When the vehicle's lights change from far to near, where has the motor vehicle entered?

1 Answers
Everett
07/29/25 6:32pm
When the distance of a motor vehicle's headlight illumination changes from near to far at night, it indicates that the vehicle may have entered a curved road with mountains on one side. If the lights appear to leave the road surface while driving, be aware that there might be a sharp curve or a large pothole ahead, or it could be a vehicle going uphill reaching the crest. When the lights shift from the center of the road to the side, it suggests an upcoming curve. If the lights move from one side of the road to the other, it indicates a series of continuous curves ahead. The following are regulations for the use of motor vehicle lights: 1. Turn signals: Left for starting, right for stopping, left or right for turning or lane changing, left only for overtaking or U-turns, right only when exiting a roundabout, and must be activated 3 seconds in advance. 2. Hazard warning lights: Used during emergency parking or driving in severe weather conditions. If a motor vehicle breaks down or is involved in an accident at night, obstructing traffic and difficult to move, hazard warning lights, position lights, and tail lights should be activated. 3. Fog lights: Used when driving in severe weather conditions. During foggy conditions, motor vehicles should turn on fog lights and hazard warning lights.
Was this review help?
10
5
Share
More Forum Discussions

What is the Difference Between the Dodge Hellcat and Demon?

Dodge Demon and Hellcat are models of the same class, with no significant changes in appearance but some differences in power. Here are some details about the Dodge Hellcat and Demon: Appearance: The Dodge Demon is the ultimate performance version of the series, featuring a more exaggerated design and equipped with the largest hood heat extractor among mass-produced cars worldwide, with an area twice that of the Hellcat. Power: In terms of power, the Demon is equipped with a 6.2L V8 supercharged engine, delivering a maximum power of 840 horsepower and a peak torque of 1004 Nm. The car incorporates extensive lightweight design, making it 105kg lighter than the Hellcat.
12
1
Share

Where is the AdBlue Nozzle Located?

AdBlue nozzles are installed on the exhaust pipes of diesel vehicles. Their function is to quantitatively inject urea aqueous solution for post-exhaust treatment, thereby reducing nitrogen oxide emissions. The AdBlue nozzle is a wear-prone component and requires frequent cleaning and replacement. Below are methods for cleaning the AdBlue nozzle: 1. Ultrasonic cleaning: A small ultrasonic cleaner (the type used for cleaning glasses) can be used. 2. It is recommended to use hot water as the cleaning solution, with the injection end immersed in the liquid (ensure the electrical connector does not get wet). 4. While cleaning the nozzle with ultrasound, perform a functional test to drive the nozzle for better cleaning results.
15
2
Share

How often is it reasonable to maintain a Honda CR-V?

After the first maintenance, it is sufficient to perform maintenance every 6 months or 5,000 kilometers. Change the engine oil every 5,000 kilometers, and replace the air filter and oil filter every 10,000 kilometers. Relevant information about car maintenance is as follows: Introduction: Car maintenance refers to the preventive work of regularly inspecting, cleaning, supplying, lubricating, adjusting, or replacing certain parts of the car, also known as car servicing. Maintenance Scope: Modern car maintenance mainly includes the maintenance of the engine system (engine), transmission system, air conditioning system, cooling system, fuel system, power steering system, etc.
14
3
Share

What are the methods of engine lubrication?

Engine lubrication methods include: 1. Pressure lubrication: Using an oil pump to continuously deliver lubricating oil under a certain pressure to the friction surfaces, forming an oil film of a certain thickness that can withstand mechanical loads without rupturing, effectively separating the two friction components to achieve reliable lubrication; 2. Periodic lubrication: For less critical and scattered components, lubrication is achieved by periodically applying grease; 3. Splash lubrication: Utilizing certain moving parts of the engine, primarily the crankshaft and camshaft, to splash oil droplets and mist onto friction surfaces for lubrication. The lubrication intensity of various engine components depends on their environment, relative motion speed, mechanical load, and thermal load.
4
1
Share

What to Do About Abnormal Noises When Raising or Lowering Car Windows?

Here are the reasons and solutions for abnormal noises when raising or lowering car windows: 1. A large amount of dust has accumulated in the rubber guide channel of the car window. Clean the dust promptly. 2. The car window seal has aged. Replace the car window seal promptly. 3. Abnormal noise occurs in the car window gear set. Apply lubricating oil to the car window gear set promptly. Additional Content: Methods for Removing Ice from Car Windows: 1. Physical de-icing. Use a plastic scraper or glass frost remover to scrape off the ice from the car. 2. Chemical de-icing. Use a spray de-icer to remove ice from the car.
4
5
Share

Is It Better to Replace Two Tires or All Four?

Tires can be replaced either two at a time or all four. When replacing two, it is essential to replace the two on the same axle. Below is relevant information about tires: Tire Introduction: Tires are the only components of a car that come into contact with the ground. Some car owners only replace the tires on the drive wheels when changing tires. For example, some front-wheel-drive car owners only replace the two front tires, while some rear-wheel-drive car owners only replace the two rear tires. In fact, this practice is acceptable. Tire Aging: Tires are made of rubber and will age over time. It is recommended that car owners replace their tires every four years, even if the mileage is low during that period. This is because tires can also age when left unused for extended periods, so it is important to check the production date when purchasing new tires.
15
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.