What to Do When the Entire Car Loses Power During Startup?

1 Answers
KimberlyRose
07/25/25 9:17pm
When the engine is running normally, but the dashboard lights gradually dim until the engine stops running and the lights go from dim to completely off, this indicates a total loss of power in the vehicle. The specific solution depends on the situation, as analyzed below: 1. If the entire car loses power during normal engine startup: It may be due to a malfunction in the car's alternator, which requires timely inspection and repair. It could also be an electrical issue, such as a ground fault in the vehicle's wiring harness or excessive current caused by improperly modified wiring, leading to burnt wires. The problematic circuit should be promptly addressed. 2. If the entire car loses power when the engine is not running: It may be due to a faulty battery. In this case, contact a rescue vehicle to connect jumper cables for temporary charging to start the engine. Alternatively, if jumper cables are unavailable, use a tow-start method to start the car.
Was this review help?
4
0
Share
More Forum Discussions

Where is the cigarette lighter fuse of Audi Q5 located?

Audi Q5 cigarette lighter fuse is located inside the fuse box on the left side of the engine compartment. Here is some relevant information about the cigarette lighter: 1. Cigarette lighter fuse current: It is generally DC 12V. The power supply for small cars is usually DC 12V (may vary depending on the vehicle model), while large trucks use DC 24V. The center elastic head is the positive pole, and the two side clips (ears) are the negative poles. It is directly connected to the car battery, with the same current and power as the battery. 2. Precautions: Do not attempt to repair the fuse. Never replace a blown fuse with one that has a higher current rating. This may cause damage to the electronic system and pose a fire hazard! If the newly replaced fuse blows again shortly after replacement, the electronic device must be checked by a professional as soon as possible.
3
0
Share

Can vehicles with Hu C license plates currently drive on the Outer Ring Road?

Vehicles with Hu C license plates are not allowed on the Outer Ring Road, and their travel is restricted within the Outer Ring Road area. Motor vehicles displaying "Hu C" license plates are prohibited from driving on the Middle Ring Road (from Yanggao South Road Overpass to Huaxia Elevated Road), Huaxia Elevated Road, and the following designated roads: along the Outer Ring Tunnel (including the ground roads on both sides, Taihe Road) - S20 Outer Ring Expressway (west of the Outer Ring Tunnel to Yanggao South Road Overpass, including the ground roads on both sides, Taihe Road, Taihe West Road to Gutai Road), etc. The specific traffic restrictions are as follows: 1. Motor vehicles displaying "Hu C" license plates are prohibited from driving on the Middle Ring Road (from Yanggao South Road Overpass to Huaxia Elevated Road), Huaxia Elevated Road, and the following designated roads: along the Outer Ring Tunnel (including the ground roads on both sides, Taihe Road) - S20 Outer Ring Expressway (west of the Outer Ring Tunnel to Yanggao South Road Overpass, including the ground roads on both sides, Taihe Road, Taihe West Road to Gutai Road) - Yanggao South Road - Longyang Road Overpass - Longyang Road - Longdong Avenue - Jinqiao Road - Jinqiao Overpass - Yanggao Middle Road - Yanggao North Road - Yanggao North First Road, and the area enclosed by the Yangtze River shoreline and Huangpu River shoreline (including the aforementioned roads). Small passenger taxis displaying "Hu C" license plates are allowed to travel on the S20 Outer Ring Expressway within the aforementioned area. 2. On the eastbound mainline of Luoshan Elevated Road (from Longdong Avenue to S20 Outer Ring Expressway), north of the Gaoke West (Middle) Road exit ramp, small passenger vehicles with "Hu C" license plates are prohibited from driving at all times. 3. In the Pudong area, the Hu C restricted zone also includes the Middle Ring Road (Pudong section) and the Resort Elevated Road (from Middle Ring Road to S2 Hulu Expressway).
3
0
Share

What does ESC refer to?

ESC in cars refers to the Electronic Stability Control system, and its switch is located on the vehicle's center console. 1. Its functions include: Monitoring the vehicle's driving state, and preventing the vehicle from deviating from the ideal trajectory when emergency obstacle avoidance or insufficient/over steering occurs during turns. 2. The working principle of the vehicle stability system is: Judging the driving state based on sensor signals, and through calculations by the well-controlled control unit, individually controlling each wheel when rotation, understeer, or oversteer occurs to improve vehicle stability. 3. The buttons inside the car and their functions are divided into: (1) Fuel tank opening button: Remotely opens the fuel tank cap from inside the car; (2) Reverse radar button: Turns the vehicle's reverse radar system on or off; (3) Central lock button: Controls the central door locking system of the vehicle.
11
2
Share

How Does Oil Film Form on Car Windows?

The causes of oil film formation on car windows are as follows: 1. Vehicle exhaust: Primarily from vehicle exhaust, which contains various pollutants due to incomplete combustion. Frequent traffic congestion in urban areas, especially when driving behind trucks, inevitably leads to these pollutants adhering to the car windows, forming an oil film. 2. Cooking fumes: Next is pollution from cooking fumes. If the car is often parked near restaurant chimneys, over time, a significant amount of grease and dirt accumulates. If not cleaned promptly, it can form a thick layer of oil residue. 3. Insect remains, bird droppings, and tree resin: Insect remains and bird droppings are highly corrosive. If left uncleaned on the glass, they harden and adhere, affecting the glass's transparency and even turning into an oil film. Additionally, tree resin is another factor. Cars frequently parked under trees may be coated with tree sap or fruit residues, leading to oil film formation.
11
0
Share

Do You Need to Fully Depress the Brake When Shifting an Automatic Transmission?

When driving an automatic transmission vehicle, you don't need to press the brake to shift gears, as all shifting actions are autonomously completed by the transmission without manual intervention. Generally, when driving an automatic transmission car, if you accelerate to a certain speed, such as 2500 RPM, and then slightly release the throttle, the transmission will upshift on its own. If you keep pressing the throttle without releasing, some automatic transmission vehicles will delay the shift until higher RPMs. Below are situations where you need to press the brake: 1. Starting in P (Park) gear: When starting the car in P gear, you must press the brake. Since the car is just starting, not pressing the brake can easily cause the vehicle to roll. 2. Driving in N (Neutral) gear: When driving in neutral, you should press the brake. In fact, experienced drivers do not recommend driving in neutral. But if you must shift to neutral, remember to press the brake to avoid emergencies that cannot be resolved. 3. Shifting from N (Neutral) gear: When shifting from N gear to D (Drive) or R (Reverse) gear, you also need to press the brake. Not pressing the brake can cause the car to lurch forward or stop abruptly, which can cause significant damage to the transmission system.
4
4
Share

Which Mazda vehicles use rotary engines

Mazda RX series vehicles use rotary engines. The rotary engine utilizes a triangular rotor's rotational motion to control compression and exhaust. Below are the specifications for the Mazda RX: 1. Body dimensions: The 2008 Mazda RX8 manual model has a body length of 4460 mm, width of 1770 mm, height of 1340 mm, a wheelbase of 2700 mm, a fuel tank capacity of 65 liters, and a curb weight of 1406 kg. 2. Vehicle configuration: The 2008 Mazda RX8 manual model is equipped with a 1.3L naturally aspirated engine, with a maximum power output of 170 kW at 8200 rpm and a maximum torque of 211 Nm at 5500 rpm.
17
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.