What to Do When the Car Brake Light Warning Appears?

2 Answers
VonKaden
07/25/25 4:22pm
When the car brake light warning appears, it should be inspected immediately. The brake light warning may indicate that the brake pads are worn thin or the brake fluid is insufficient. Continuing to drive under such conditions poses safety risks. The car's braking system is crucial for vehicle deceleration, and the braking system is designed to ensure safe driving from a technical standpoint. New cars undergo a break-in period for the braking system during initial use, with 1,000 kilometers being the break-in period for the new car's braking system. It is recommended to avoid emergency braking situations as much as possible during this period. Car brake pads and discs have a service life and must be replaced when worn to a certain extent. The specific replacement time depends on the vehicle's usage, but it is generally recommended to inspect them every 50,000 kilometers.
Was this review help?
4
2
Share
DiGage
08/11/25 9:48pm
When I see the brake light failure warning while driving, I get a bit nervous because it's directly related to driving safety. Last time I encountered this situation, the warning light on the dashboard came on, and I immediately found a safe place to pull over and check. If the brake lights aren't working, the car behind can't clearly see when you're braking, which can easily lead to a rear-end collision. I usually try to replace the brake light bulb myself first – locate the light assembly position in the trunk, give it a gentle twist to remove it, and check if the bulb is burnt out. If it is, just buy a new one from an auto shop and replace it. If that doesn't work, it might be a fuse issue – find the corresponding brake light fuse in the engine compartment fuse box and check if it's blown, replacing it if necessary. If none of these solutions work, I think it's best not to delay and drive directly to a professional repair shop or 4S dealership to check for wiring or switch problems. After all, when you're on the road, safety comes first, especially at night when it's even more dangerous. I recommend that anyone who encounters a similar warning should address it promptly and not wait for an accident to happen.
Was this review help?
1
1
Share
Expand All
More Forum Discussions

What are the consequences of exceeding the vehicle annual inspection deadline?

Exceeding the annual inspection deadline means the vehicle cannot be driven on the road. There is no grace period for annual inspections—even one day over the limit prohibits road use. Below is the vehicle annual inspection process: Schedule an appointment in advance: Inspection stations are usually less crowded at the beginning of the month and busier toward the end. Therefore, it's best to schedule the inspection for early in the month to avoid long wait times. Handle traffic violations and check insurance: Before the inspection, check if your vehicle has any outstanding traffic violations. If so, you must resolve them at the traffic enforcement office before proceeding with the inspection. Also, ensure your insurance is valid. Clean the vehicle exterior and perform maintenance: If the car has obvious issues, take it to a repair shop first. Inspection station procedures: First, verify compulsory insurance and the vehicle registration certificate. Next, inspect the exterior (any stickers or decals must be removed). Then, check the vehicle identification number (VIN) to confirm authenticity and prevent fraud. Finally, test emissions, brakes, and lights.
18
1
Share

How to Inquire About the Vehicle Owner's Phone Number?

If blocked by someone else, you can notify the vehicle owner through the following methods: Call the 114 hotline to request the vehicle owner to move their car: You need to provide your own license plate number and phone number to 114, along with the other party's license plate number. 114 will then notify the vehicle owner via SMS or phone call to move their car. Use the One-Click Move Car feature: The One-Click Move Car feature is a convenient service launched by the 12123 traffic management department. When you need to request a car to be moved, using this feature will automatically compare the vehicle information in the database through the 12123 system. It will then search and retrieve the vehicle owner's phone number in the background, and the system will send a move car notification to the vehicle owner via SMS or APP message push. Call 122 or 110 to seek assistance from the traffic-specific hotline: They will help contact the vehicle owner and inform them of the current situation. The traffic-specific hotline will then reach out to the vehicle owner.
9
2
Share

When will Beijing's China 5 vehicles no longer be eligible for registration?

