter housing when replacing - this extends the new filter's lifespan. The whole DIY job takes about half an hour, saving over 200 yuan compared to dealership service. Remember to buy an activated carbon filter for better performance - regular filters start smelling musty after just three months.
