What to Do When the Car Wiper Stops Working?
3 Answers
Solutions for when the car wiper stops working are as follows: 1. Open the hood and observe if the transmission linkage is dislocated. 2. Check if the fuse is intact. 3. Disconnect the motor wire plug, turn on the power, and use a multimeter to measure if there is voltage. If the fuse is intact but the motor has no voltage, check if the wiring and the combination switch for the turn signals are intact. Below is an introduction to the method for replacing car wipers: 1. Lift the metal wiper arm from the windshield and keep it steady in a position perpendicular to the windshield. 2. Press the tab and remove the old wiper blade, separating it from the metal arm. 3. Insert the new wiper, gently rotate the new blade until the hook snaps into place to secure it, then place the wiper back onto the windshield.
I've been driving for over twenty years, and non-functioning wipers are nothing new. The most common issue is a blown fuse. Just find the corresponding wiper label in the fuse box under the driver's seat and replace it with a new fuse—that usually does the trick. If it's not the fuse, the wiper motor might be aging. Press the switch and listen for a humming sound under the hood. If you hear it, the motor is running but the wiper is stuck. In that case, open the engine compartment to check if the wiper arm is loose or rusty, and spray some lubricant. Also, check if the washer fluid reservoir is clogged and clean the nozzles to prevent dry wiping. Personally, I test the wiper spray function every month to minimize malfunctions. If you can't fix it yourself, never force it in the rain—find a safe spot to pull over and call a repair shop. Safety first. During regular maintenance, have the mechanic inspect the entire system—it saves money and gives peace of mind.
As a DIY enthusiast, when the wipers stop working, I start with the basics: first check the fuse box, locate it near the passenger side or center console (refer to the manual for diagrams), and replace the fuse to see if that fixes the issue. If not, inspect the wiper motor by turning on the switch and listening for motor sounds. Sometimes, the linkage is loose, and tightening the screws can restore functionality. I recommend cleaning debris from the water trough when replacing wiper blades to prevent clogs. Regularly wiping the wiper rubber strips helps prevent aging and extends their lifespan. Driving in the rain without wipers is terrifying, so I always test the washer function during car washes. Keep tools handy and be cautious with electrical systems; if unsure, quickly consult a professional. Preventive maintenance saves time and effort—don’t wait until it rains to regret neglecting it.
