Browse
For Sale
Antiques CollectiblesApparelBaby Kids ItemsBooks， Movies And MusicElectronicsFree StuffGarden OutdoorHealth BeautyHome GoodsHome Improvement SuppliesMusical InstrumentsOffice SuppliesPet SuppliesSporting GoodsTicketToys GamesTransportationOthers
Jobs
AccountingAdministration & Office SupportAdvertising， Arts & MediaBanking & Financial ServicesCall Center & Customer ServiceCEO & General ManagementCommunity Services & DevelopmentConstructionConsulting & StrategyDesign & ArchitectureEducation & TrainingEngineeringFarming， Animals & ConservationGovernment & DefenseHealthcare & MedicalHospitality & TourismHuman Resources & RecruitmentInformation & Communication TechnologyInsuranceLegalManufacturing， Transport & LogisticsMarketing & CommunicationsMining， Resources & EnergyReal Estate & PropertyRetail & Consumer ProductsSalesScience & TechnologySelf EmploymentSport & RecreationTrades & ServicesOther
Property
BuyRent
Cars
Used CarsNew CarsOthers
Services
BusinessCraftsDesign And WebEventsHome ImprovementLegalLessonsPersonalPetsPhotographyRepair And Technical SupportWellnessWriting， Translation， And TranscriptionOthers
Community
Activities & GroupsArtists & MusiciansClasses & LessonsEventsFriendship & NetworkingLost & FoundRideshareSports TeamsVolunteersTravel & Travel PartnersSkills & Language SwapOther

What to Do When the Reversing Camera Guidelines Are Offset to the Right?

1 Answers
LeAubree
07/30/25 7:36am
Enter [System Settings], press and hold [Guideline Settings] for more than 15 seconds, then click [Factory Mode] and [Default Mode] to check if the issue is resolved. Use your finger or a stylus to press and hold the white dotted-line box at the end of any red, yellow, or green guideline, then drag it to your desired position.
Was this review help?
3
4
Share
More Forum Discussions

Where is the ETC device installed?

The ETC is generally installed in the upper middle part of the front windshield for most vehicles, while for large vehicles like trucks and buses, it is installed in the lower middle part. The appropriate installation position should be no lower than 1.2 meters and no higher than 2.5 meters, with an installation angle between 30 to 90 degrees. For vehicles with pre-installed or aftermarket explosion-proof film, which may affect the signal transmission of the microwave communication link, the ETC should be installed in the microwave sunroof strip. ETC stands for Electronic-Toll-Collection, meaning electronic toll collection system. To apply for ETC, the vehicle owner needs to provide their valid ID card and the original and photocopy of the vehicle registration certificate. If the application is made by a non-owner, the agent's valid ID card is also required. The photocopy of the vehicle registration certificate should include the page with the most recent annual inspection stamp. A bank card for deducting highway tolls is also needed, and the vehicle must be registered under the name of an individual aged between 18 and 60. For company vehicles, the required documents are: An introduction letter from the vehicle owner (with official seal); Copy of the organization code certificate or business license (with official seal); Original ID card of the agent; Original vehicle registration certificate; The vehicle that needs to have ETC installed. Here are some precautions for installing ETC: Do not obstruct the view, it's best to install it behind the rearview mirror: Many car models have a large inclination angle of the windshield, which can reduce the driver's field of vision. If this is not considered during ETC installation, it can increase the driver's blind spot. Installing it on the right side behind the rearview mirror can avoid obstructing the view. Do not affect charging: The ETC electronic tag consumes power, but generally does not require charging or battery replacement because it has a solar panel on the back that can charge itself. Therefore, during installation, avoid the blackened areas on the windshield and do not install it where the solar panel can be easily blocked. Do not remove it casually once installed: The button in the middle of the adhesive is an anti-removal lever, connected to a switch underneath. After the electronic tag is installed, the windshield will press the anti-removal lever in. If it is removed casually, the lever will pop out and trigger the switch, locking the electronic tag and making it unusable. You will then need to go to an ETC service point to unlock it. This is designed to prevent multiple vehicles from sharing one device.
5
3
Share

What Are the Buick Business Vehicle Models?

