What type of gasoline should be used for the Mercedes-Benz E260?

Why should the vehicle be circled counterclockwise instead of clockwise?

Because China implements right-hand traffic, vehicles are generally parked on the right side of the road. Drivers need to enter the driver's seat from the left side. At this time, conducting a counterclockwise inspection from the left front door ensures that the driver can see oncoming traffic and road conditions from behind, which is safer. Below are the precautions for the Subject 3 driving test: 1. Before starting the test: Circle the vehicle counterclockwise to check its condition. 2. After getting in the vehicle: Adjust the seat position, adjust the rearview mirror angle, and fasten the seat belt. Only after completing these steps can the test begin. 3. During all test items: Listen to voice prompts and do not act before the prompt. Special attention should be paid to the school and bus stop sections where there is no voice reminder. A deceleration and braking action must be performed within 30 meters, but not too early. 4. After completing the roadside parking: Do not rush to get out of the vehicle. Open the door, then close it, and only exit after the voice announcement of the results. Do not forget to close the door after getting out.

16

2

Share

Where is the BCM located on the Cruze?

Under the center of the dashboard, you can see it by removing the trim panel near the passenger side footwell. Below is relevant information about the Cruze: 1. Origin: The highly anticipated all-new Chevrolet compact model, the Cruze, was finally unveiled globally at the Paris Motor Show, revealing its mysterious veil. The Cruze has attracted attention with its avant-garde design style, and its precise manufacturing craftsmanship makes it a potential new benchmark in the compact car segment. 2. Powertrain: In terms of powertrain, the new car continues to be equipped with a 1.5L and a 1.4T engine, with maximum power outputs of 114 horsepower and 150 horsepower, respectively. For the transmission system, the 1.4T model is paired with a 7-speed dual-clutch transmission, while the 1.5L model is matched with a 6-speed automatic transmission and a 6-speed manual transmission.

19

5

Share

What is the Three Guarantees Policy for Vehicles?

The Three Guarantees Policy for Vehicles is as follows: 1. Vehicle Replacement: If the same fault is repaired more than 5 times, the vehicle can be replaced. Within the validity period of the Three Guarantees, if the cumulative repair time exceeds 35 days, or if the same product quality issue leads to more than 5 repairs, the consumer can request a replacement. This applies within 60 days from the date of the purchase invoice issued by the seller or within 3,000 kilometers of driving. 2. Vehicle Return: If the engine is replaced twice and still does not function properly, the vehicle can be returned. Within the validity period of the Three Guarantees, if there have been 2 repairs due to serious safety performance faults and the faults are still not resolved or new serious safety performance faults occur, the vehicle can be returned.

8

4

Share

How many meters long is an eight-wheel truck?

The length of an eight-wheel truck is 4.2 meters. According to Article 54 of the "Implementation Regulations of the Road Traffic Safety Law of the People's Republic of China," the load carried by a motor vehicle shall not exceed the approved load capacity specified in the vehicle's driving license, and the loading length and width shall not exceed the vehicle's body. The following regulations shall also be observed: (1) For heavy and medium-duty trucks and semi-trailers, the height of the load from the ground shall not exceed 4 meters, and for vehicles transporting containers, the height shall not exceed 4.2 meters; (2) For other motor vehicles carrying goods, the height of the load from the ground shall not exceed 2.5 meters. Vehicles are generally classified into six categories based on their purpose: 1. Sedan: Also known as a passenger car, typically seating no more than 9 people (including the driver's seat). 2. Bus: Seating more than 9 people (including the driver's seat), including city buses, highway coaches, and tourist buses. 3. Truck: Commonly known as a lorry, mainly used for transporting goods. 4. Tractor: Specifically designed for towing trailers or semi-trailers. 5. Special transport vehicle: Designed according to the special requirements of the cargo being transported, equipped with dedicated compartments and corresponding auxiliary equipment, such as dump trucks, tanker trucks, refrigerated trucks, bulk cement trucks, and container trucks. 6. Special-purpose vehicle: Mainly used for completing other tasks, such as ambulances, fire trucks, garbage trucks, sprinkler trucks, and various engineering vehicles.

15

4

Share

Why can't the Cruze accelerate when pressing the gas pedal?

The reasons why the Cruze cannot accelerate effectively when pressing the gas pedal can be numerous, such as clutch slippage, throttle system blockage, engine fuel system issues, etc. Below are the relevant explanations: 1. Clutch slippage: Clutch slippage mainly manifests as the vehicle's speed not increasing with the rise in engine RPM during acceleration while driving. The engine's power cannot be fully transmitted to the drive wheels, resulting in weak driving performance, especially noticeable when going uphill. If this situation occurs, it is recommended to repair or replace the clutch promptly. 2. Throttle system blockage: For the car's engine to operate properly, it requires not only fuel but also air; otherwise, the engine cannot run smoothly. The most common intake problems likely occur in the air filter or throttle system blockage. If these small components malfunction, they can cause insufficient air intake. If these parts are problematic, timely repair or replacement is necessary.

15

2

Share

What procedures are required to change an operating vehicle to a non-operating one?

No special conditions are required; the vehicle owner can apply to the local vehicle management department. Additional information: Safety inspection requirements for operating and non-operating vehicles: Safety technical inspections should be conducted according to the following periods: 1. Operating passenger vehicles must be inspected once a year within 5 years, and every 6 months after exceeding 5 years. 2. Trucks and large or medium-sized non-operating passenger vehicles must be inspected once a year within 10 years, and every 6 months after exceeding 10 years. 3. Small and micro non-operating passenger vehicles must be inspected once every 2 years within 6 years, once a year after exceeding 6 years, and every 6 months after exceeding 15 years. 4. Motorcycles must be inspected once every 2 years within 4 years, and once a year after exceeding 4 years.

18

2

Share

What type of gasoline should be used for the Mercedes-Benz E260?

Why should the vehicle be circled counterclockwise instead of clockwise?

Where is the BCM located on the Cruze?

What is the Three Guarantees Policy for Vehicles?

How many meters long is an eight-wheel truck?

Why can't the Cruze accelerate when pressing the gas pedal?

What procedures are required to change an operating vehicle to a non-operating one?

Is BYD a Car for the Poor?

What are the test items for C1 Subject 2?

Is It a Problem to Leave a Car Parked for a Week?

The Meaning of 'Drive a BMW, Ride a Mercedes'