Where are the vehicle inspection locations in Linyi?

Can Snow Tires Be Installed Only on the Front Wheels?

No, it's best to replace all four tires, otherwise it may cause side slipping. Many cars currently use anti-skid chains, but they can only temporarily handle ice and snow. If used for a long time, they can severely damage the tires. Installing only on the front wheels: Installing winter tires only on the front wheels will result in insufficient grip for the rear wheels. When driving on winter roads, this can easily cause oversteering or brake shudder. Installing only on the rear wheels: Installing winter tires only on the rear wheels will lead to insufficient grip for the front wheels, and the vehicle is prone to steering issues when driving on winter roads. Therefore, it is recommended to replace all four winter tires simultaneously. Note that winter tires of the same specifications, brand, structure, and tread pattern must be installed on the same axle.

16

5

Share

Where can small cars generally go to inflate their tires?

Small cars generally go to tire shops for inflation. Introduction to tire shop inflation: Designed uniformly by manufacturers and managed according to the manufacturer's business model. Currently, domestic joint-venture car manufacturers have 4S stores nationwide, which directly supply complete vehicles and spare parts to these 4S stores. The 4S stores are responsible for sales and after-sales services on behalf of the manufacturers. Additional information on checking tires: Screw the connecting end of the tire pressure gauge into the tire valve to display the tire pressure value. After inflation, measure the tire pressure again. Follow the process: measure → inflate → measure again → deflate until the tire pressure values of all four tires are consistent. Remember to screw the valve cap back on.

8

1

Share

What does starting the car mean?

Starting the car is the fundamental technique and experience for driving safety. Steps for starting the car: Engage the handbrake (to prevent sliding); insert the key; turn on the power and perform a self-check for 5 seconds; press the foot brake; shift from P to N gear; start the engine and warm up for 15 seconds (during this time, fasten the seatbelt and adjust the rearview mirror); shift into D gear; release the handbrake; slowly release the foot brake; start moving. Precautions for starting the car: Carefully inspect the surroundings of the vehicle, paying attention to any obstacles under the car or around the body. Cold starts require warming up the engine, with the warm-up time depending on the temperature; generally, it is sufficient to start when the idle speed returns to normal. Always remember to fasten the seatbelt and check if the driver's seat and rearview mirror positions are appropriate; adjust them if necessary.

20

1

Share

How to Change the Engine Oil You Purchased Yourself?

Method for changing self-purchased engine oil: 1. Start the car engine and turn it off once the water temperature reaches the normal operating range. Then, use a jack or car lift to raise the vehicle; 2. Open the oil drain plug at the bottom and use a specialized wrench to remove the oil filter. The oil will drain slowly from the drain plug, allowing you to remove the filter for secondary drainage during this time; 3. After all the old oil has completely drained, use the wrench to install the new oil filter. Pour the appropriate amount of specification-compliant engine oil into the oil pan, making sure to align it properly with the filler hole. If necessary, use a funnel for assistance; 4. Start the engine to check if the oil level is normal, which serves to verify there are no leaks in the lower part of the engine.

4

0

Share

What are the components of a clutch?

The clutch consists of four main parts: the driving part, the driven part, the pressing part, and the operating mechanism. The detailed structure of each part is as follows: 1. Driving part: includes the flywheel, pressure plate, and clutch cover; 2. Driven part: includes the driven disc and driven shaft; 3. Pressing part: consists solely of the pressure spring; 4. Operating mechanism: includes the release lever, release lever support post, swing pin, release sleeve, release bearing, clutch pedal, etc. The clutch is located inside the flywheel housing between the engine and the transmission. The clutch assembly is secured to the rear plane of the flywheel with screws, and the output shaft of the clutch is the input shaft of the transmission. During vehicle operation, the driver can press or release the clutch pedal as needed to temporarily disconnect or gradually engage the engine and transmission, thereby cutting off or transmitting the power from the engine to the transmission.

9

0

Share

How to use M1, M2, and M3 in manual-automatic transmission?

Manual-automatic transmission refers to the manual first, second, and third gears, which are used for climbing slopes and overtaking. Manual transmission cars: These are cars that use a manual shift mechanical transmission (also known as manual transmission, MT) to adjust speed. That is, the gear meshing position inside the transmission can only be changed by manually moving the gear lever, altering the transmission ratio to achieve gear shifting. The gear lever can only be moved when the clutch is depressed. Principle of manual transmission: The power input shaft is connected to the clutch, and the power transmitted from the clutch is directly passed to the gear set through the input shaft. The gear set consists of gears with different diameters, and different gear ratios achieve completely different power transmission effects. The gear shifting in normal driving refers to changing the gear ratio.

20

3

Share

Where are the vehicle inspection locations in Linyi?

Can Snow Tires Be Installed Only on the Front Wheels?

Where can small cars generally go to inflate their tires?

What does starting the car mean?

How to Change the Engine Oil You Purchased Yourself?

What are the components of a clutch?

How to use M1, M2, and M3 in manual-automatic transmission?

Why can't the wiper blade clean properly when it's frozen?

How Tall is a Van?

What brand is the Verano's transmission?

How to Adjust the Odometer on a Bora?