What traffic principles must be followed when driving a motor vehicle?

1 Answers
WalterAnn
07/30/25 7:11am
Driving a motor vehicle must adhere to the right-side traffic principle, as clearly stipulated in Article 35, Chapter 4 of the Road Traffic Safety Law of the People's Republic of China. Both motor vehicles and non-motor vehicles must follow right-side traffic, which means driving on the right side of the road in the direction of travel. Requirements for driving a motor vehicle: To drive a motor vehicle, one must legally obtain a motor vehicle driver's license. Drivers should operate motor vehicles according to the vehicle types specified on their driver's license and must carry the license with them while driving. The traffic management department of the public security authorities conducts regular reviews of motor vehicle driver's licenses in accordance with laws and administrative regulations. Individuals holding a foreign motor vehicle driver's license who meet the driving permit conditions specified by the public security department under the State Council and pass the assessment by the traffic management department of the public security authorities may be issued a Chinese motor vehicle driver's license. Before driving a motor vehicle on the road, the driver should thoroughly inspect the vehicle's safety and technical performance. It is prohibited to drive a motor vehicle with incomplete safety facilities or components that do not meet technical standards, posing potential safety hazards.
Was this review help?
3
0
Share
More Forum Discussions

How to Replace the Headlight Bulb of Arrizo 5?

Arrizo 5 bulb replacement steps are as follows: 1. Turn off the vehicle power, open the engine hood, and wait until the engine and cooling system are in a cold state before starting the replacement. Locate the headlight plug that needs to be replaced from the rear of the headlight and unplug it. 2. Rotate the old bulb counterclockwise to remove it and install the new bulb. Be careful not to hold the bulb glass directly with your fingers, as fingerprints left on it will evaporate when the bulb is lit, depositing on the mirror surface and dimming the beam. 3. Reinstall the replaced bulb back into the socket and plug in the connector. 4. After installation, test the bulb effect. If necessary, adjust the light projection angle using a cross-head screwdriver at the adjustment port behind the headlight.
19
0
Share

How to Remove the Rear Seats of a Volkswagen?

There are two red buckles on both sides of the rear seats of a Volkswagen. Press the two red buttons on the rear seats simultaneously with both hands and pull downward to release the seats. Then, unfasten the seatbelt buckles on the rear seats to complete the removal. Below is some relevant information about car seats: Car seats are generally divided into two types: leather seats and fabric seats. Leather Seats: 1. Easy to clean. Dust only settles on the surface of leather seats and does not penetrate deep into the material, so a simple wipe with a cloth is sufficient for cleaning. In contrast, fabric seats may require purchasing seat covers, as stains can seep into the interior of the seats. 2. Heat dissipates quickly. A few pats with your hand can disperse the heat, or after sitting for a while, you won't feel the heat. Fabric Seats: 1. The surface is less prone to damage, resulting in a longer lifespan. 2. Provides stable and slip-resistant seating. Sitting on fabric seats does not give a slippery feeling.
8
3
Share

Can China V vehicles still be registered in Foshan?

No, the registration of China V vehicles in Foshan was halted on July 1, 2019. According to the Ministry of Environmental Protection's timeline, the implementation of the China VI standard was originally planned in two phases: the first phase aimed to popularize the China VI-A standard by July 2020, and the second phase aimed to fully implement the China VI-B standard by 2023. Some regions piloted the China VI standard before July 1, 2019, meaning that registration of China V vehicles was stopped in these areas from that date. Below is relevant information about the China VI standard: 1. To alleviate environmental pressure, China's vehicle emission standards have been continuously updated. The China V standard was officially implemented in 2017, and the country transitioned to the China VI standard in 2020. The "China VI standard" for light-duty vehicles was implemented in stages, with two emission limit schemes—China VI-A and China VI-B—rolled out in 2020 and 2023, respectively. 2. Some regions piloted the China VI standard before July 1, 2019, which also means that vehicles meeting the China V emission standard could no longer be registered in cities implementing the China VI emission standard.
1
4
Share

What is the abbreviation for Shandong vehicles?

