Where are the door drainage holes located on the old Mazda6?

1 Answers
McKarter
07/29/25 5:25pm
The door drainage holes on the old Mazda6 are located at the bottom of the doors. The Mazda6 is part of the Mazda automobile lineup. Below is a detailed introduction about Mazda automobiles: 1. Overview: Mazda, officially known as Mazda Motor Corporation, is a Japanese multinational automaker listed on the Tokyo Stock Exchange (TYO). Its business scope includes passenger vehicles, automobile manufacturing, and sales. 2. Models: Mazda's global passenger vehicle lineup includes: SUV series CX-3, CX-30, CX-4, CX-5, CX-8, CX-9, MX-30; sedan series Mazda2, Mazda3, Mazda6 (known as 'Atenza' by FAW Car); and the sports car MX-5.
Was this review help?
3
4
Share
More Forum Discussions

How long does it take to charge a completely dead car battery?

When a car battery is completely dead, it usually takes about two hours of driving to fully charge the battery. Here is more information about car batteries: 1. Introduction: A car battery, also known as a storage battery, works by converting chemical energy into electrical energy. The commonly referred to car battery is a lead-acid battery, which is mainly made of lead and its oxides, with a sulfuric acid solution as the electrolyte. 2. Reasons for a dead battery: Frequent short-distance driving with frequent stops and starts can cause the battery to remain undercharged for extended periods, shortening its lifespan. Driving at a steady speed on the highway for 20-30 minutes can provide sufficient time to charge the battery.
7
2
Share

How Can a Beginner Driver Drive on the Highway?

For the first 12 months after obtaining a driver's license, it is considered the probationary period. During this period, if a driver wishes to drive on the highway, they must be accompanied by a driver who has held a valid driver's license for the same or higher vehicle category for at least three years. After one year of obtaining the license, the driver can drive on the highway alone. Here are more tips for driving on the highway: 1. Do not stop on the highway: You should not stop on the highway unless it's an emergency. If you must stop, park in the emergency lane and place a red warning sign about 150 meters behind your vehicle to alert other drivers. 2. Maintain a safe distance: Always keep a sufficient distance from the vehicle in front of you to ensure enough reaction time in case of an accident.
3
0
Share

How to Check if ETC is Successfully Activated?

Methods to check ETC activation status: View through the ETC Assistant mini-program, which will display an activation success notification upon completion; Alternatively, remove and reinsert the card into the device - for debit cards, the device will display "card" or "debit card", while prepaid cards will show the balance, indicating successful ETC activation. ETC working principle: Utilizing dedicated short-range communication between the on-board unit (OBU) installed on the vehicle's windshield and microwave antennas at toll station ETC lanes, the system employs computer networking technology for backend bank settlement processing. This enables vehicles to pass through highway or bridge toll stations without stopping while automatically paying the required fees. ETC installation positions: For small vehicles like cars and minivans, the OBU device should be installed on the upper-middle section of the front windshield. For large vehicles such as trucks and buses, the installation position should be on the lower-middle section. ETC installation requirements: Minimum height of 1.2 meters, maximum of 2.5 meters; Installation angle N should be between 30º and 90º (the angle between the electronic tag surface and the horizontal plane).
7
3
Share

What are the 6 non-recognition situations for hit-and-run?

6 non-recognition situations for hit-and-run: 1. When the parties involved in a traffic accident have no dispute over the facts of the accident, leave the scene to negotiate and resolve it on their own, reach an agreement, and leave their real names and contact information, but one party later regrets and reports the case; 2. When the parties involved in a traffic accident drive away from the scene after marking the location of the vehicle and the injured to promptly rescue the injured and report the case in time; 3. When the parties involved in a traffic accident send the injured to the hospital and need to temporarily leave the hospital to raise medical expenses for the injured, with the consent of the injured or their family members, leaving their real information and returning within the agreed time; 4. When the parties involved in a traffic accident leave the scene due to the need for medical treatment for their injuries and fail to report the case in time; 5. When the parties involved in a traffic accident drive away from the scene, and there is evidence to prove that they did not know or could not discover the occurrence of the accident; 6. When there is evidence to prove that the parties involved in a traffic accident were forced to leave the scene due to possible personal injury and reported the case in time.
16
5
Share

Where does the G25 Changshen Expressway run from and to?

The G25 Changshen Expressway runs from Changchun to Shenzhen. Also known as the Changshen Expressway, it is designated as G25 in China's National Expressway Network. This expressway connects Changchun City in Jilin Province with Shenzhen City in Guangdong Province, passing through 11 provinces including Jilin, Inner Mongolia, Liaoning, Hebei, Tianjin, Shandong, Jiangsu, Anhui, Zhejiang, Fujian, and Guangdong. The Daling to Shuangliao section of the Changshen Expressway is part of the national expressway network's Changchun-Shenzhen route and serves as a crucial component of Jilin Province's expressway network plan. This section connects with the Hunchun-Ulanhot and Ji'an-Shuangliao expressways, forming a transportation hub in central and western Jilin with Changchun and Shuangliao as key junctions, radiating multiple expressway routes.
8
3
Share

What are the reasons for the car making a clicking sound and failing to start?

The reason for the car making a clicking sound and failing to start is insufficient battery power, or it could be due to low battery voltage. If the car's headlights or other electrical devices were left on before the engine was turned off, or if there were too many external electrical appliances connected, the battery may be drained. It is important to follow proper vehicle usage practices in daily driving. Before turning off the engine, all electrical devices in the car should be switched off. Low voltage can also cause the car to fail to start and produce a clicking sound. The main reason for low battery voltage is prolonged use, leading to battery aging and reduced charge storage capacity. In such cases, it is recommended that the owner replace the battery with a new one.
19
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.