What to Do When Tire Pressure is Low?

2 Answers
MaverickMarie
07/25/25 9:15am
Tire pressure is too low, the solution is to go to the repair shop for repair. Repair: If the tire can still continue to drive, go to the nearest tire repair shop for treatment. If the tire pressure is too low to drive, if there is a car inflator pump, you can inflate a little, and then go to the nearest repair shop, or replace the spare tire, and then go to repair. Introduction to Tire Pressure: Low tire pressure increases the contact area between the tire and the ground, leading to severe deformation of the tire side and accelerated aging, thereby laying hidden dangers for tire blowout. Although low tire pressure brings comfort and smoothness when driving, it will increase fuel consumption, accelerate tire wear, and reduce service life.
Was this review help?
7
5
Share
VanCalvin
08/11/25 7:14pm
Low tire pressure indeed requires prompt attention, as it can accelerate tire wear, increase the risk of a blowout, and negatively impact handling and fuel efficiency. I usually start by finding a safe place to pull over to avoid potential accidents from continued driving. Then, I use a tire pressure gauge to measure the pressure in each tire, confirming whether it’s truly below the recommended value—typically found on the door frame or in the vehicle manual. If the pressure is low, I head to the nearest gas station to use their free air pump, or if I have a portable inflator, it’s even more convenient to top up the tires right by the car. When inflating, I take it slow, setting the target pressure to avoid overinflation, and double-check afterward to ensure consistency. If the tire frequently loses pressure, it might have a puncture or leak, requiring a visit to a professional repair shop for a fix. It’s a good habit to check tire pressure every two weeks, especially during sudden temperature drops or long trips, as maintaining proper pressure protects the tires, saves fuel, and provides peace of mind. I recommend keeping a tire pressure gauge and a small air pump in the car for emergencies.
Was this review help?
18
1
Share
Expand All
More Forum Discussions

How to remove the water pump of Volkswagen CC?

Volkswagen CC water pump removal method: First, the throttle needs to be removed, then the inlet pipe should be taken off. The water pump removal is relatively troublesome, so it's generally better to have it repaired or replaced at an auto repair shop. As a crucial component for maintaining the engine's normal temperature, the car water pump is indeed very important. However, improper use may easily damage the car water pump. The Volkswagen CC is a model under FAW-Volkswagen, with body dimensions of 4817mm in length, 1855mm in width, and 1417mm in height, and a wheelbase of 2712mm. In terms of configuration, the Volkswagen CC is equipped with numerous technological features such as lane change assist, MKE fatigue reminder, Dynaudio international top-tier audio brand, dynamic light assist system, 6.5-inch multimedia touch screen, and Easyopen trunk opening function.
2
0
Share

Do I Need to Retake Subject One When Switching to Automatic Transmission?

If you have already passed the manual transmission driver's license Subject One test and the vehicle management office has issued a learning driving certificate, you will need to retake Subject One when switching to an automatic transmission driver's license. If you have registered for a manual transmission driver's license test but have not yet taken the Subject One test, you can change the relevant procedures with the driving school and pay the additional fees to switch to an automatic transmission driver's license test. Passing Score for Subject One: The total time for the Subject One test is 45 minutes. The test paper consists of 100 questions, including true/false questions and single-choice questions, with a full score of 100 points. A score of 90 or above is required to pass. The test questions are randomly selected and combined by the computer driver examination system according to the proportion specified in the "Motor Vehicle Driver's License Work Regulations." Subject One Test Content: Basic knowledge of motor vehicles; laws, regulations, and road traffic signals; basic knowledge of safe driving and civilized driving; basic knowledge related to motor vehicle driving operations.
20
2
Share

What engine does the Volkswagen New Santana have?

The Volkswagen New Santana is equipped with a 1.5L engine, delivering a maximum power output of 81 kW and a maximum torque of 150 Nm. It comes with two transmission options: a 5-speed manual transmission and a 6-speed automatic manual transmission. The Volkswagen New Santana is a compact sedan with body dimensions of 4475mm in length, 1706mm in width, and 1469mm in height, and a wheelbase of 2603mm. The front suspension of the New Santana uses a MacPherson independent suspension, while the rear suspension employs a torsion beam non-independent suspension. It is quite common for compact sedans to use a torsion beam for the rear suspension, which also helps to expand the rear seating space and trunk space.
13
0
Share

Is it cleaner to extract or drain engine oil?

Changing engine oil by draining is the cleaner method. Reasons why draining is cleaner: The drain plug is located at the lowest point of the oil pan, allowing nearly all the engine oil to be drained out. During the draining process, you can visually inspect the condition and color of the old oil to assess the engine's operating status. Additionally, impurities settled at the bottom of the oil pan can be removed, and metal shavings attached to the drain plug can be cleaned promptly to prevent contamination of the new oil. Precautions for changing engine oil: After driving the car into the service bay, let the engine run for a few minutes before shutting it off. This allows the oil in the oil passages to flow back into the oil pan. As the oil flows back, metal shavings in the oil will also settle to the bottom of the oil pan. The drain plug at the very bottom is magnetic and can attract and hold these settled metal shavings.
19
5
Share

How to Set Up the Auto-Lock Feature on the Ford Kuga?

The auto-lock feature on the Ford Kuga cannot be set up directly as it is a hidden function. To enable the auto-lock feature, you need to perform a system update (commonly referred to as 'flashing') to activate it. Once enabled, the vehicle will automatically lock when it exceeds a certain speed or when the key is removed. The purpose of the auto-lock feature is to enhance anti-theft security, allowing the doors to lock quickly after driving to prevent potential door-pull robberies during traffic jams or at red lights, thereby providing an additional layer of safety. The Ford Kuga is a compact SUV produced by Changan Ford. In terms of body dimensions, it measures 4524mm in length, 1838mm in width, and 1701mm in height, with a wheelbase of 2690mm.
10
0
Share

What are the starting steps for the Volkswagen Magotan?

Volkswagen Magotan starting steps are: 1. Insert the Magotan key into the first position. At this time, a yellow steering wheel light will appear at the 20 mph mark on the dashboard, indicating that the steering wheel is being unlocked; 2. After the yellow steering wheel light goes out, indicating the steering wheel is unlocked, insert the Magotan key into the second position. The steering wheel light will continue to illuminate, but the color changes to red, indicating that the steering wheel power assist system is undergoing self-check; 3. Once the yellow airbag light at the 50 rpm mark on the tachometer goes out, you can press the key to fully start the Magotan's engine. The Magotan is a B-class sedan under FAW-Volkswagen, with body dimensions of 4866mm in length, 1832mm in width, and 1464mm in height, and a wheelbase of 2812mm. In terms of power, the Magotan is equipped with a 1.8TSI engine, paired with a 6-speed Tiptronic automatic manual transmission.
17
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.