···
Log in / Register

When Does the New Year Start for Vehicle Inspection?

3 Answers
MacMadeline
07/30/25 1:47am
It depends on different situations. Additional Information: Operational Passenger Vehicles: Operational passenger vehicles must be inspected once a year within the first 5 years. After exceeding 5 years, they must be inspected every 6 months. This means new operational passenger vehicles require an annual inspection within the first 5 years, and after 5 years of use, they must be inspected every six months, making the inspection frequency more frequent. Conditions for New Vehicles Exempt from Inspection for 6 Years: The motor vehicle must be a non-operational vehicle; the approved seating capacity must be 6 or fewer people. Starting from November 20, 2020, small and micro passenger vehicles with 7-9 seats (excluding minivans) are included in the exemption scope; vehicles that undergo registration procedures within 4 years from the date of manufacture, etc.
Was this review help?
4
3
Share
VanEmiliano
08/15/25 7:38am
I was also quite confused about when the annual vehicle inspection starts when I first bought my car. As a veteran driver with over a decade of experience, let me tell you: For the first 6 years after purchasing a new car, you don't need to go through the hassle of visiting the inspection station every year. Instead, you just need to submit information every 2 years through the traffic management app or online - this is called the exemption from on-site inspection, mainly requiring submission of documents like license plates and insurance policies to prove the vehicle is in good condition. After 6 years, however, you'll need to conduct an actual on-site inspection annually, checking brakes, lights, emissions, etc., to ensure safety. If overdue, you might face a fine of 100-200 yuan and it could affect your insurance renewal. My advice is to complete the exemption formalities on time during the first few years to avoid potential issues during later on-site inspections. For older vehicles, maintenance becomes even more crucial to prevent inspection failures that could cause delays. Remember, annual inspections aren't meant to trouble you but to protect lives - don't procrastinate.
Was this review help?
15
1
Share
Expand All
VonHadley
10/21/25 2:29am
I just bought my first car last year and knew nothing about it, so I asked a lot of people. The new car annual inspection policy is quite considerate: for the first 6 years, you only need to complete the process online every 2 years without having to queue at the inspection station under the sun. However, after the initial 6 years, you must undergo an annual on-site inspection, which includes checks on lights, brakes, chassis, etc. I passed mine in one go last time, all thanks to regular maintenance. Remember to install a traffic management app on your phone to remind you of the dates, so you don’t miss it and avoid trouble. The annual inspection helps uncover potential issues, especially hidden dangers like insufficient lighting or weak brakes, which are crucial for new drivers’ safety. Keep a maintenance record handy to make the inspection easier.
Was this review help?
18
5
Share
Expand All
More Forum Discussions

What Does Clutch Half-Engagement Mean?

Clutch half-engagement refers to the unstable connection state of the clutch. When the driver presses the clutch pedal, the pressure of the clutch pressure plate gradually decreases, causing the driving plate and the driven plate to be in a state of simultaneous rotation and slipping. As the clutch approaches the half-engagement point, the driver can feel increased pressure under the foot, at which point the lifting speed should be slowed down, paused briefly, and then gradually released. When the clutch reaches the half-engagement point, the vehicle may shake, the engine may produce a slight noise, and the sole of the foot may feel a resistance. Manual transmission vehicles often require half-engagement for various operations, but prolonged use of half-engagement can lead to clutch wear. During driving tests, half-engagement is necessary for the field test but prohibited for the road test. The primary functions of the clutch in a vehicle are to ensure smooth starting and to facilitate seamless gear shifting. Ensuring smooth starting: This is the primary function of the clutch. Before starting the vehicle, the engine must be started first. When the vehicle starts, it accelerates from a completely stationary state. Facilitating seamless gear shifting: During driving, the transmission system often needs to switch between different gears to adapt to changing driving conditions.
15
2
Share

Why is the steering light when cold but heavy after warming up?