Buick has two business vehicle models: the GL6 and the GL8. Below is more detailed information about Buick's business vehicles: 1. GL6: The vehicle's length, width, and height are 4692mm, 1794mm, and 1627mm respectively, with a wheelbase of 2796mm. The front suspension is a MacPherson independent suspension, and the rear suspension is a multi-link independent suspension. It is equipped with a 1.3-liter three-cylinder turbocharged engine, delivering a maximum power of 120 kW, a maximum torque of 230 Nm, and a maximum power speed of 5500 rpm. 2. GL8: The vehicle's length, width, and height are 5238mm, 1878mm, and 1776mm respectively. The front suspension is a MacPherson independent suspension, and the rear suspension is a torsion beam non-independent suspension. It is equipped with a 2.0T turbocharged engine, producing a maximum torque of 350 Nm and a maximum power of 174 kW.
14
0
Share

What does RST mean on a car?

RST on a car stands for reset, which is the abbreviation of the English word 'reset'. It is usually not a port but just a small hole with a tiny switch inside that can restore the navigation system to factory settings. This means that when the navigation system freezes or the program malfunctions, you can use this button to reset it, and the navigation will function normally again. A common scenario that triggers a reset is when a connection request arrives, but there is no process listening on the destination port. For UDP, when a datagram arrives at a destination port that is not in use, it will generate an ICMP port unreachable message, while TCP uses a reset.
12
3
Share

What to Do If ID Card Is Lost During Driver's License Exam?

If you lose your ID card during the driver's license exam, you can apply for a temporary ID card. Below is relevant information about the driver's license exam: 1. Exam Subjects: The subjects of the driver's license exam are standardized nationwide, divided into four categories: theoretical knowledge, field driving skills, road driving skills, and knowledge related to civilized driving. 2. Notes: Before the exam, you need to register first and then undergo a physical examination. The exam must be taken in the order of Subject 1, Subject 2, Subject 3, and Subject 4. Only after passing one subject can you proceed to the next. 3. Exam Content: Subject 1 mainly tests knowledge of road traffic safety laws, regulations, and related information; Subject 2 focuses on field driving skills, including reversing into a parking space, hill start and stop, right-angle turns, curve driving, and parallel parking; Subject 3 primarily assesses road driving skills, which is the most important exam subject; Subject 4 mainly covers knowledge related to safe and civilized driving.
10
0
Share

How to turn on the air conditioning cold air in Trumpchi GS4?

Method to turn on the air conditioning cold air in Trumpchi GS4: First press the AUTO button to turn on the air conditioning, then press the AC button to activate the cold air, and adjust the temperature using the knob. The Trumpchi GS4 is positioned as an SUV, with body dimensions of 4510mm in length, 1852mm in width, and 1708mm in height, and a wheelbase of 2650mm. In terms of appearance, the Trumpchi GS4 features a bold and imposing front face design, dynamic and smooth when in motion, and grand when stationary, resembling an eagle soaring in the sky, spreading its wings high in the clouds, revealing a captivating edge in both motion and stillness. It combines international design with Chinese aesthetics, meticulously crafting every line and surface, and presenting them with ultimate beauty.
18
1
Share

What to Do When the Fuel Tank Cap Switch Won't Open in Winter?

If the fuel tank cap switch won't open in winter, it may be because the cap is stuck or rusted. Gently pry or tap it while pressing the fuel tank cap switch to open it. Nowadays, most vehicle fuel tank caps rely on a motor for locking. If the cap won't open, the motor might be faulty. Some vehicles are equipped with an emergency fuel tank cap release. The emergency release is located under a panel on the fuel tank cap side in the trunk. Pull the emergency handle with a bit of force while pressing the fuel tank cap to open it. The fuel tank cap refers to the box on a car used for storing gasoline. It is square-shaped, made of stainless steel, and has excellent sealing. There is only a small circular opening, about the size of a bottle cap, for easy storage. It is usually located at the rear of the vehicle.
1
3
Share
Trending Ranking
How to Identify Genuine Castrol Magnetec Engine Oil?
What does the N gear in an automatic transmission mean?
The Meaning of License Plate Numbers Starting with 5
4
How to Remove the Bumper?
5
What are the items for the physical examination required for driver's license renewal?
6
What to Do When the Car Gets Too Hot in Summer?
7
What are the English letters on Hankook tires?
8
Where is the windshield washer fluid reservoir located in a Buick?
9
What to Do When Foreign Objects Get Stuck in the Window Glass Gap?
10
What to do if the driver's license has been overdue for review for 6 months?
More Forum Discussions

What Causes the Engine Warning Light to Illuminate in a Passat?

2
3
1

Can I still drive on the road if one license plate is missing?

1
0
1

What Does a Yellow Light in a Car Indicate?

11
5
1

What is the normal mileage for a new car when taking delivery?

14
3
1
About Us
Terms of Use
Privacy Policy
Help
Contact Us
FAQ
Cookie
Cookie Policy
Cookie Settings
© 2025 Servanan International Pte. Ltd.