What to Do When the Cruze Temperature Gauge Shows Normal but the Radiator Boils Over?

How to Determine if a Car Has a Three-Cylinder or Four-Cylinder Engine?

To determine whether a car has a three-cylinder or four-cylinder engine, open the engine hood and check the number of intake and exhaust manifolds. A three-cylinder engine has three intake and exhaust manifolds, while a four-cylinder engine has four. Three-cylinder engines are simpler in structure, more compact, lighter in weight, and easier to arrange. Four-cylinder engines are relatively more complex, with an additional cylinder, heavier weight, and more complicated layout. Engines use dynamic balancing technology to reduce vibrations. Due to inherent design, engines with four or more cylinders can balance vibrations mutually. The ignition phase angle of a three-cylinder engine is larger than that of a four-cylinder engine. Three-cylinder engines incorporate various vibration reduction mechanisms, such as pendulum-type dual-mass flywheels and crankshaft rubber damping technology.

4

2

Share

How to Install Car Snow Chains?

Installation method for car snow chains: 1. Park the car on a flat surface, use a jack to lift one of the drive wheels, and lay the snow chain flat under the lifted wheel; 2. Pull up one end of the snow chain from the fender side, then pull up the other end, and connect the inner steel cable of the snow chain; 3. Evenly spread the main body of the snow chain on the tire surface, then hook the upper and lower hooks, insert the three pins of the tensioner into the grooves of the limit lock buckle, and turn clockwise to lock the snow chain in place, completing the installation. After installing the snow chains, test drive the vehicle for about 200 meters to ensure the snow chains are fully engaged with the tires. Additionally, the maximum speed should not exceed 40 kilometers per hour, and avoid sudden acceleration or deceleration during driving.

18

1

Share

When is the best time to refuel a car?

It is best to refuel your car when the fuel warning light comes on. An excessively low fuel level can cause damage to the fuel pump. However, the remaining fuel should not be too high, as frequent refueling increases trips to the gas station, leading to waste. You can choose to refuel in the morning or evening, avoiding times when the sun is intense and temperatures are high at noon. This is because gasoline is charged by volume rather than weight, and volume is affected by temperature, expanding when hot and contracting when cold. When refueling at a gas station, the engine should be turned off, and you should avoid making phone calls, using mobile phones, or using open flames inside the station. For regular refueling, always choose gas stations with high-quality fuel. Avoid those with poor-quality fuel, as long-term use of low-quality gasoline can lead to increased carbon deposits in the engine.

12

4

Share

Where to Add Engine Oil in a Car?

Engine oil is added through the oil filler cap located on top of the engine. The steps are as follows: Open the engine hood, unscrew the oil cap on the left side of the engine counterclockwise, and then pour in the prepared engine oil. Precautions for adding engine oil: 1. When selecting engine oil, use the grade specified in the car's user manual; 2. Try to choose multi-grade oil, which saves fuel, has a long service life, is efficient, and provides better protection for the engine; 3. The amount of oil added should be slightly lower than the standard mark. Excessive oil will increase the rotational resistance of the crankshaft, reduce the engine's output power, cause the vehicle to burn oil and emit blue smoke, and even increase fuel consumption.

10

4

Share

Where to Add Windshield Washer Fluid for Cars?

Location for adding windshield washer fluid: Pull the engine compartment lever inside the driver's cabin to open the engine hood, locate the windshield washer fluid filler port, open the cap, and add the fluid. There are mainly three types of windshield washer fluids available in the market: summer-use windshield washer fluid, winter antifreeze windshield washer fluid, and special antifreeze windshield washer fluid. The summer-use fluid is primarily used to remove insect residues from the windshield. It's important to choose the appropriate windshield washer fluid based on different climate and temperature conditions. Windshield washer fluid can also be used to clean other glass surfaces. Spray it on the area to be cleaned, let it soak for 2 to 3 minutes, then wipe with a soft cloth or directly use a soft cloth soaked with the cleaning solution to wipe the area until it becomes clear. For heavy stains, repeat the cleaning process and rinse with clean water before drying.

12

5

Share

What are the precautions for high-speed driving?

Precautions for high-speed driving: 1. Slow down and prepare to brake when encountering blind spots; 2. Anticipate risks and slow down when road conditions change; 3. Observe more when your own situation changes; 4. Brake immediately when the vehicle ahead changes. Disadvantages of high-speed driving: 1. Inability to fully and accurately perceive changes inside and outside the vehicle; 2. Reduced spatial awareness; 3. Impaired judgment; 4. Increased likelihood of fatigue; 5. Difficulty in shifting attention; 6. Increased risk of driver misjudgment; 7. Impact on timely and accurate operations; 8. Compromised vehicle safety performance.

3

1

Share

What to Do When the Cruze Temperature Gauge Shows Normal but the Radiator Boils Over?

How to Determine if a Car Has a Three-Cylinder or Four-Cylinder Engine?

How to Install Car Snow Chains?

When is the best time to refuel a car?

Where to Add Engine Oil in a Car?

Where to Add Windshield Washer Fluid for Cars?

What are the precautions for high-speed driving?

How to Prevent Static Electricity in Cars?

What are the steps for performing an automotive fuel system cleaning (commonly known as 'IV drip cleaning')?

How to Remove Formaldehyde in a Car?

How to Maintain Car Batteries?