Where is the air conditioning drain pipe of the Besturn X80 located?

1 Answers
MacEmerson
07/30/25 5:05am
Air conditioning drain pipes are mostly located at the wall hole where the copper pipe connects to the indoor unit. Normally, they enter from the right side and connect to the indoor unit. If they enter from the left side, the indoor unit will basically be in a horizontal position. Introduction to air conditioning: Air conditioning, or air conditioner (Air Conditioner), refers to equipment that artificially regulates and controls parameters such as temperature, humidity, and air velocity within a building or structure. Air conditioning equipment: Includes cold/heat source equipment, cold and hot medium distribution systems, terminal devices, and other auxiliary equipment. Main components include refrigeration hosts, water pumps, fans, and piping systems. Terminal devices are responsible for utilizing the distributed cold or heat to specifically treat the air state, ensuring that the air parameters of the target environment meet requirements.
Was this review help?
18
3
Share
More Forum Discussions

How many cubic meters of soil can an 8-wheel rear truck carry?

An 8-wheel rear truck can carry 23 cubic meters of soil. Calculating vehicle capacity: Measure the dimensions of the cargo compartment (length × width × height) to calculate the volume of soil the truck can transport in one trip. Vehicle configuration: Hydraulically controlled rear cover opening and closing system, equipped with replaceable trapezoidal sealing rubber rings. Additional manual backup locking devices are installed on both sides at the lower part of the rear cover to ensure complete sludge containment without leakage. Driving tips: For 8-wheel rear truck maintenance, the most routine service item is regular replacement of the three filters. These filters are designed to better protect the engine and extend its service life as much as possible. The three filters refer to the fuel filter, air filter, and oil filter, which function to remove impurities from gasoline, air, and engine oil respectively, preventing contaminants from entering the engine interior. It is recommended that owners replace the oil filter according to the prescribed maintenance intervals.
13
3
Share

What does it mean when the airbag detonation device exceeds the upper limit?

Airbag detonation device exceeding the upper limit refers to a fault code indicating excessive resistance in the airbag control unit. Reasons for excessive resistance in airbags: Loose airbag connectors - If the wiring harness connector under the seat is loose, simply reconnect each one firmly. Damage to the clock spring (slip ring) in the steering column, or damage to the main airbag in the steering wheel. Side airbags are installed on the outer side of car seats and function to deploy during side impacts, protecting passengers from lateral collision forces. Definition of airbags: An airbag is a device that inflates to protect occupants before secondary impact occurs during a collision. As a supplemental restraint system (SRS) to seat belts, the airbag system consists of: an integrated airbag module containing the cushion and inflator (gas generator), impact sensors that detect collisions and trigger deployment, and wiring harnesses that transmit sensor signals.
7
2
Share

How to adjust the steering when the right side is wide and the left side is narrow while reversing into the garage?

When the rearview mirror shows a "left wide, right narrow" positional relationship, turn the steering wheel 1/4 turn to the left, and straighten the wheel when the car body is aligned. Reversing into the garage is an assessment point in the driver's test. It involves correctly maneuvering the vehicle into the garage from both sides while moving. There is a time limit for reversing into the garage during the test. Below are the evaluation criteria for reversing into the garage: 1. Failure to follow the prescribed route and sequence results in disqualification. 2. If the car body touches the line or fails to enter the garage while reversing, it results in disqualification. 3. Exceeding 210 seconds without completing the reversing into the garage results in disqualification. 4. Stopping midway deducts 5 points each time.
20
1
Share

Why Does Oil Leak After an Oil Change?

Because the oil pan bolt is not tightened properly or the drain plug gasket needs replacement (poor sealing). As the engine operates, engine oil has strong permeability and typically seeps slightly from the oil seal, which is a common occurrence and not a malfunction. Below are explanations of two scenarios: Minor Oil Seepage: It does not significantly affect the engine. It is advisable to continue using the vehicle while monitoring the situation. For oil seepage or slow leaks, identify the location, usually most common at joints. Sometimes, simply tightening the relevant screws yourself can resolve the issue. Long-term Oil Seepage: It is recommended to have it inspected at a professional repair shop. Although this seepage does not affect the engine's overall operation, it depletes the lubrication system's oil over time, reducing the oil level. Prolonged seepage can degrade the lubrication system's effectiveness and ultimately shorten the engine's lifespan.
17
2
Share

What engine does Changan Oushang have?

Changan Oushang is equipped with a 1.5L DAM engine, with a maximum torque of 148, a maximum power of 84, and a maximum horsepower of 114. The following is extended information about Changan Oushang: 1. Exterior: The vehicle's length/width/height are 4490/1860/1580mm respectively, with a wheelbase of 2710mm. 2. Interior: It features a 10-inch full LCD dashboard with clear and easy-to-read content, displaying information such as fuel consumption, tire pressure, and navigation in the central area. 3. System: It comes with the new Onstyle 3.0 intelligent ecosystem, built-in Qualcomm Snapdragon 8-core car chip, and includes functions such as artificial intelligence voice, navigation, music, radio, facial recognition, gesture recognition, remote vehicle control, track mode, and wireless car KTV.
7
2
Share

Will There Be Color Difference When Replacing a Bumper?

There might be slight color difference when replacing a bumper. Automobile Safety Device: The car bumper is a safety device that absorbs and mitigates external impacts, protecting the front and rear parts of the vehicle body. Many years ago, the front and rear bumpers of cars were made of steel plates pressed into channel steel, riveted or welded to the frame longitudinal beams, with a relatively large gap from the vehicle body, which looked quite unattractive. Bumper Material: With the development of the automotive industry and the extensive application of engineering plastics in the automotive sector, car bumpers, as an important safety device, have also embarked on a path of innovation. Today, the front and rear bumpers of cars not only maintain their original protective functions but also strive for harmony and unity with the vehicle body styling, as well as the pursuit of lightweight design. Both the front and rear bumpers of cars are made of plastic, hence they are commonly referred to as plastic bumpers.
14
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.