The reason for light steering when cold but heavy after warming up is due to deteriorated power steering fluid or wear of the power steering pump. Specific causes and solutions are as follows: Deteriorated power steering fluid: The power steering fluid in the hydraulic power steering system serves as the working medium. It should have appropriate viscosity, good viscosity-temperature characteristics, and certain lubrication properties. Normally, the viscosity change of steering fluid is minimal under both high and low temperatures, ensuring similar steering feel across temperature conditions. The solution is to replace the power steering fluid. Worn power steering pump: The power steering pump acts as the power source for the hydraulic power steering system, generating the hydraulic pressure for steering. Severe wear of the pump can result in lower system pressure, making steering heavier. The solution is to repair or replace the power steering pump.
2
0
Share

Where is the vehicle inspection location in Liaocheng?

Liaocheng City's vehicle inspection location is at the Liaocheng Motor Vehicle Inspection Station. Here is an introduction to the relevant content of motor vehicle inspection: 1. Inspection period: There will be no penalty for being one day overdue. Vehicles that exceed the annual inspection period by less than one year can apply for a replacement annual inspection procedure at the vehicle management department without facing penalties. However, if the annual inspection period is exceeded by more than one year, a penalty of 3 points will be imposed, and the vehicle may be temporarily impounded. 2. Penalties for not undergoing inspection on time: For motor vehicles driving on the road without displaying an inspection compliance label, the vehicle will be impounded, and 1 point will be deducted. If compulsory traffic insurance is not purchased, a penalty of twice the amount of the compulsory insurance coverage will be imposed.
16
5
Share

Does Li Xiang have hybrid models?

Li Xiang ONE is a hybrid model. Here is relevant information: Li Xiang ONE powertrain: The Li Xiang ONE adopts the world's most advanced range-extender electric technology, featuring pure electric power with fuel-based range extension, offering an ultra-long range of 800 kilometers to effectively mitigate range anxiety. The Li Xiang ONE eschews the pure electric drive format commonly adopted by new automakers, opting instead for the relatively niche range-extender solution. Operation without charging: The Li Xiang ONE can operate without charging, though fuel consumption will be relatively higher, and the inherent advantages of the "range-extender" system would be lost. Owners can activate the hybrid mode after a full charge, maintaining battery levels at approximately 70%. Fuel consumption vulnerability: When the battery level drops to a certain point, the engine will recharge the battery pack while consuming fuel to power the vehicle, resulting in an overall increase in fuel consumption.
19
4
Share

What Are the Reasons for Valve Noise When Cold but Not When Hot?

The reasons for valve noise when cold but not when hot include unsuitable oil viscosity, low oil pressure, and poor sealing of the hydraulic tappet itself. Unsuitable oil viscosity: If the oil viscosity is inappropriate, especially during cold starts in the morning, air can enter the hydraulic tappet, causing abnormal noise. Low oil pressure: This is due to faults in the car itself, such as issues with the oil pressure relief valve or oil pressure sensor, which result in low oil pressure. This leads to oil leakage in the hydraulic tappet and air ingress, ultimately causing abnormal noise. Poor sealing of the hydraulic tappet itself: There are two reasons for poor sealing. One is wear on the hydraulic tappet itself, and the other is the cooling of the car after being parked for a while. The hydraulic tappet shrinks due to thermal contraction, leading to poor sealing and air ingress. Solutions: Clean carbon deposits and check the oil. Cleaning carbon deposits: Cleaning the carbon deposits helps because, during a cold start, the oil pump cannot immediately establish oil pressure, and oil films cannot form between components. This is especially true for the valves in the cylinder head (upper part), which do not get lubricated during a cold start. Whether it's hydraulic lifters or mechanical rocker arms, there will be some valve clearance, leading to abnormal noise. Check if the oil level is low, then measure the oil pressure. Valve noise when cold but not when hot could be the sound of piston slap or hydraulic tappet noise. It is recommended to clean the engine during the next car maintenance.
6
5
Share

When was the Jetta VS5 released?

In early September 2019, the Jetta VS5 was officially launched at the Chengdu Auto Show as the first SUV model under the Jetta brand. Here is more information about the Jetta VS5: 1. Exterior: The front face adopts Volkswagen's X design elements, extending bidirectionally to the hood and lower grille. The side body lines continue Volkswagen's brand design language, running through the entire vehicle body. 2. Engine: The Jetta VS5 is equipped with Volkswagen and Audi's shared EA211 1.4T 110KW engine, paired with either an MQ250 manual transmission or an Aisin AQ250 six-speed automatic transmission.
4
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.