Where is MG produced?

Is It Okay to Drive a New Car on a Long Trip?

It is possible to drive a newly purchased car on a long highway trip, but you should pay attention to the speed and engine RPM. It is best not to exceed 100 km/h and keep the engine RPM below 3000. Avoid driving for extended periods and ensure the vehicle gets sufficient rest. Here are specific precautions for driving a new car on the highway: 1. Speed Control: Do not exceed 100 km/h on the highway, avoid sudden acceleration or deceleration, and gently apply the brakes and throttle. 2. Pre-Trip Inspection: Before the trip, it's advisable to have the car checked at a 4S dealership (usually free). Inspect tire pressure and check for any leaks of fluids or oil. 3. Avoid Overloading: Overloading a new car can damage its components. For the first 1000 km, domestic cars should not exceed 75%-80% of the rated load capacity, while imported cars should not exceed 90%. Additionally, choose smoother road surfaces to minimize excessive vibration, impact, or emergency braking, reducing stress on the body and powertrain. 4. Take Breaks: For trips longer than 2 hours, take breaks at service areas—both the driver and the car need rest. Prolonged engine operation increases the likelihood of accelerated component wear.

8

2

Share

How to Set Up the Rearview Camera?

Step on the car's brake pedal and press the one-touch start button to turn on the dashboard and power up the vehicle. Shift the car's gear lever to the R position to engage reverse gear. Check if the rearview camera image is misaligned. Adjust the camera angle if necessary.

2

5

Share

What is the method to clear the 0101 fault code on Dongfeng Dolika?

"The fault code 0101 on Dongfeng Dolika indicates a lack of urea in the vehicle. This code serves as a reminder for the driver to refill the urea. To resolve this, open the urea filler cap and pour in the urea solution. Fault resolution method: When the vehicle is low on urea solution, a warning light resembling a fuel tank with 'Adblue' will illuminate on the dashboard (usually yellow or blue). The urea tank is typically located on the left or right side of the vehicle frame. Unscrew the cap on top of the urea tank to refill it. If the vehicle is not consuming urea, it may be due to a clogged urea nozzle or a system malfunction. The digital dashboard will display corresponding fault codes. In such cases, it is recommended to visit a service station for inspection and repair. Function of urea solution: It reduces nitrogen oxide compounds in vehicle exhaust, lowering pollution levels and helping the vehicle meet national emission standards. The SCR system's intelligent control prevents the vehicle from starting when the urea solution level is insufficient. To ensure normal operation, always maintain an adequate supply of urea solution. Vehicle urea solution is essential for heavy-duty diesel vehicles to meet China's National IV emission standards. It consists of a 32.5% urea concentration in ultrapure water, made from urea crystals and ultrapure water."

7

2

Share

Is the parking distance 30 meters or 50 meters?

50m. Motor vehicles are not allowed to park at intersections, railway crossings, sharp curves, narrow roads less than 4 meters wide, bridges, steep slopes, tunnels, or within 50 meters of the above locations. Parking in these areas not only endangers the driver's property and personal safety but also poses risks to others' property and personal safety. When temporarily parking on the road, motor vehicles must comply with the following regulations: 1. Parking is prohibited in sections with no-parking signs or markings, sections with isolation facilities between motor vehicle lanes and non-motor vehicle lanes or sidewalks, crosswalks, and construction zones. 2. Parking is prohibited at intersections, railway crossings, sharp curves, narrow roads less than 4 meters wide, bridges, steep slopes, tunnels, or within 50 meters of the above locations. 3. Parking is prohibited in front of bus stops, emergency stations, gas stations, fire hydrants, or fire stations (including within 30 meters of these locations), except when using these facilities. 4. Doors must not be opened or passengers allowed to board or alight before the vehicle comes to a complete stop, and opening doors must not obstruct other vehicles or pedestrians. 5. When parking on the roadside, vehicles must stay close to the right side of the road, and the driver must not leave the vehicle. After passengers board or alight or goods are loaded or unloaded, the vehicle must depart immediately. 6. City buses are not allowed to stop to pick up or drop off passengers outside designated bus stops.

7

1

Share

What is the correct procedure to start a manual transmission car?

Press the clutch pedal, shift the manual transmission to neutral (N) position, insert the ignition key, and start the engine. Additional information: 1. Composition: By engaging different gear sets, gear shifting is achieved. As the critical component for power distribution, the transmission must have two major parts - the power input shaft and output shaft, along with the gears that constitute the transmission, forming the most basic components of a manual transmission. 2. Principle: The power input shaft connects to the clutch. The power transmitted from the clutch goes directly through the input shaft to the gear set, which consists of gears with different diameters. Different gear ratios achieve completely different power transmission effects. The gear shifting during normal driving essentially refers to changing gear ratios.

12

2

Share

Which Three Certificates Are Required for Hazardous Materials Drivers?

Need to hold the "Hazardous Materials Professional Qualification Certificate" as well as the vehicle license and driver's license. Road hazardous goods transport drivers should meet the following conditions: 1. Obtain the corresponding motor vehicle driver's license. 2. Age not exceeding 60 years. 3. No major or above traffic responsibility accidents within 3 years. 4. Have more than 2 years of professional qualification for operating road passenger transport or cargo transport drivers. 5. Receive training on relevant regulations, safety knowledge, professional technology, occupational health protection, and emergency rescue knowledge, understand the nature of hazardous goods, hazard characteristics, usage characteristics of packaging containers, and emergency measures in case of accidents. 6. Pass the examination and obtain the corresponding professional qualification certificate.

1

5

Share

Where is MG produced?

Is It Okay to Drive a New Car on a Long Trip?

How to Set Up the Rearview Camera?

What is the method to clear the 0101 fault code on Dongfeng Dolika?

Is the parking distance 30 meters or 50 meters?

What is the correct procedure to start a manual transmission car?

Which Three Certificates Are Required for Hazardous Materials Drivers?

What are the materials used in new energy power batteries?

How to Handle Traffic Violations for Out-of-Town Vehicles in Shanghai?

Does low car AC temperature consume more fuel or does high fan speed consume more fuel?

Why Does the Radiator Run Out of Water?