Where is the air conditioning drain hole of Haval H6?

How to Determine the Quality of a Car Air Conditioning Compressor?

To determine the quality of a car air conditioning compressor: Turn on the air conditioning, and the low-pressure gauge on the car dashboard will quickly drop while the high-pressure gauge rapidly rises. If the needle's amplitude increases significantly when the throttle is pressed, it indicates the compressor is in good condition; otherwise, it is damaged. Reasons for air conditioning compressor failure include: 1. Damage to the electromagnetic clutch inside the compressor or internal wear; 2. Refrigerant leakage; 3. Damage to the compressor capacitor. The working principle of the air conditioning compressor: It draws refrigerant from the low-pressure area, compresses it, and sends it to the high-pressure area for cooling and condensation. The heat is dissipated into the air through the radiator, and the refrigerant changes from a gaseous to a liquid state, with an increase in pressure.

7

4

Share

How to Distinguish Between Toyota Prado and Land Cruiser?

The methods to distinguish between Toyota Prado and Land Cruiser are: 1. Different letters on the lower part of the front face: Toyota Prado is labeled as 'landcruiserprado'; Land Cruiser is labeled as 'landcruiser'. 2. Different front grilles: Toyota Prado has a vertical grille; Land Cruiser has a horizontal grille. 3. Different engine displacements: Toyota Prado comes with 2.7L and 4.0L; Land Cruiser comes with 4.0L, 4.6L, and 5.7L. 4. Different numbers of differential locks: Toyota Prado has two differential locks; Land Cruiser has three differential locks. The Toyota Prado features a double-wishbone independent front suspension and a four-link non-independent rear suspension. It is equipped with a 3.5L naturally aspirated engine, delivering a maximum horsepower of 280PS, a maximum torque of 365Nm, and a maximum power of 206kW, paired with a 6-speed automatic transmission.

19

0

Share

What are the reasons for engine failure to start?

Engine failure to start can be attributed to the following reasons: 1. Fuel supply system failure: blockage in the low-pressure fuel line, loose pipes causing fuel leakage, air in the high-pressure fuel line, poor technical condition of the fuel injector, incorrect fuel injection timing angle; 2. Starting device failure: power supply issues, poor contact in the electromagnetic switch, poor contact between the starter motor commutator and brushes, clutch slippage in the starter transmission mechanism; 3. Insufficient cylinder compression pressure: cylinder head gasket damage causing air leakage, improper valve closure leading to air leakage, wear in piston cylinder liners causing air leakage; 4. Insufficient air intake: clogged air filter element. An engine is a machine capable of converting other forms of energy into mechanical energy, applicable both as a power generation device and as a complete machine including the power unit.

20

4

Share

What is the suitable position for ETC installation?

The installation position for ETC in small cars is generally in the upper middle part of the front windshield, while for large vehicles such as trucks and buses, it is in the lower middle part. The suitable installation position should be no lower than 1.2 meters and no higher than 2.5 meters, with an installation angle between 30 to 90 degrees. For vehicles with factory-installed or aftermarket explosion-proof film, which may affect the signal transmission of the microwave communication link, the ETC should be installed in the microwave sunroof strip. ETC stands for Electronic-Toll-Collection, meaning electronic toll collection system. To apply for ETC, the vehicle owner needs to provide original and photocopies of their valid ID card and vehicle registration certificate. If the application is not done by the owner themselves, the agent must also bring their valid ID card. The photocopy of the vehicle registration certificate should include the page with the most recent annual inspection stamp. A bank card for deducting highway tolls is also required, and the vehicle must be registered under the name of an individual aged between 18 and 60. Here are some considerations for ETC installation: Do not obstruct the driver's view. It is best to install it behind the rearview mirror: Many car models have a large rearward tilt angle of the windshield, which can reduce the driver's field of vision. If this is not considered during ETC installation, it can increase the driver's blind spots. Installing it behind the rearview mirror on the right side can help avoid obstructing the view. Do not interfere with charging: The ETC electronic tag consumes power but generally does not require charging or battery replacement because it has a solar panel on the back that can charge itself. Therefore, during installation, avoid the black areas on the windshield and positions that may block the solar panel. Once installed, do not remove it arbitrarily: The button in the middle of the adhesive is an anti-removal lever connected to a switch. After installation, the windshield will press the anti-removal lever in. If the tag is removed arbitrarily, the lever will pop out and trigger the switch, locking the electronic tag and rendering it unusable. In such cases, you will need to visit an ETC service point to unlock it. This mechanism is designed to prevent multiple vehicles from sharing one device. When using ETC, note the following: The ETC transaction sensing range is 8 meters. To prevent the ETC device of the vehicle in front from malfunctioning, maintain a distance of more than 10 meters from the vehicle in front to avoid automatic toll deduction for the wrong vehicle. The ETC lane recognition speed is 20 kilometers per hour. Driving too fast may result in failure to read the vehicle's device information, leading to toll deduction failure. When using a debit card linked to ETC, insufficient balance may also cause toll deduction failure.

5

Share

What brand are the original tires on the Geely Emgrand GL?

The original tires on the Geely Emgrand GL are from the Giti brand, with the tire model being 205/55r16. Taking the 2020 Geely Emgrand GL as an example, it belongs to the compact car category, with body dimensions of: length 4725mm, width 1802mm, height 1478mm, a wheelbase of 2700mm, a fuel tank capacity of 55 liters, and a curb weight of 1335kg. The 2020 Geely Emgrand GL features a MacPherson strut front suspension and a torsion beam rear suspension. It is equipped with a 1.4L turbocharged engine, delivering a maximum horsepower of 141PS, a maximum power of 104kW, and a maximum torque of 235Nm, paired with a 6-speed manual transmission.

20

4

Share

How to Adjust the Time on Wuling Hongguang?

To adjust the time on Wuling Hongguang, follow these steps: Press and hold the clock button until you hear a beep, then release the button. The time display will start flashing. To set the hour, press and hold the preset button (H end) until the hour increments to the desired time. To set the minutes, press the M end, following the same principle as setting the hour. Finally, press the clock button to confirm the set time. Taking the 2020 Wuling Hongguang as an example, it is a microvan with the following dimensions: length 4390mm, width 1660mm, height 1750mm, wheelbase 2720mm, fuel tank capacity 50L, and curb weight 1185kg.

16

4

Share

Where is the air conditioning drain hole of Haval H6?

How to Determine the Quality of a Car Air Conditioning Compressor?

How to Distinguish Between Toyota Prado and Land Cruiser?

What are the reasons for engine failure to start?

What is the suitable position for ETC installation?

What brand are the original tires on the Geely Emgrand GL?

How to Adjust the Time on Wuling Hongguang?

What do the 'five oils, four filters, and three waters' refer to?

What is the difference between 1.5L and 1.5T cars?

How to Distinguish Between Domestic and Imported Audi?

What is the difference between the Volkswagen Arteon and the Volkswagen CC?