What to Do When the Tire Overheating Warning Light Comes On?

1 Answers
MaddoxLee
07/30/25 1:37am
Most of the time, it is due to abnormal tire pressure or possibly because the surface temperature of the tire is too high. Both excessively high and low tire pressures are considered abnormal and are detrimental to driving safety. Therefore, it is recommended to promptly adjust the tire pressure to ensure it falls within the normal range. If you have been driving for an extended period, it is best to take appropriate breaks to allow the tires to cool down naturally. Below are the specific reasons for high tire temperature: 1. Prolonged contact with high-temperature road surfaces: Heat accumulation intensifies, leading to a rapid decline in the mechanical properties of the tire rubber. Additionally, due to the principle of thermal expansion and contraction, excessively high temperatures will increase tire pressure. When the tire's strength is insufficient to withstand the pressure, a blowout becomes inevitable. 2. Excessive driving speed: When a vehicle moves at high speed, most of the kinetic energy is absorbed and converted into heat, causing the tire temperature to rise. This accelerates rubber aging and reduces the fatigue resistance of the cord layers, leading to early tire separation or blowouts. 3. High external temperatures: Especially in summer, road surface temperatures often exceed 70°C, making it difficult for the accumulated heat in the tires to dissipate. This causes a sharp rise in tire temperature and an increase in internal pressure, thereby accelerating rubber aging.
Was this review help?
6
3
Share
More Forum Discussions

Where Should Windshield Washer Fluid Be Added in a Car?

Pull the engine compartment lever inside the driver's cabin to open the hood, locate the windshield washer fluid filler port, open the cap, and add the fluid. Below is more information about windshield washer fluid: 1. There are not many requirements for windshield washer fluid specifications, but never use tap water. 2. Minerals in tap water can clog the windshield washer fluid lines. 3. Summer windshield washer fluid is mainly used to remove insect residues from the glass. 4. Windshield washer fluid can clean debris off the windshield, eliminate static charges on the glass surface, reduce friction between the wipers and the glass, and prevent scratches.
11
2
Share

How to Reset the Maintenance Light on a Buick?

To reset the maintenance light on a Buick, follow these steps: 1. First, turn off the ignition switch of your Buick LaCrosse. 2. Next, press and hold the trip odometer reset button on the Buick's dashboard. You must keep holding this button until the maintenance light reset is complete. 3. While holding the trip odometer reset button, turn the ignition switch back on. 4. Finally, the odometer will begin counting down. When the display shows 0000.0, immediately release the reset button. This will successfully reset the maintenance light on your Buick LaCrosse.
5
5
Share

How to Adjust the High Clutch of Elantra?

Elantra clutch adjustment method is to release the handbrake, locate the clutch, and use a wrench. The following are the steps to adjust the Elantra clutch: 1. Park the car under the lift and release the handbrake. Locate the position of the chassis jacking point. Raise the lift foot to the position of the chassis jacking point. 2. Lift the vehicle. Find the clutch location, and the clutch cable will appear next to the clutch. 3. Use a wrench to loosen the screws on one side. If the clutch is too low, loosen the left screw and tighten the right screw. If the clutch is too high, loosen the right screw and tighten the left screw to the right.
19
0
Share

What is the reason for the Audi air conditioning screen not displaying?

Audi air conditioning screen not displaying may be due to disconnected vehicle linkage or host system crash. Check the vehicle's connection wiring: If the Audi air conditioning screen is not displaying, it might be because of wiring disconnection. First, inspect the vehicle's connection wiring to identify the specific fault cause, then address it accordingly. If the vehicle's display screen fails to pop up, it may affect the normal use of the vehicle navigation. Remove the upper decorative panel of the screen: Remove the upper decorative panel of the screen to check where exactly the problem lies, whether it's due to mechanical failure or other issues. Do not forcibly bend the screen when problems occur, as this may cause screen damage.
1
2
Share

Where Are the Three Pedals Located in a Car?

Generally, manual transmission cars have three pedals, arranged from left to right as the clutch pedal, brake pedal, and accelerator pedal. The standard operation distribution involves using the left foot to control the clutch pedal and the right foot to control the brake or accelerator pedal. The functions of the car's clutch pedal, brake pedal, and accelerator pedal are as follows: 1. Clutch Pedal: Its function is to control the vehicle speed at low speeds; to disconnect and connect power transmission for gear shifting operations. 2. Brake Pedal: Its function is to brake, reduce the vehicle speed, and bring the vehicle to a stop. 3. Accelerator Pedal: Its function is to adjust the throttle opening, thereby increasing the vehicle speed.
12
1
Share

What is the main function of the oil pump?

The function of the oil pump: To pressurize the oil from the oil pan and deliver it to the oil filter and various lubrication channels, thereby lubricating the main moving components of the engine and ensuring the oil is filtered. More information about the oil pump is as follows: 1. The oil pump is a lightweight and compact pump, mainly categorized into in-line, distributor, and unit types. The oil pump requires a power source to operate, with the lower camshaft driven by the engine crankshaft gear. 2. The key aspect of the oil pump lies in the word "pump." The quantity, pressure, and timing of oil pumping must be extremely precise and automatically adjusted according to the load.
16
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.