···
Log in / Register

What to Do When the Outside of the Windshield Fogs Up on Rainy Days?

3 Answers
LeHarper
09/01/25 5:53am
The solutions for fogging on the outside of the windshield on rainy days are as follows: 1. Use the air conditioning system: Turn the temperature adjustment button to the warm air direction and press the defrost button to gradually remove the fog. 2. Use anti-fog products: Spray glass cleaner evenly on the window and wipe it clean. One application can prevent fogging for about ten days to half a month. 3. Cold and hot air convection: Open a gap in the windows on both sides to allow air convection and eliminate fog. Precautions for driving in the rain are as follows: 1. Slow down: Regardless of the road width or condition, drive slowly in the rain, always pay attention to the distance between vehicles in front and behind, and be prepared to take various emergency measures. 2. Maintain distance: Visibility is impaired when driving in the rain, so pay attention to maintaining distance between vehicles, always observe the distance between vehicles in front and behind, and increase the safe distance. Especially stay away from large vehicles, as they can block the view, and puddles that large vehicles can pass through may not be passable for small vehicles. Additionally, large vehicles can easily splash water, interfering with the driving of small vehicles.
Was this review help?
7
4
Share
Kathryn
09/13/25 8:32am
Don't panic when your windshield fogs up on rainy days. I used to struggle with this issue when I first started driving. Turning on the AC is the fastest solution—set it to the windshield defrost setting and crank up the fan speed. Cold air clears fog quickly but may require repeated use in wet conditions. Switching to warm air provides longer-lasting results, though it takes more time; remember to keep the AC on for dehumidification. Crucially, avoid recirculation mode, as it traps humidity inside. Fogging occurs due to temperature differences and high humidity—I keep an anti-fog spray in my car for light rain, applying it before using the AC. Also, always activate your mirrors' heating function and utilize side/rear window defoggers when available.
Was this review help?
8
1
Share
Expand All
HadleyDella
10/28/25 2:30am
Actually, I quite enjoy studying these physical phenomena. Windshield fogging occurs when the outside temperature is low and the humidity inside the car is high, causing the glass temperature to drop below the dew point. Water vapor then condenses into tiny droplets upon contact with the cold glass. The key solution is to either reduce the humidity inside the car or raise the glass temperature. The fastest method is to simultaneously turn on the air conditioning in cooling mode and direct the airflow to the windshield, as cold air dehumidifies quickly. For long-distance driving, using the heater mode is more comfortable, but you'll have to endure a more severe fogging process for the first few dozen seconds. Be careful not to open the windows for ventilation on rainy days, as this will introduce more moisture. It's also important to regularly clean the air conditioning filter, as a clogged filter can reduce dehumidification effectiveness.
Was this review help?
6
3
Share
Expand All
More Forum Discussions

What is a Hydrogen Fuel Vehicle?

Hydrogen fuel vehicles refer to automobiles that primarily use hydrogen as their energy source for propulsion. In conventional internal combustion engines, diesel or gasoline is typically injected, whereas hydrogen vehicles utilize gaseous hydrogen instead. Fuel cells and electric motors replace the standard engine. The principle of hydrogen fuel cells involves introducing hydrogen into the fuel cell, where the electrons of hydrogen atoms are blocked by a proton exchange membrane, then conducted through an external circuit from the negative to the positive electrode, generating electricity to drive the motor. Additional Information: 1. Hydrogen Fuel Principle: Hydrogen molecules combine with oxygen molecules through combustion to produce thermal energy and water. Hydrogen fuel cells generate electricity by combining liquid hydrogen with oxygen from the air. Based on this principle, hydrogen fuel cells can generate electricity to power vehicles, supply household or industrial electricity, or serve as mobile phone batteries. 2. Hydrogen Storage Methods: There are two traditional hydrogen storage methods. One method involves using high-pressure cylinders (hydrogen tanks) to store hydrogen, but these cylinders have limited storage capacity and pose explosion risks. The other method involves storing liquid hydrogen, but the storage tanks are very large and require excellent insulation devices to maintain temperature.
7
0
Share

What is the fuel tank capacity of the BYD Han?

The fuel tank capacity of the BYD Han hybrid version is 48 liters, as officially announced. Owners who have purchased the BYD Han hybrid version can also check this information on the vehicle's configuration sheet. The BYD Han hybrid version uses 92-octane fuel, with a fuel consumption of 1.4L per 100 kilometers. A full tank can cover a distance of 3,429 km. During daily driving, it is necessary to always pay attention to the remaining fuel level in the tank. This is usually observed through the fuel gauge inside the vehicle. If there are no other issues, the fuel level will be accurately reflected on the gauge. The fuel gauge typically has 5 to 6 segments, and it is advisable to refuel when only 2 segments remain to avoid running out of fuel midway. During actual refueling, the amount of fuel may exceed the calibrated capacity. This is because the fuel tank capacity specified by the manufacturer is measured from the bottom of the tank to the safe limit, and there is still some space from the safe limit to the tank opening. This space is designed to accommodate fuel expansion due to temperature increases, preventing overflow. If fuel is filled up to the tank opening during refueling, the actual amount of fuel added may exceed the calibrated tank capacity.
16
4
Share

Where are the positions of the brake, accelerator, and clutch?