The abbreviation for Shandong is Lu, where Lu represents Shandong Province, and A represents Jinan City. Therefore, LuA is the license plate code for Jinan City. The significance of a license plate number to a vehicle is akin to that of an ID number to a person. Below is relevant information about the license plate codes for various cities in Shandong Province: License plate codes for cities in Shandong Province: LuA Jinan, LuB Qingdao, LuC Zibo, LuD Zaozhuang, LuE Dongying, LuF Yantai, LuG Weifang, LuH Jining, LuJ Tai'an, LuK Weihai, LuL Rizhao, LuM Binzhou, LuN Dezhou, LuP Liaocheng, LuQ Linyi, LuR Heze, LuS Laiwu, LuU Qingdao supplementary, LuV Weifang supplementary, LuW Provincial Government Agencies, LuY Yantai supplementary
13
2
Share

How to Use the Cruise Control on the Teana?

Nissan Teana's cruise control buttons are located on the right side of the steering wheel. When the speed exceeds 30km/h, you can press the button to activate cruise control. Here are the specific instructions: 1. Press RES to resume cruise control, while CANCEL is to deactivate it. 2. The cruise control function does not activate immediately after turning on the switch. The SET button is for setting; press it to adjust the desired speed. (Note: The cruise control function cannot be used when the speed is below 30km/h.) 3. The plus and minus buttons are used to adjust the speed value, with up and down controlling speed increase and decrease respectively.
19
0
Share

What is the mandatory scrapping period for new vehicles?

Non-operational vehicles and operational vehicles have different scrapping periods, as detailed below: Scrapping regulations for non-operational vehicles: For household 5-seat sedans and 7-seat SUVs, as well as small and micro non-operational vehicles, there is no usage period limit. When the normal mileage reaches 600,000 kilometers, the state will guide the scrapping process. In addition to the above vehicles, small and micro non-operational passenger vehicles, large non-operational sedans, and wheeled special machinery vehicles also have no usage period limit. Common scrapping regulations for operational vehicles: Small and micro taxi passenger vehicles have a scrapping period of 8 years, medium-sized taxi passenger vehicles have a scrapping period of 10 years, and large taxi passenger vehicles have a scrapping period of 12 years. Public transport passenger vehicles have a scrapping period of 13 years, other small and micro operational passenger vehicles have a scrapping period of 10 years, and large and medium operational passenger vehicles have a scrapping period of 15 years. Micro operational trucks have a scrapping period of 8 years, while light and large operational trucks have a scrapping period of 10 years. The vehicle scrapping process is as follows: The vehicle owner applying for scrapping and renewal must fill out the "Motor Vehicle Change, Transfer, Modification, Suspension, and Scrapping Approval Application Form" in duplicate and affix the owner's seal. The registration office will accept the application and issue a "Vehicle Scrapping Notice" for vehicles that have reached the scrapping period. For vehicles that have not reached the scrapping period, the motor vehicle inspection office will determine if they meet the scrapping standards and issue a "Vehicle Scrapping Notice" if applicable. The vehicle owner can choose a qualified recycling company to dismantle the vehicle with the "Notice". The recycling company will dismantle the vehicle and take photos after verifying the "Notice". The engine must be separated from the vehicle, the engine block must be broken, and the chassis must be cut. The vehicle owner must submit the "Change Form", "XX Province Updated Vehicle Technical Appraisal Form", "Scrapped Vehicle Recycling Certificate", and photos of the dismantled vehicle to the motor vehicle inspection office for verification and signature. The license plates will be reclaimed, and the case will be submitted for approval according to regulations to complete the scrapping registration. Special notes: According to Article 30 of the "Motor Vehicle Registration Regulations", if a vehicle is damaged and cannot be driven back to the registration location, the owner can sell the scrapped vehicle to a local motor vehicle recycling company. Operational vehicles converted to non-operational status must still be scrapped according to the original operational vehicle's scrapping period. According to Article 43 of the "Motor Vehicle Registration Regulations", after completing the transfer or cancellation of a motor vehicle's registration, the original owner can apply to the vehicle management office to use the original license plate number when registering a newly purchased vehicle. The application must meet the following conditions: (1) the application must be submitted within six months after the transfer or cancellation; (2) the owner must have owned the original vehicle for more than three years.
2
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.