What Type of Engine Oil Does the Skoda Kamiq Use?
1 Answers
The Skoda Kamiq uses engine oil of the VW50200 specification (or higher VW standards compatible with VW50200). The replacement capacity is 4 liters, and the replacement interval is 10,000 kilometers. Before changing the oil, the vehicle's engine should be turned off for 30 minutes to allow the oil to flow back from the cylinder walls to the oil pan, otherwise, there will be residual oil. 1. First, remove the engine cover. (Lift the four clips of the cover) 2. If possible, operate on a lift or use an electric oil pump to directly extract the oil. Pull out the oil dipstick, insert the extraction hose into the dipstick hole until the hose touches the bottom. 3. Extracting the oil takes about 15 minutes; collect the old oil in a waste container. 4. After the oil is extracted, use a socket and wrench to remove the oil filter, wipe off any excess oil from the contact area, and then install the new oil filter. (Tip: Usually, the oil filter is placed on top, but some models have it located at the bottom.) 5. After adding new oil, check the oil level using the dipstick. The first time you pull out the dipstick, wipe it clean with a tissue before reinserting it, then pull it out again to check. The dipstick has upper and lower limit marks, and the oil level should normally be between these two marks.