Where does the license plate 'Lu P' belong to?

Should the engine be warmed up before an oil change?

It is necessary to warm up the engine before changing the oil. The method for warming up is: After starting the vehicle, let it idle for 1 to 2 minutes to allow the engine coolant to reach normal temperature. The steps for changing the oil are: 1. Lift the vehicle, remove the undercover, and place a container beneath the oil drain plug; 2. Unscrew the drain plug, use an air gun to blow into the oil filler port for two minutes, then tighten the drain plug after the oil has drained and wipe it with a tissue to check for leaks; 3. Reinstall the undercover, lower the vehicle, and add new oil through the filler port. Precautions for changing the oil include: 1. Perform the oil change while the engine is warm to ensure the old oil is drained as completely as possible; 2. Add the appropriate amount of new oil; 3. After adding the oil, start the engine and check all components for leaks. Let the engine run for 3 minutes to confirm the oil level is at the normal mark.

2

Share

Is Skoda a Joint Venture or Domestic Car?

Skoda is a joint venture car. Its body dimensions are: length 4675mm, width 1814mm, height 1460mm, with a wheelbase of 2686mm, fuel tank capacity of 68.5 liters, trunk capacity of 570 liters, and a body weight of 1440kg. The 2019 standard version of Skoda features a MacPherson independent front suspension and a four-link independent rear suspension. It is equipped with a 1.4L turbocharged engine, delivering a maximum horsepower of 150PS, maximum power of 110kW, and maximum torque of 250Nm, paired with a 7-speed dual-clutch transmission.

5

Share

What is the disassembly and installation method for the ŠKODA Superb navigation system?

The disassembly and installation method for the ŠKODA Superb navigation system is as follows: 1. Remove the button panel and air vents on the center console; 2. After removing the panel, unplug the connecting wires, loosen the relevant screws, take out the single-disc CD player, and disconnect the connecting wires to complete the disassembly; 3. Use screws and clips to install the new navigation device in the original center console panel position, remove the packaging from the navigation screen, and eliminate any bubbles on the screen film before completing the installation. The navigation modes include: 1. Path retrieval customization mode; 2. Site setting mode; 3. Map positioning mode. The functions of the navigation system are: 1. Search and processing of map data; 2. Map matching; 3. Route planning; 4. Human-machine interface; 5. Wireless communication.

17

2

Share

What is the method to reset the maintenance reminder on a Skoda?

Skoda reset maintenance reminder method is: 1. Remove the vehicle key, turn off the engine, and hold down the trip meter reset button; 2. Start the vehicle, release the trip meter reset button, at which point the service indicator will appear on the display; 3. Then turn the minute button on the vehicle's instrument panel to the right, and the mileage will be displayed; 4. Turn off the vehicle, and the reminder message will reset; 5. Turn the ignition switch to the on position. Taking the 2020 Comfort version Skoda as an example, its body dimensions are: 4675mm in length, 1814mm in width, 1460mm in height, with a wheelbase of 2686mm.

18

4

Share

Does the Civic meet the China 6 emission standard?

The Civic meets the China 6 emission standard. Its body dimensions are: length 4517mm, width 1799mm, height 1434mm, with a wheelbase of 2700mm. It has a fuel tank capacity of 47 liters, a trunk capacity of 440 liters, a minimum ground clearance of 104mm, and a curb weight of 1343kg. The 2021 Sharp Control Edition Civic features a MacPherson strut front suspension and a multi-link independent rear suspension. It is equipped with a 1.5L turbocharged engine producing a maximum horsepower of 177PS, a maximum power of 130kW, and a maximum torque of 220Nm, paired with a continuously variable transmission.

16

2

Share

How to Adjust the Height of the Civic Driver's Seat?

The method to adjust the height of the Civic driver's seat is as follows: On the left side of the seat, near the door frame, use your left hand to reach down and feel for the handle. Lift the handle to adjust to the desired position and then release it. Taking the 2021 Civic New Sharp Control Edition as an example, its body dimensions are: length 4517mm, width 1799mm, height 1434mm, with a wheelbase of 2700mm, a fuel tank capacity of 47 liters, and a curb weight of 1343kg. The 2021 Civic New Sharp Control Edition features a MacPherson strut front suspension and a multi-link independent rear suspension. It is equipped with a 1.5L turbocharged engine, delivering a maximum horsepower of 177PS, a maximum power of 130kW, and a maximum torque of 220Nm, paired with a continuously variable transmission (CVT).

12

3

Share

Where does the license plate 'Lu P' belong to?

Should the engine be warmed up before an oil change?

Is Skoda a Joint Venture or Domestic Car?

What is the disassembly and installation method for the ŠKODA Superb navigation system?

What is the method to reset the maintenance reminder on a Skoda?

Does the Civic meet the China 6 emission standard?

How to Adjust the Height of the Civic Driver's Seat?

What is the engine of the Hongqi HS7?

What engine does the SWM X3 use?

What to Do When ETC Signal is Weak?

What are the drawbacks of ECU remapping for engines?