What type of engine oil is used in the Fit?

1 Answers
McCooper
07/28/25 5:43pm
The Fit uses 0W20 engine oil, with an oil capacity of 3.6 to 3.7 liters. The Fit is a hatchback launched by GAC Honda, with body dimensions of 4065mm in length, 1695mm in width, and 1525mm in height. In terms of power, the Fit is equipped with a 1.5L Earth Dreams engine codenamed L15B2. The 1.5L Earth Dreams engine can deliver 131 horsepower, providing strong performance while achieving a fuel consumption of only 6.1L per 100 kilometers. Exterior-wise, the Fit adopts Honda's family-style design, featuring chrome trim on the grille, a glossy black panel in the center, and adjustments to the bumper, lower air intake, and fog light areas on both sides, giving it a cleaner and more streamlined appearance.
Was this review help?
9
0
Share
More Forum Discussions

What Causes Engine Shaking in a New Car?

The causes of engine shaking in a new car are: 1. Improper air-fuel mixture ratio in the engine compartment; 2. Poor fuel quality; 3. Faulty electronic control system. Precautions for driving a new car include: 1. Maintain smooth starts, avoid sudden acceleration, and do not let the engine RPM run too high; 2. Before starting, ensure the coolant temperature reaches at least 50°C, start in a low gear, and shift to a higher gear after 1 kilometer; 3. Shift gears promptly while driving, avoid prolonged use of a single gear, and refrain from using high gears at low speeds or low gears at high speeds; 4. Choose good road surfaces to avoid excessive vibration and impact, and disengage the clutch before braking; 5. Use high-quality fuel and engine oil, and avoid using engine wear-resistant additives.
1
4
Share

Why do valves make noise when hot but not when cold?

The reason why valves make noise when hot but not when cold: This situation indicates that there is a gap in the valves. Solutions for valve noise: 1. Check if the engine oil is insufficient. 2. If the engine oil is normal, the valves need to be replaced. Below is relevant information about valve noise: 1. Cold start of the car: When the car has been parked for a long time and the engine is started at the same temperature as the environment. During a cold start, you may hear a "clicking" sound from the engine compartment. This abnormal noise sounds very unusual, unlike the normal operation of the car. Even some new cars may experience this during the break-in period, with the engine making loud noises when started, which normalizes after the engine warms up. 2. During a cold start of the engine, due to the thick and poor fluidity of the engine oil, there may be operational noise for a short period, and slight sounds may occur when various moving parts come into contact, which is a normal phenomenon.
11
4
Share

Is the Nissan Patrol a Hardcore Off-Road Vehicle?

Nissan Patrol is indeed a hardcore off-road vehicle. The Patrol is a large 5-door, 7-seat SUV with the following dimensions: length 5165mm, width 1995mm, height 1955mm, wheelbase 3075mm, and a fuel tank capacity of 100 liters. It features a front-engine, four-wheel-drive layout and is equipped with double-wishbone independent suspension on both front and rear axles. The Patrol is powered by a 4.0L naturally aspirated engine paired with a 7-speed automatic transmission, delivering a maximum power of 205 kW at 5600 rpm and a peak torque of 394 Nm at 4000 rpm.
11
1
Share

How to Connect Power to a Car Refrigerator?

Simply connect the power cord directly between the car refrigerator and the power source. Precautions for using a car refrigerator: 1. It is best to place the refrigerator in a stable location, such as the back seat or the trunk of the car. Additionally, when placing it, pay attention to the refrigerator's cooling vents and ensure they are not blocked, as this could easily damage the refrigerator. 2. For compressor-type car refrigerators, incorrect placement angles may cause the compressor to shut down. 3. If the car refrigerator has a built-in battery protection module, there is no need to manually turn off the refrigerator's power even when the engine is off. This type of refrigerator can automatically detect the battery voltage and will adjust the refrigerator's frequency or shut it down when the car battery is low. 4. For car refrigerators without a battery protection module, always disconnect the power when the car is turned off to prevent battery drain.
10
3
Share

Where should the motor vehicle inspection sticker be placed?

The motor vehicle inspection sticker should be placed on the upper right corner of the vehicle's windshield. There are several methods to attach the motor vehicle inspection sticker: 1. Peel off the sticker and directly attach it to the upper right corner of the front windshield. This method is generally not recommended as it is difficult to remove, requires significant effort, and may leave marks. Especially if the windshield has a heat-insulating film, removing the sticker may damage the film, which is not worth the effort. 2. Static cling method. Many insurance companies provide static clings when you purchase insurance, usually giving three at a time. Peel off the inspection sticker and attach it to the static cling, then place the static cling on the upper right corner of the front windshield. The advantage of this method is easy removal without leaving marks. Be careful not to place it upside down. If the insurance company does not provide static clings, you can purchase them on Taobao at a low price. 3. Lamination method. Take the inspection sticker to a copy shop to have it laminated. After laminating the sticker, apply a small piece of transparent tape to each of the four corners and attach it to the windshield. This method allows for easy removal without affecting aesthetics or leaving any marks.
18
1
Share

What Causes the Rattling Sound When Accelerating Hard?

There may be several reasons for the rattling sound when accelerating: 1. First, you should check the engine oil yourself. If the oil hasn't been changed for a long time or has deteriorated, it will increase friction between the cylinder valves and guides, as well as hydraulic lifters, causing abnormal noises when accelerating. 2. Due to long-term torsional fatigue and impact forces, the car's half-shafts are prone to bending, twisting, breaking, or wear and misalignment of spline teeth. This can lead to regular shaking of the car's front end when accelerating within a certain speed range, accompanied by a rattling sound. The shaking disappears or lessens when you release the accelerator. 3. A loose engine belt can cause a squealing sound. Once the belt slips, the resulting friction and high heat will stretch the belt further, worsening the slippage and creating a vicious cycle. In this case, you should visit a repair shop to adjust the belt.
16
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.