What type of vehicle is the Livina?

What are the penalties for using an original driver's license?

After a driver replaces their driver's license, the original license becomes invalid and must not be used further. If a driver continues to use the original license in violation of regulations, the traffic management department of the public security authority will impose a fine and confiscate the original license. In cases where the original license was lost and later found after a replacement was issued, the driver must surrender the original license to the vehicle management office or destroy it themselves, and must not use both licenses simultaneously. Currently, each driver's license has a unique serial number and is managed with computer traceability. After a driver applies for a replacement license, the original license and its serial number will be marked as invalid in the driver's license management system. If the original license is later found and is still within its validity period, it must still be destroyed and cannot be used. If a driver's license is lost, there is no need to report the loss. The driver only needs to bring relevant documents to the vehicle management office to apply for a replacement. During the replacement process, a copy of the ID card will be required, along with a statement on the copy declaring the loss of the original license, to complete the replacement procedure. Additionally, it is important to note that when replacing a driver's license, the accumulated demerit points in the scoring cycle must not reach twelve. This ensures a smooth replacement process. If the replacement is due to damage to the original license, the original will be confiscated on the spot.

5

3

Share

Are there any new regulations for driver's licenses in 2020?

There are new regulations for driver's licenses in 2020, specifically: 1. Self-registration is allowed. The nationwide Internet-based comprehensive traffic safety service management platform will be fully launched, enabling drivers to register online, schedule exams online, and make payments online through this platform; 2. Individuals with monocular vision can obtain a driver's license. Eligible individuals with monocular vision impairment can apply for a motor vehicle driver's license for small cars, small automatic transmission cars, low-speed trucks, three-wheeled cars, and other permitted vehicle types; 3. Relaxation of physical conditions for upper limb disabled individuals to drive. Depending on the degree of finger, palm, or lower limb disability, they can apply for a motor vehicle driver's license for small cars, small automatic transmission cars, low-speed trucks, three-wheeled cars, or small automatic transmission passenger cars specially designed for the disabled.

6

1

Share

How to Extract Fuel from a Car?

To extract fuel from a car, follow these steps: 1. Prepare the necessary tools, including a flat-head or Phillips screwdriver, pliers, a plastic tube approximately 1cm in diameter, a wire, and a container for the gasoline; 2. Open the engine compartment hood and locate the fuel lines connecting the engine and the fuel tank. There are usually three lines: one supply line, one return line, and one carbon canister line. If the owner cannot distinguish between the three lines, all three can be disconnected, and the plastic tube can be connected to the gasoline container; 3. Next, open the vehicle's relay box, locate the fuel pump relay, remove it, and use the wire to short-circuit the 85 and 86 sockets on the relay socket. The relay box cover will have markings, making it easy to identify; 4. Insert the car key and turn it to the "ON" position. For vehicles with a push-button start, press the start button without pressing the brake pedal. Once activated, gasoline will flow out of the fuel line; 5. When the container has collected a sufficient amount of fuel, the owner can turn off the ignition, remove the short-circuit wire, reinsert the fuel pump relay, and finally reinstall the disconnected fuel lines to their original positions.

10

2

Share

What are the precursors to a failing fuel pump?

Precursors to a failing fuel pump include: 1. Weak acceleration with jerking sensations when accelerating suddenly; 2. Difficulty starting the vehicle, requiring prolonged key turning; 3. Unusual buzzing noises while driving; 4. Illumination of the engine warning light; 5. Engine vibration or shaking. The primary causes of fuel pump failure are poor fuel quality, delayed refueling, and prolonged neglect of fuel filter replacement. Severe clogging of the fuel filter in the supply system forces the fuel pump to work harder, leading to damage due to prolonged high-load operation. It is recommended that drivers refuel promptly and choose reputable gas stations to ensure fuel quality and prevent damage to the fuel pump.

4

2

Share

What brand of car has two Cs on top and bottom?

The logo with two Cs on top and bottom represents NIO. Here is relevant information about NIO: 1. The upper and lower parts of the logo symbolize vision and action respectively: the upper part represents the sky, symbolizing openness, future, and goals; the lower part represents the road extending to the horizon, symbolizing direction, action, and forward momentum. NIO stands for 'A New Day'. 2. Brand vision: NIO is not just an automobile brand. By providing high-performance intelligent electric vehicles and ultimate user experiences, NIO is committed to creating a joyful lifestyle for users and building a 'user brand' worldwide.

6

0

Share

Should You Pull Out a Nail Stuck in a Car Tire?

If there is no air leakage after a tire is punctured by a nail, it is best to inspect and confirm the situation. If there is indeed no air leakage, the nail can be pulled out. If air leakage occurs during the process of pulling it out, it is better not to continue removing it. Instead, the nail can be pushed back in, allowing the car to be driven directly to a tire repair shop without needing to change to a spare tire, as the tire can still be driven for a long time if the air leakage is not severe. Tires are made of wear-resistant rubber with a strong yet elastic outer shell that comes into direct contact with the ground. They consist of the bead, belt layer, tread, and carcass. Therefore, repairing a nail puncture on the tread is relatively simple. All that is needed is to remove the wheel and tire for repair. If the nail is only stuck in the outer tread, it can be pulled out without issue. However, if it has penetrated the inner tube, pulling it out will cause air leakage, necessitating a tire repair. Small holes or punctures can be patched. Always check the condition of your tires before heading out, especially before long trips, highway drives, or mountain roads. If the tire shows signs of bulging, it should be replaced as soon as possible. Never overlook the importance of tires—safety comes first.

1

Share

What type of vehicle is the Livina?

What are the penalties for using an original driver's license?

Are there any new regulations for driver's licenses in 2020?

How to Extract Fuel from a Car?

What are the precursors to a failing fuel pump?

What brand of car has two Cs on top and bottom?

Should You Pull Out a Nail Stuck in a Car Tire?

What are the front and rear position lights on a vehicle?

Should the front windshield film be applied on the inside or outside of the car?

What Causes Car Turn Signal Failure?

What Causes the Car to Shake After Starting?