What will happen if the transmission fluid is not changed?

1 Answers
GraceFitz
07/30/25 7:05am
Symptoms of not changing transmission fluid are as follows: 1. Decreased power. When accelerating, the car responds sluggishly. The engine speed increases with loud noise, but the car does not accelerate. 2. Difficulty in starting. At low gears, pressing the accelerator increases the speed, but the car travels a short distance. 3. Overheating the transmission, damaging bearings and gears. 4. Gear shifting feels jerky, not smooth, and the transmission makes abnormal noises. Additional relevant information: The transmission is a mechanism used to change the speed and torque from the engine. It can fix or change the transmission ratio between the output shaft and the input shaft in steps. It is also called a gearbox, consisting of transmission mechanisms and control mechanisms.
Was this review help?
11
2
Share
More Forum Discussions

Can Dull Car Paint Be Fixed with Clear Coat Spray?

Dull car paint can be temporarily improved with clear coat spray, but the effect won't last long. A complete repaint is recommended. Here's an introduction to paint maintenance: 1. Be cautious with the first wash: The initial cleaning is best done at an indoor dust-free hand wash facility or a high-quality car wash. Some contaminants like tree sap, alkali, and acidic chemical residues are invisible to the naked eye and require special clay bar treatment instead of regular detergent. 2. Be careful with waxing: Some owners wax their new cars immediately after purchase, which isn't advisable. New vehicles come with a factory-applied protective wax layer, and premature waxing will remove this original coating, causing unnecessary waste. Generally, newly purchased cars don't require waxing within the first three months.
2
0
Share

How to Replace the Air Conditioning Filter in a Volkswagen Santana?

Remove the old filter. The white one is the old air conditioning filter; simply pull it out. Before installing the new one, turn on the air conditioner and run it on both cold and hot settings at high fan speed for 3 minutes each. Then, install the new filter with the black side (which contains activated carbon) facing the driver's seat—make sure not to install it backward. Push it firmly upward in this direction until it clicks into place. Additional Information: 1. The air conditioning filter in the Volkswagen Santana is located on the passenger side, beneath the glove compartment near the center console. Look up from the floor to see it. The arrow points to the filter's clips—there are three in total. Gently pull them outward to open the compartment, revealing the air filter. 2. The Kun brand car air conditioning filter is specifically designed for the Santana. The black side contains activated carbon, visible as tiny cylindrical particles evenly distributed within the honeycomb mesh. The filter also features sealing foam around the edges to tightly fit the housing, preventing dust leakage and intercepting surrounding dust.
7
0
Share

Can a Car's Front Windshield Be Repaired?

Front windshield crack repair methods are as follows: 1. Use alcohol and glass cleaner to wipe the area to be repaired clean, and after drying, remove any possible impurities in the crack. 2. Attach an observation board to the inside of the front windshield. 3. Align the center point of the suction cup base with the position to be repaired and secure the four corners. 4. Fix the pressurizing device to the suction cup base, ensuring the position is correct, then unscrew the upper part of the pressurizing rod. 5. Pour the repair liquid into the opening at the top of the pressurizing device, then screw the pressurizing rod back into the base. 6. Wait for the repair liquid to penetrate and solidify, which takes about 10 minutes, then unscrew the pressurizing rod, wait for one minute, and screw it back in to eliminate air inside the crack. 7. Finally, remove the repair device and scrape off any residual repair liquid with a blade.
4
0
Share

Where to Install the Small Round Mirror on the Rearview Mirror?

The installation position of the small round mirror on the rearview mirror: 1. For the right rearview mirror, install it at the lower right corner; 2. For the left rearview mirror, install it at the lower left corner, which provides a clear view of the left rear wheel position. The function of the small round mirror: It can reduce blind spots and prevent scraping accidents. The function of the car rearview mirror is to reflect the situation behind, beside, and below the car, expanding the driver's field of vision and reducing the occurrence of safety accidents. The adjustment method for the rearview mirror is: 1. For the left rearview mirror, place the horizontal line at the midline position of the mirror, then adjust the edge of the car body to occupy a quarter of the mirror image; 2. For the right rearview mirror, place the horizontal line at two-thirds of the mirror's position, then adjust the edge of the car body to occupy a quarter of the mirror image.
14
3
Share

What are the reasons for the anti-skid light to illuminate?

Here are the main reasons why the Electronic Stability Program (ESP) light comes on: 1. Accidentally pressing the ESP-OFF button; 2. Loose or faulty sensor connectors; 3. Short circuits in wiring or related fuse blowouts; 4. Software issues causing poor signal transmission; 5. ABS pump failure. Additional Information: Methods to cancel the ESP light include: 1. Restart the engine and briefly press the ESP-OFF button on the vehicle to check if the ESP was accidentally turned off; 2. Visit a 4S dealership for inspection, use a specialized fault diagnostic tool to identify the issue, repair it, and then use a decoder to clear the fault code. Ensure the ESP operates normally, and the warning light will turn off.
3
4
Share

Which brand does Alto belong to?

Alto is a microcar under Changan Suzuki. The Alto comes with a 1.0-liter engine option, offering both manual and automatic transmissions. The engine delivers a maximum power of 52 kW, a maximum horsepower of 71 PS, and a maximum torque of 92 Nm. Additional information: 1. The 2016 Alto features black paint on the front bumper bottom, side skirts, rear fenders, roof, and A/B/C pillars, along with decals printed around the body, giving it a sporty and fashionable appearance. It adopts a large honeycomb-shaped trapezoidal grille, enhancing visual impact and making the overall design more dynamic. 2. The side mirrors feature a two-tone design, with the black bottom part echoing the anti-scratch strips on the body. The turn signals are not integrated but designed separately. The interior is youthful and lively, with rich lines creating a layered dashboard, and the color scheme is primarily light-toned.
19
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.