What to Do When the Car Window Glass is Covered with Rainwater and Obstructs Vision?

1 Answers
StMakayla
07/29/25 5:47pm
When the car window glass is covered with rainwater and obstructs vision, the problem should be resolved immediately. Here are some solutions to address this issue: 1. Soap for Water Removal: Soap, as a common household item, is a very useful cleaning tool. The principle of using soap to remove rainwater from car windows is easy to understand. Since soap molecules can disrupt the surface tension of the glass, water molecules cannot form droplets on the glass. Instead, they spread evenly across the glass surface, which does not affect the transparency of the window glass, as water itself is transparent. 2. Purchase Waterproof Stickers: Waterproof stickers for car windows are available in most stores. Using these items can effectively prevent this problem.
Was this review help?
20
1
Share
More Forum Discussions

Can out-of-province vehicles undergo annual inspection within the province?

Out-of-province vehicles can undergo annual inspection. 1. You must obtain a Notice of Entrusted Inspection from the original registration vehicle management office, authorizing the local vehicle management office to conduct the annual inspection of the vehicle. 2. After obtaining the entrustment letter, bring the vehicle license and insurance policy to proceed with the normal inspection process. Additional information on annual inspection for out-of-province vehicles: 1. The following circumstances will result in refusal to issue an entrusted motor vehicle inspection compliance mark: the vehicle involves unresolved road traffic violations or accidents; the vehicle applying for the entrusted inspection compliance mark is a large passenger vehicle. 2. Starting from September 1, 2018, cross-province annual inspections for small cars, trucks, and medium-sized buses have been fully implemented. Applicants can directly conduct inspections and apply for inspection compliance marks in provinces other than the vehicle's registration location without needing to go through the entrustment inspection procedure.
2
5
Share

What is the bulb model for the Prado's headlights?

The bulb model for the Prado's headlights is H4. The Prado is a new model in Toyota's Land Cruiser series. Taking the Prado 2019 3.5L Automatic TXL Premium Edition as an example: it is equipped with a 3.5L 280-horsepower V6 naturally aspirated engine and a 6-speed automatic transmission, with a maximum power of 206 kW, a maximum torque of 365 Nm, a maximum power speed of 6000 rpm, and a maximum torque speed of 4500 rpm. The exterior dimensions of the Prado are 4840 mm in length, 1885 mm in width, and 1890 mm in height, with a wheelbase of 2790 mm, a minimum ground clearance of 215 mm, and a curb weight of 2285 kg.
6
5
Share

What is the battery model of the Elantra?

The battery model of the Elantra is 55D23L, with a voltage of 12 volts and a capacity of 60 ampere-hours. The Elantra is a compact sedan under Beijing Hyundai. Taking the 2021 Elantra 240TGDi LUX Premium Edition as an example: it is equipped with a 1.4T 140 horsepower L4 turbocharged engine, with a maximum power of 103 kilowatts and a maximum torque of 211 Newton-meters. The exterior dimensions of the Elantra are 4680mm in length, 1810mm in width, 1415mm in height, and a wheelbase of 2720mm. The fuel tank capacity is 47 liters, the trunk capacity is 474 liters, and the curb weight is 1270 kilograms.
7
3
Share

Dimensions of the Dump Truck Body for a 4x8 Axle Configuration?

The body dimensions are 1120mm, 1180mm, and 1015mm. The term '4x8 axle configuration' refers to a setup with four wheels at the front and eight wheels at the rear. Specifically, '4 at the front' means a dual-axle system with four wheels, while '8 at the rear' also indicates a dual-axle system, totaling eight driven wheels—four wheels per axle, with two wheels on each side of every axle. Below is relevant information about the truck's engine system: The engine drives the hydraulic pump via the transmission and power take-off (PTO) device. High-pressure oil flows through the control valve and pipelines into the lifting hydraulic cylinder, where the piston rod is pushed to tilt the truck body. Rearward tilting is the most common method. The movement of the piston rod can be controlled by the operating system to stop the body at any desired tilt angle. The body returns to its original position using its own weight and hydraulic control.
14
0
Share

How to Replace the Focus Air Conditioning Filter?

To replace the Focus air conditioning filter, follow these steps: 1. Remove the fuse box cover under the passenger seat; 2. Take off the vertical inner cover of the fuse box; 3. Pull out the old air conditioning filter; 4. Install the new air conditioning filter in reverse order. The Focus is a brand under Ford Motor Company of the United States, available in both sedan and hatchback models. Taking the Focus 2021 Sedan 1.5L Manual Fengyue as an example: it is equipped with a 1.5L 122 horsepower L3 naturally aspirated engine, paired with a 6-speed manual transmission, and has exterior dimensions of 4647mm in length, 1810mm in width, and 1468mm in height.
1
0
Share

What does Volkswagen CleanAir mean?

The CleanAir in cars refers to the air purification function, which is only available in mid-to-high-end vehicles. Moreover, the "CleanAir" button is merely an indicator and cannot be manually pressed. When the driver turns on the internal or external circulation, the CleanAir function will automatically activate. The air purification function can filter harmful gases, ensuring a clean air environment inside the car. The CleanAir air purification function includes: 1. Air conditioning filter with activated carbon: It has an additional activated carbon layer that can adsorb more harmful substances on the filter. Of course, the price of this air conditioning filter is several times higher than that of a regular one. 2. Negative ion air purification: It generates plasma through a high-voltage circuit, which disrupts the protein membrane on the surface of bacteria with positive and negative ions, causing them to lose vitality and die, thereby achieving the goal of eliminating bacteria in the air.
8
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.