What to Do When the Exhaust System Warning Light Comes On in the Sagitar?

1 Answers
IanAnn
07/29/25 8:00pm
Solutions for the Sagitar's exhaust system warning light coming on: 1. Start and turn off the vehicle three times in a row; 2. Pay attention to using high-quality fuel and maintaining engine cleanliness; 3. If the vehicle cannot start after turning off or exhibits severe shaking, lack of acceleration power, or other symptoms, it is recommended to stop driving and seek professional help to diagnose and repair the fault. Reasons for the exhaust system warning light coming on: 1. Poor quality gasoline, leading to abnormal air-fuel mixture, electronic component failures, and exhaust system abnormalities; 2. Faulty electronic components in the intake and exhaust systems, such as oxygen sensors, air flow meter sensors, throttle valves, or carbon buildup inside the engine. The Sagitar brand was jointly established by Volkswagen AG of Germany and FAW in 2006. The first-generation Sagitar was a new A-class sedan introduced by FAW-Volkswagen, strategically synchronized with Volkswagen's product launch for the North American market.
Was this review help?
16
1
Share
More Forum Discussions

How to Open the Front Hood of the Envision?

To open the front hood of the Envision: First, pull the handle located below the driver's compartment. Then, go to the front center of the hood, lift the hood with one hand while reaching into the center gap with the other hand. Inside, there is a lever—pull it firmly to the right to release the front hood. To close the engine hood, simply press it down manually. Taking the 2021 Envision as an example, its body dimensions are 4694mm in length, 1839mm in width, and 1686mm in height, with a wheelbase of 2750mm and a fuel tank capacity of 66 liters. This model is equipped with a 1.5T turbocharged engine, delivering a maximum power of 124kW and a maximum torque of 250Nm, paired with a 7-speed dual-clutch transmission.
17
0
Share

How to Adjust the Valve Shim on a Sonata?

The adjustment method for the Sonata valve shim: 1. Remove the valve cover, tighten the rocker arm shaft bracket, and place the decompression handle in the preheat I position; 2. Rotate the crankshaft until the intake valve of the first cylinder changes from open to closed, and use the top dead center positioning pin to determine the compression top dead center of the first cylinder; 3. Return the decompression handle to the working position, and check and adjust the valve clearance of the remaining valves from front to back; 4. Place the decompression handle back in the preheat I position, pull out the top dead center positioning pin from the flywheel positioning hole, slowly rotate the crankshaft, and when it falls back into the flywheel positioning hole, return the decompression handle to the working position, and then check and adjust the valve clearance of the remaining 4 valves; 5. Review once according to the aforementioned sequence, and re-adjust if incorrect. After adjustment, securely tighten the top dead center positioning pin on the flywheel housing and reinstall the valve cover. Taking the 2020 automatic Zhixiang edition Sonata as an example, its body dimensions are 4955mm in length, 1860mm in width, and 1445mm in height, with a wheelbase of 2890mm, a fuel tank capacity of 60 liters, and a body weight of 1542kg.
14
2
Share

Where is the trunk switch on the 2019 Bora?

The 2019 Bora does not have a trunk switch. There are two ways to open the trunk: 1. The driver stands outside the car and presses the button on the key to open the trunk; 2. If the doors are unlocked, the driver can stand near the trunk and lift it open by hand. The dimensions of the 2019 Bora are 4663 mm in length, 1815 mm in width, and 1462 mm in height, with a wheelbase of 2688 mm. The 2019 Bora features front-wheel drive, a front MacPherson strut independent suspension, a rear torsion beam non-independent suspension, and a unibody structure.
20
3
Share

How Many Years Are There for the Driving Test?

The validity period for the driving test is three years. Applicants must complete the Subject 2 and Subject 3 tests within this period. If they fail to complete the tests within the validity period, the passed subject scores will be invalidated. If they need to retake the test, applicants must re-register for the Subject 1 test. The order of the driving test subjects is as follows: traffic regulations and related knowledge, field driving, road driving, and safety and civilization knowledge. During the test, if a candidate fails a subject, the subsequent subjects will not proceed. For Subject 2 and Subject 3, there is one initial test and one retake opportunity, with a total of five retake chances. If the candidate still fails after five retakes, the current test session will be terminated.
15
3
Share

What are the common interior decorations in a car?

Common interior decorations in a car include floor mats, headrests, seat covers, etc. Some car owners like to place model dolls inside the car, but it is recommended not to place anything on the dashboard of the front passenger seat, including dashboard sunshade pads, tissue boxes, small figurines, etc. A dashboard sunshade pad can obstruct the deployment of the front passenger airbag in the event of an accident, while tissue boxes and small figurines with edges or hard surfaces can carry significant energy when the airbag deploys, enough to shatter the windshield. It is important to check if the vehicle's seats have airbag markings. If they do, choose seat covers that do not obstruct the airbag deployment. Additionally, some higher-end models may have seats with ventilation functions. Choosing inappropriate seat covers could render the ventilation feature ineffective.
17
3
Share

What is the ground clearance of the Jetta?

The ground clearance of the Jetta is 12 centimeters. Ground clearance refers to the distance between the ground and the rigid object at the bottom of the vehicle. The Jetta is equipped with two engines: a 1.4L naturally aspirated engine and a 1.5L naturally aspirated engine. The 1.4L naturally aspirated engine has a maximum horsepower of 90 HP and a maximum torque of 132 Nm, while the 1.5L naturally aspirated engine has a maximum horsepower of 110 HP and a maximum torque of 150 Nm. The body dimensions of the Jetta are 4501 mm in length, 1704 mm in width, and 1469 mm in height, with a wheelbase of 2604 mm. The Jetta features front-wheel drive, with a front suspension type of MacPherson independent suspension and a rear suspension type of compound torsion beam non-independent suspension. The body structure is of a unibody design.
15
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.