After July 1, 2019, Beijing has implemented the China 6 standard, and new China 5 vehicles in Beijing can no longer be registered. The following is an introduction to the implementation of China 6: Official implementation of the China 6 policy: The China 6 motor vehicle pollutant emission standard refers to the standard formulated to implement the Air Pollution Prevention and Control Law of the People's Republic of China, prevent and control the environmental pollution caused by the exhaust of compression ignition and gas fuel ignition engine vehicles, protect the ecological environment, and safeguard human health. Differences between China 5 and China 6: The emission standards are different, with China 6 being more than 30% stricter than China 5. Excluding the influence of working conditions and testing, gasoline vehicles' carbon monoxide emissions are reduced by 50%, total hydrocarbon and non-methane hydrocarbon emissions are reduced by 50%, and nitrogen oxide emissions are reduced by 42%. The principles are different: during the China 5 stage, diesel vehicles and gasoline vehicles had different emission standards, but China 6 adopts a fuel-neutral principle, meaning the emission limits are the same regardless of the fuel type used.
9
0
Share

Do Automatic Cars Have a Clutch?

Automatic cars do have a clutch. More details about automatic transmissions are as follows: 1. There is no clutch pedal, but the clutch and accelerator pedals are combined. The clutch in an automatic transmission is replaced by something called a torque converter, which can lock one end while the engine outputs torque, converting kinetic energy into internal energy. 2. Even though automatic transmissions don't have a clutch pedal, they still have a clutch, which is located inside the automatic transmission. As the car's RPM, throttle, brake, and speed change, the onboard computer controls the separation or engagement of the clutch plates to achieve the effect of automatic shifting. 3. As the name suggests, an automatic transmission does not require the driver to shift gears manually. The vehicle automatically selects the appropriate gear based on driving speed and traffic conditions. The clutch is located in the flywheel housing between the engine and the transmission, with the clutch assembly fixed to the rear plane of the flywheel by screws. The output shaft of the clutch is the input shaft of the transmission. During gear shifts, it connects and disconnects the power between the engine and the transmission to ensure smooth shifting.
3
1
Share

What Are the Blind Spots When Driving a Car?

The blind spot of a car is located in the area from 45 to 60 degrees outward starting from the car door. More details are as follows: Left and Right A-Pillar Blind Spots: Some cars have particularly wide A-pillars, which severely obstruct the view. However, some cars have a small triangular window added to the A-pillar, effectively increasing visibility. The A-pillar blind spot is the most dangerous and the one that troubles drivers the most. This blind spot is particularly hazardous when starting off or making turns. Rearview Mirror Blind Spot: This blind spot has a wide range of hazards, affecting lane changes, turns, and reversing. The blind spot is roughly in the area from 45 to 60 degrees outward starting from the front door. Upon closer observation, when the front of the adjacent lane's car is near the rear wheel of your car, it cannot be seen in the rearview mirror. Therefore, when changing lanes, check the rearview mirror multiple times or glance out the window after checking the mirror to effectively address the rearview mirror blind spot while driving. Blind Spot Directly Behind the Vehicle: Due to the height of the vehicle and issues with the rear windshield and trunk, low areas directly behind the vehicle are not visible. However, this blind spot poses relatively minor hazards. Accidents are more likely to occur when reversing, so it's advisable to reverse slowly.
5
5
Share

How to Read the Gauge on an Air Conditioning Refrigerant Pressure Meter?

Depending on the ambient temperature, the low pressure during normal operation of the refrigeration system generally ranges between 3 to 6 bar, while the high pressure ranges between 10 to 25 bar. Below is an introduction to the air conditioning refrigerant pressure meter: Why Add Freon to Air Conditioners: Freon serves as the medium for heat transfer in the air conditioning refrigeration system. Without it, heat cannot be effectively exchanged, and the air conditioner cannot cool or heat. Therefore, if the air conditioner lacks Freon, symptoms may include poor cooling (or heating), failure to cool (or heat), protective shutdown, water leakage from the indoor unit (sometimes spraying water), and ice formation on the indoor evaporator. There are also less visible issues—reduced lifespan of the air conditioner, wasted electricity, and damage to the air conditioner's compressor. Hence, sufficient Freon is essential for normal air conditioner operation. How Much Freon Should Be Added to an Air Conditioner: During hot summer weather (when the ambient temperature is above 32°C), the pressure gauge needle should stabilize at 0.45 MPa. In spring and autumn, it should be around 0.3 MPa. In winter, adding Freon does not strictly follow the pressure gauge reading (the reference pressure is 1.8 MPa). Instead, it relies on the technician's experience or observing the swing amplitude of the pressure gauge needle.
12
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.