The accelerator, brake, and clutch in a car are separate. The clutch is on the left side and is controlled by the left foot, while the accelerator and brake are on the right side, with both pedals controlled by the right foot. Below is some information about brake pads: 1. Introduction: Brake pads are specially designed friction materials on a vehicle used for braking. They are also called brake linings. 2. Replacement cycle: There is no fixed replacement interval for brake pads. It is recommended to inspect them regularly. For general household vehicles, inspection is advised around 30,000 to 60,000 kilometers, and replacement should be determined based on the degree of wear. 3. Function: The heat insulation layer of brake pads is made of non-heat-conductive materials to insulate heat. During braking, they are pressed against the brake disc or drum to create friction, thereby achieving vehicle deceleration and stopping. Due to friction, the friction material gradually wears out. Lower-cost brake pads tend to wear out faster. It is essential to replace the brake pads once the friction material is depleted; otherwise, braking effectiveness will be lost, and the brake disc may be damaged.
12
2
Share

Does entering the left-turn waiting zone when the light suddenly turns red count as running a red light?

If the left-turn arrow light is red, a motor vehicle making a left turn is considered to have run a red light. Here is relevant information about the left-turn waiting zone: 1. The correct way to handle a left-turn waiting zone: The left-turn waiting zone is only for vehicles making a left turn. When the straight-through light in the same direction is green, although the left-turn light is red, left-turning vehicles are allowed to enter the intersection and wait in the left-turn waiting zone. They can proceed through the intersection when the left-turn signal turns green. 2. Whether points will be deducted: No points will be deducted; it is a legal operation. Based on the description, if a vehicle enters the left-turn waiting zone when the light suddenly changes from green to red (even without a yellow light transition), as long as the vehicle passed the stop line when the light was green, it can continue to proceed according to the relevant regulations in the "Implementation Regulations of the Road Traffic Safety Law." This does not count as running a red light.
19
4
Share

Why does BMW QQ Music download fail and prompt to retry?

The reason is poor signal. Here is an introduction about BMW: 1. Overview: BMW (abbreviation for Bayerische Motoren Werke) is a German automobile brand under the BMW Group. It has four model series: i, X, Z, and pure numbers, along with series like 1, 2, 3, and the M series (BMW's official high-performance modification division) based on improvements to each series. The B.M.W. in the BMW logo stands for Bavarian Motor Works, and the colors and combination of the logo come from the state emblem of Bavaria, where BMW is located. 2. Model Series: BMW's model series include 1, 3, 4, 5, 6, 7, 8 (discontinued), i, M, X, and Z. Among them, the 1 Series is a compact car, the 3 Series is a midsize car, the 4 Series is a midsize coupe (including convertibles), the 5 Series is a mid-to-large-size car, the 6 Series is a mid-to-large-size coupe (including convertibles), the 7 Series is a luxury D-segment car, the i Series is BMW's non-mass-produced concept car series, M is BMW's high-performance and sports car version, the X Series is BMW's specific SUV (Sports Utility Vehicle) series, and the Z Series is BMW's entry-level sports car.
20
2
Share

Are the interiors of the Audi A6L and Audi A8L the same?

The interiors of the Audi A6L and Audi A8L are not the same. The A6L is a mid-size luxury sedan, while the A8L is the top-tier luxury sedan in the Audi lineup and serves as the flagship model of the brand. Size differences: Due to their different positioning, the two models have significant distinctions. In terms of body dimensions, the A8L measures 5302mm in length, 1945mm in width, and 1487mm in height, with a wheelbase of 3128mm. In comparison, the A6L measures 5036mm in length, 1874mm in width, and 1466mm in height, with a wheelbase of 3012mm. From the dimensions, the A8L is larger than the A6L. Powertrain differences: In terms of powertrain, the current domestic A6L offers four gasoline engine options: a 1.8T turbocharged engine, a 2.0T turbocharged engine, a 2.5L naturally aspirated engine, and a 3.0T supercharged engine. On the other hand, the A8L is equipped exclusively with a 3.0T turbocharged engine. The A6L provides more engine choices compared to the A8L. Additionally, there are noticeable differences in their taillights and tire widths.
7
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.