When Should Tires Be Replaced?

2 Answers
ODallas
07/24/25 10:10pm
Tires generally have a normal service life of 3 to 5 years, and even if they are not used frequently, it is best not to exceed 8 years. Here is an introduction to car tire wear: 1. Since tires are in constant contact with the ground, they are one of the faster-wearing components on a vehicle. The timing for tire replacement can be determined based on the car's usage and the condition of the tires. 2. First, check the outer rubber of the tire, as it is not easily damaged. Then, examine the tread pattern on the tire. If the pattern is no longer visible, it may be time to replace the tire immediately, as its friction may no longer meet driving requirements. 3. Take the initiative to assess your own vehicle's condition to decide when replacement is necessary.
Was this review help?
1
0
Share
VanGrace
08/10/25 2:55pm
As a seasoned driver with years of experience, I fully understand the dangers of tire issues, especially on highways where shallow treads can easily cause skidding. Tires should be replaced when the tread depth falls below 1.6mm. A simple test is to insert a one-yuan coin into the tread—if the top of the national emblem is visible, it's time to act immediately. I've witnessed a friend's accident in the rain due to delaying this. Additionally, tires older than six years suffer from rubber degradation and deformation, potentially leading to bulges or blowouts. Regularly check for uneven wear, which often indicates suspension problems. Don’t forget seasonal checks; summer downpours make poor drainage particularly deadly. Regular maintenance is key to prevention—safety is far more important than saving money.
Was this review help?
20
5
Share
Expand All
More Forum Discussions

What Causes the Smell of Gasoline While Driving?

Both overfilling the gas tank and fuel pump leakage can cause the smell of gasoline while driving. Reasons for smelling gasoline while driving: Overfilling the gas tank; Fuel pump leakage; Aging of gasoline rubber hoses; Incomplete combustion of gasoline during cold starts; Residuals not cleaned when replacing the fuel pump; Aging or uneven gasket inside the fuel tank cap; Dirty fuel injectors and throttle body; Dirty fuel filter; Dirty gasoline vapor canister. Solutions: Pay attention to the amount of fuel added to avoid overfilling; Replace gasoline rubber hoses; Clean the fuel pump, fuel filter, vapor canister, fuel injectors, and throttle body; Replace the gasket inside the fuel tank cap; Place some deodorizers in the car cabin, etc.
11
1
Share

How to Fix the Steering Wheel Warning Light?

Check the condition of damaged mechanisms; connection points of various components; tire pressure; replace parts if necessary. Possible causes for the light: Generator malfunction causing unstable power supply that triggers the steering wheel light; loose connections in the power steering system leading to partial steering fluid leakage; power steering pump failure; air in the steering system causing abnormal steering; mechanical damage to the steering gear piston cylinder; foreign objects in the steering hydraulic lines causing jamming of the steering pump flow control valve, etc. Common steering wheel malfunctions: Vibration, weak steering response, difficulty in control, unresponsive steering direction, stiff brake pedal when braking, floating steering wheel sensation, etc.
13
0
Share

Can a newly applied paint protection film be exposed to rain?

Newly applied paint protection film should not be exposed to rain. The film requires at least 3 days to ensure the adhesive bonds firmly. Paint protection film washing method: Wash the car regularly, once a week is sufficient, not too frequently. Do not wash the car within the first week after applying the film. Dirt can be wiped clean with a soft microfiber towel and water. Corrosive contaminants (such as oil stains, dyes, bird droppings, etc.) should be cleaned as soon as possible, ideally within 24 hours. Precautions: Avoid directly spraying water at the edges with a pressure washer to reduce the chance of peeling; do not use dirty water for cleaning; do not use acidic or alkaline corrosive cleaners to wash the paint protection film.
16
1
Share

What are the two methods of alternating high and low beams in Subject 3 lighting?

Directly operate the lever under the left-hand steering wheel 2-3 times without switching to low beam first. When simulating lighting that requires alternating high and low beams, it is required to operate the lever continuously three times. Usage methods: If the high beam angle is too high, it can easily dazzle oncoming vehicles and pedestrians around, affecting others' vision, which is very unsafe and impolite. Alternately turning the high beam on and off at night can replace the horn to alert pedestrians and vehicles around to avoid causing too much noise. High beams can be used when driving on highways or in rural areas without streetlights to expand the field of vision. When there is an oncoming vehicle and you need to pass each other, switch to low beam for safety and courtesy. Relevant regulations: When meeting a vehicle from the opposite direction on a road without a central divider or centerline, high beams cannot be used within 150 meters of the oncoming vehicle. High beams cannot be used when meeting non-motorized vehicles on narrow bridges or roads without a central divider or centerline. High beams cannot be used when turning at an intersection controlled by traffic signals. When driving at night without streetlights, poor lighting, or in low visibility conditions such as fog, rain, snow, or dust, high beams cannot be used when a following vehicle is driving close to the vehicle in front in the same direction.
1
2
Share

How Often Should the Keyless Entry Battery Be Replaced?

The lifespan of a keyless entry battery is generally around five years. Here are specific details about car key battery depletion: 1. Remote Control Range: If the car door can be opened from over ten meters away before but now requires being close to the car, it indicates the key battery is depleted. 2. Indicator Light: When pressing the button, if the indicator light is dim, it means the battery is running low. However, key malfunction isn't always due to a dead battery; it could also be caused by nearby power interference. Strong magnetic fields in the vicinity can also affect the remote key's functionality. 3. Unresponsive Behavior: If the remote control for the car door works intermittently, sometimes requiring multiple presses to respond, it indicates the key battery is nearly depleted.
8
0
Share

Which principle must be followed when driving a vehicle?

When driving a vehicle, the following rules must be observed: 1. Traffic rules must be obeyed, and drivers must follow the instructions and inspections of traffic police to maintain traffic order and ensure safe and smooth traffic flow. 2. When driving a vehicle, the driver must possess a valid driver's license, vehicle registration certificate, and road maintenance fee payment receipt. These documents must not be altered, lent to others, or forged. The type of vehicle driven must match the permitted vehicle class. 3. It is strictly prohibited to drive under the influence of alcohol or to allow unlicensed individuals to drive. Motor vehicles must adhere to the right-hand traffic principle. Overloading, forced overtaking, forced merging, and exceeding the passenger capacity in the driver's compartment are not allowed. Additionally, driving vehicles that do not comply with loading regulations is prohibited.
9
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.