Where are the swivel casters with brakes located?

Is Wheel Alignment Necessary When Changing Tires?

Wheel alignment is not necessary when changing tires. Wheel alignment is required in the following situations: 1. Damage to the chassis and suspension caused by an accident; 2. Replacement of steering system and components; 3. Unilateral wear of front or rear tires; 4. Replacement or adjustment of the suspension system. Wheel alignment involves adjusting the geometric angles of the tires, steering, and suspension components to ensure tight contact between the tires and the ground. The benefits of wheel alignment include: 1. Enhanced driving safety; 2. Reduced tire wear; 3. Maintaining straight steering when driving straight; 4. Automatic return of the steering wheel after turning, improved driving control, reduced fuel consumption, and decreased wear on suspension components.

5

4

Share

What is the meaning of the gecko on the car?

The gecko on the car symbolizes protection and safety. The gecko emblem originates from Audi's proud Quattro four-wheel-drive system. Here is an introduction to Audi Quattro: 1. The core technology of Audi Quattro is the purely mechanical Torsen center differential. The Torsen differential features a worm gear planetary gear structure and operates purely mechanically without any electronic system intervention. The basic principle of this differential is to utilize the one-way transmission characteristic of worm gears, meaning motion can only be transmitted from the worm to the gear, while reverse motion causes self-locking. 2. Audi Quattro is a full-time four-wheel-drive system that balances both road performance and off-road capability. Without relying on any electronic devices, it achieves these performance requirements through ingenious purely mechanical design, giving Audi Quattro an extremely high response speed.

13

0

Share

What is the detailed process of annual vehicle inspection?

The specific process for annual vehicle inspection is as follows: 1. After submitting the inspection application at the license office, have the engine number stamped at the imprinting station. 2. The inspection service hall will accept the documents and verify the VIN code, then proceed with the vehicle inspection handover procedures. 3. After paying the fee according to the vehicle type, drive the vehicle to the parking area for an exterior inspection, where the chassis number and engine number will be verified. 4. Follow the instructions of the staff to drive the vehicle to the exhaust emission testing line. The inspector will then drive the vehicle into the testing workshop for exhaust measurement. This process is referred to as "passing the line." 5. Enter the automatic inspection system, where the vehicle will sequentially pass through the speed test, side slip test, brake test, and light test. After completion, the vehicle will be returned to the owner. 6. The owner should collect the inspection report and application form from the inspector. If all inspection items pass, the owner can proceed to the license office to pay the inspection fee and collect the vehicle license and compliance label at the visa window. If any items fail, the owner must repair and adjust the vehicle before participating in a re-inspection until all items pass, after which the visa procedures can be completed.

11

2

Share

What are the requirements for upgrading from C1 to B1 driver's license?

The requirements for upgrading from C1 to B1 driver's license are: holding a C1 driver's license for more than three years, being between 21 and 50 years old, and not having a full-point deduction record in the current scoring cycle and the most recent scoring cycle before applying for the B1 license. Here are the relevant details: 1. After meeting the conditions, you can apply for the upgrade at the vehicle management office in your registered residence. According to regulations, the application for upgrading to a B1 license can only be processed at the vehicle management office in the driver's registered residence, so it cannot be done in a temporary residence. 2. After passing the tests for Subject One, Subject Two, and Subject Three, you can obtain a driver's license with a B1 endorsement. 3. It is important to note that there are some situations where you cannot apply for an upgrade, such as: causing a fatal traffic accident and bearing full or primary responsibility; driving under the influence of alcohol, etc.

20

4

Share

What does RF mean on tires?

Tire RF stands for Run-Flat tire, commonly known as a puncture-proof tire. Here are the specific details about puncture-proof tires: 1. The differences between puncture-proof tires and traditional tires include puncture resistance, reinforced sidewalls, additional valve strip bands, and synthetic rubber materials with high heat resistance. 2. In the event of a tire deflation, puncture-proof tires allow the vehicle to continue driving at a speed of 80 km/h for up to 250 kilometers. The reason puncture-proof tires do not collapse after deflation is mainly due to their thickened rubber sidewalls. Even when air pressure is lost, the sidewalls can still support the vehicle's weight without causing severe deformation, so a tire blowout does not significantly affect the vehicle's movement. 3. The design principle of puncture-proof tires relies on sturdy sidewalls to provide support. Another design approach for puncture-proof tires involves installing a device called a fixed ring inside the tire. This fixed ring supports the tire from the inside, preventing it from being crushed and also keeping the tire from detaching from the tire bead.

11

1

Share

How to Distinguish Between Company-Registered and Privately-Registered Vehicles?

Company-registered and privately-registered vehicles differ in the following aspects: 1. Required registration documents differ: Company registration requires business license, IC card, organization code certificate, capital verification report, etc.; Private registration only requires ID card, and for non-locals, additional documents like household registration and temporary residence permit are needed. 2. Payment responsibility differs: Company-registered vehicles are paid for by the company; Privately-registered vehicles are paid for by the individual. 3. Vehicle ownership differs: The vehicle license of a company-registered vehicle bears the name of a company, making it the legal property of the company; The vehicle license of a privately-registered vehicle bears the individual's name, making it private property. 4. Impact on creditors differs: If the vehicle is company property, creditors of the company's external debts can legally apply for preservation or execution of this property. If the vehicle is personal property, creditors of company debts generally cannot apply for preservation or execution of this property. 5. Insurance costs differ: Compulsory traffic insurance for company-registered vehicles costs a few dozen RMB more than for privately-registered vehicles.

10

3

Share

Where are the swivel casters with brakes located?

Is Wheel Alignment Necessary When Changing Tires?

What is the meaning of the gecko on the car?

What is the detailed process of annual vehicle inspection?

What are the requirements for upgrading from C1 to B1 driver's license?

What does RF mean on tires?

How to Distinguish Between Company-Registered and Privately-Registered Vehicles?

What Causes Fogging on the Outside of Car Windows?

What kind of vehicle has a white XH license plate?

What does it mean when the engine oil warning light comes on in a car?

How to Quickly Defog a Car?